RÉSUMÉ
Phonon polaritons-light coupled to lattice vibrations-in polar van der Waals crystals are promising candidates for controlling the flow of energy on the nanoscale due to their strong field confinement, anisotropic propagation and ultra-long lifetime in the picosecond range1-5. However, the lack of tunability of their narrow and material-specific spectral range-the Reststrahlen band-severely limits their technological implementation. Here, we demonstrate that intercalation of Na atoms in the van der Waals semiconductor α-V2O5 enables a broad spectral shift of Reststrahlen bands, and that the phonon polaritons excited show ultra-low losses (lifetime of 4 ± 1 ps), similar to phonon polaritons in a non-intercalated crystal (lifetime of 6 ± 1 ps). We expect our intercalation method to be applicable to other van der Waals crystals, opening the door for the use of phonon polaritons in broad spectral bands in the mid-infrared domain.
RÉSUMÉ
Novel behavior has been observed at the interface of LaAlO3/SrTiO3 heterostructures such as two dimensional metallic conductivity, magnetic scattering and superconductivity. However, both the origins and quantification of such behavior have been complicated due to an interplay of mechanical, chemical and electronic factors. Here chemical and strain profiles near the interface of LaAlO3/SrTiO3 heterostructures are correlated. Conductive and insulating samples have been processed, with thicknesses respectively above and below the commonly admitted conductivity threshold. The intermixing and structural distortions within the crystal lattice have been quantitatively measured near the interface with a depth resolution of unit cell size. A strong link between intermixing and structural distortions at such interfaces is highlighted: intermixing was more pronounced in the hetero-couple with conductive interface, whereas in-plane compressive strains extended deeper within the substrate of the hetero-couple with the insulating interface. This allows a better understanding of the interface local mechanisms leading to the conductivity.
RÉSUMÉ
We study materials that present challenges for conventional elemental mapping techniques and can in some cases be treated successfully using independent component analysis (ICA). In this case the material in question is obtained from a TiO2-SiO2 solid solution that is spinodally decomposed into TiO2 rich-SnO2 rich multilayers. Conventional elemental mapping is difficult because the edges most easily mapped for these elements (Ti-L, Sn-M and O-K) all have onsets within the same 80 eV range. ICA is used to separate entire spectral signals corresponding to particular material phases or molecular units rather than particular elements and is thus able to distinguish between TiO2 and SnO2. We show that quantification of oxide species can be performed by different methods that require extra assumptions, but nevertheless should be feasible in many cases.
