High-Rate Anaerobic Digestion of Waste Activated Sludge by Integration of Electro-Fenton Process.

Anaerobic digestion (AD), being the most effective treatment method of waste activated sludge (WAS), allows for safe disposal. The present study deals with the electro-Fenton (EF) pretreatment for enhancing the WAS biogas potential with low-cost iron electrodes. The effect of pretreatment on the physicochemical characteristics of sludge was assessed. Following EF pretreatment, the pH, conductivity, soluble chemical oxygen demand (SCOD), and volatile fatty acids (VFA) increased to 7.5, 13.72 mS/cm, 4.1 g/L, and 925 mg/L, respectively. Capillary suction time (CST) analysis highlighted the dewaterability effect of EF on WAS, as demonstrated by the decrease in CST from 429 to 180 s following 30 min of pretreatment. Batch digestion assays presented an increase in the biogas yield to 0.135 L/g volatile solids (VS) after 60 min of EF pretreatment in comparison to raw sludge (0.08 L/g VS). Production of biogas was also found to improve during semi-continuous fermentation of EF-pretreated sludge conducted in a lab-scale reactor. In comparison to raw sludge, EF-pretreated sludge produced the highest biogas yield (0.81 L biogas/g VS) with a high COD removal rate, reaching 96.6% at an organic loading rate (OLR) of 2.5 g VS/L. d. Results revealed that the EF process could be an effective WAS disintegration method with maximum recovery of bioenergy during AD.

Comprehensive characterization of the liquid fraction of digestates from full-scale anaerobic co-digestion.

Waste management by anaerobic digestion generates a final byproduct, the digestate, which is usually separated into solid and liquid fractions to reduce the volume for transportation. The composition of the solid fraction has been recently studied to allow its valorization. However, full composition of liquid fraction of digestate and its size fractionation are less considered in the literature for efficient post treatment and valorization purposes. Therefore, here we characterized in detail liquid fraction of digestate obtained after solid-liquid separation from 11 full-scale co-digestion plants. The liquid fraction has a high concentration in organic matter with Chemical Oxygen Demand (COD) from 9.2 to 78g/L with 60-96% of COD in suspended particles (>1.2µm), 2-27% in colloids (1.2µm to 1kDa) and 2-18% in dissolved matter (<1kDa). Besides, it contained from 1.5 to 6.5g/L total nitrogen and high ions concentrations (0.5-3.1g/L NH4+, 1.05-5.48g/L K+, 0-2.13g/L PO43-). In addition, liquid fraction of digestate has poor biodegradability due to presence of humic substances making aerobic treatment inefficient. Only physico-chemical post treatment can be proposed for organic matter removal.

Review of feedstock pretreatment strategies for improved anaerobic digestion: From lab-scale research to full-scale application.

When properly designed, pretreatments may enhance the methane potential and/or anaerobic digestion rate, improving digester performance. This paper aims at providing some guidelines on the most appropriate pretreatments for the main feedstocks of biogas plants. Waste activated sludge was firstly investigated and implemented at full-scale, its thermal pretreatment with steam explosion being most recommended as it increases the methane potential and digestion rate, ensures sludge sanitation and the heat needed is produced on-site. Regarding fatty residues, saponification is preferred for enhancing their solubilisation and bioavailability. In the case of animal by-products, this pretreatment can be optimised to ensure sterilisation, solubilisation and to reduce inhibition linked to long chain fatty acids. With regards to lignocellulosic biomass, the first goal should be delignification, followed by hemicellulose and cellulose hydrolysis, alkali or biological (fungi) pretreatments being most promising. As far as microalgae are concerned, thermal pretreatment seems the most promising technique so far.

Harmonization of the quantitative determination of volatile fatty acids profile in aqueous matrix samples by direct injection using gas chromatography and high-performance liquid chromatography techniques: Multi-laboratory validation study.

The performance parameters of volatile fatty acids (VFAs) measurements were assessed for the first time by a multi-laboratory validation study among 13 laboratories. Two chromatographic techniques (GC and HPLC) and two quantification methods such as external and internal standard (ESTD/ISTD) were combined in three different methodologies GC/ESTD, HPLC/ESTD and GC/ISTD. Linearity evaluation of the calibration functions in a wide concentration range (10-1000mg/L) was carried out using different statistical parameters for the goodness of fit. Both chromatographic techniques were considered similarly accurate. The use of GC/ISTD, despite showing similar analytical performance to the other methodologies, can be considered useful for the harmonization of VFAs analytical methodology taking into account the normalization of slope values used for the calculation of VFAs concentrations. Acceptance criteria for VFAs performance parameters of the multi-laboratory validation study should be established as follows: (1) instrument precision (RSDINST≤1.5%); (2) linearity (R(2)≥0.998; RSDSENSITIVITY≤4%; REMAX≤8%; REAVER≤ 3%); (3) precision (RSD≤1.5%); (4) trueness (recovery of 97-103%); (5) LOD (≤3mg/L); and (6) LOQ (10mg/L).

Shotgun metaproteomic profiling of biomimetic anaerobic digestion processes treating sewage sludge.

Two parallel anaerobic digestion lines were designed to match a "bovid-like" digestive structure. Each of the lines consisted of two continuous stirred tank reactors placed in series and separated by an acidic treatment step. The first line was inoculated with industrial inocula whereas the second was seeded with cow digestive tract contents. After 3 months of continuous sewage sludge feeding, samples were recovered for shotgun metaproteomic and DNA-based analysis. Strikingly, protein-inferred and 16S ribosomal DNA tags based taxonomic community profiles were not consistent. PCA however revealed a similar clustering pattern of the samples, suggesting that reproducible methodological and/or biological factors underlie this observation. The performances of the two digestion lines did not differ significantly and the cow-derived inocula did not establish in the reactors. A low throughput metagenomic dataset (3.4 × 10(6) reads, 1.1 Gb) was also generated for one of the samples. It allowed a substantial increase of the analysis depth (11 vs. 4% of spectral identification rate for the combined samples). Surprisingly, a high proportion of proteins from members of the "Candidatus Competibacter" group, a key microbial player usually found in activated sludge plants, was retrieved in our anaerobic digester samples. Data are available via ProteomeXchange with identifier PXD002420 (http://proteomecentral.proteomexchange.org/dataset/PXD002420).

Saponification of fatty slaughterhouse wastes for enhancing anaerobic biodegradability.

The thermochemical pretreatment by saponification of two kinds of fatty slaughterhouse waste--aeroflotation fats and flesh fats from animal carcasses--was studied in order to improve the waste's anaerobic degradation. The effect of an easily biodegradable compound, ethanol, on raw waste biodegradation was also examined. The aims of the study were to enhance the methanisation of fatty waste and also to show a link between biodegradability and bio-availability. The anaerobic digestion of raw waste, saponified waste and waste with a co-substrate was carried out in batch mode under mesophilic and thermophilic conditions. The results showed little increase in the total volume of biogas, indicating a good biodegradability of the raw wastes. Mean biogas volume reached 1200 mL/g VS which represented more than 90% of the maximal theoretical biogas potential. Raw fatty wastes were slowly biodegraded whereas pretreated wastes showed improved initial reaction kinetics, indicating a better initial bio-availability, particularly for mesophilic runs. The effects observed for raw wastes with ethanol as co-substrate depended on the process temperature: in mesophilic conditions, an initial improvement was observed whereas in thermophilic conditions a significant decrease in biodegradability was observed.