Biomechanical adaptations during exhaustive runs at 90 to 120% of peak aerobic speed.

The aim of this study was to examine how running biomechanics (spatiotemporal and kinetic variables) adapt with exhaustion during treadmill runs at 90, 100, 110, and 120% of the peak aerobic speed (PS) of a maximal incremental aerobic test. Thirteen male runners performed a maximal incremental aerobic test on an instrumented treadmill to determine their PS. Biomechanical variables were evaluated at the start, mid, and end of each run until volitional exhaustion. The change of running biomechanics with fatigue was similar among the four tested speeds. Duty factor and contact and propulsion times increased with exhaustion (P ≤ 0.004; F ≥ 10.32) while flight time decreased (P = 0.02; F = 6.67) and stride frequency stayed unchanged (P = 0.97; F = 0.00). A decrease in vertical and propulsive peak forces were obtained with exhaustion (P ≤ 0.002; F ≥ 11.52). There was no change in the impact peak with exhaustion (P = 0.41; F = 1.05). For runners showing impact peaks, the number of impact peaks increased (P ≤ 0.04; [Formula: see text] ≥ 6.40) together with the vertical loading rate (P = 0.005; F = 9.61). No changes in total, external, and internal positive mechanical work was reported with exhaustion (P ≥ 0.12; F ≤ 2.32). Results suggest a tendency towards a "smoother" vertical and horizontal running pattern with exhaustion. A smoother running pattern refers to the development of protective adjustments, leading to a reduction of the load applied to the musculoskeletal system at each running step. This transition seemed continuous between the start and end of the running trials and could be adopted by the runners to decrease the muscle force level during the propulsion phase. Despite these changes with exhaustion, there were no changes in either gesture speed (no alteration of stride frequency) or positive mechanical work, advocating that runners unconsciously organize themselves to maintain a constant whole-body mechanical work output.

Effect of cold ambient temperature on heat flux, skin temperature, and thermal sensation at different body parts in elite biathletes.

Introduction: When exercising in the cold, optimizing thermoregulation is essential to maintain performance. However, no study has investigated thermal parameters with wearable-based measurements in a field setting among elite Nordic skiers. Therefore, this study aimed to assess the thermal response and sensation measured at different body parts during exercise in a cold environment in biathletes. Methods: Thirteen Swiss national team biathletes (6 females, 7 males) performed two skiing bouts in the skating technique on two consecutive days (ambient temperature: -3.74 ± 2.32 °C) at 78 ± 4% of maximal heart rate. Heat flux (HF), core (Tcore) and skin (Tskin) temperature were measured with sensors placed on the thigh, back, anterior and lateral thorax. Thermal sensation (TS) was assessed three times for different body parts: in protective winter clothing, in a race suit before (PRE) and after exercise (POST). Results: HF demonstrated differences (p < 0.001) between sensor locations, with the thigh showing the highest heat loss (344 ± 37 kJ/m2), followed by the back (269 ± 6 kJ/m2), the lateral thorax (220 ± 47 kJ/m2), and the anterior thorax (192 ± 37 kJ/m2). Tcore increased (p < 0.001). Tskin decreased for all body parts (p < 0.001). Thigh Tskin decreased more than for other body parts (p < 0.001). From PRE to POST, TS of the hands decreased (p < 0.01). Conclusion: Biathletes skiing in a race suit at moderate intensity experience significant heat loss and a large drop in Tskin, particularly at the quadriceps muscle. To support the optimal functioning of working muscles, body-part dependent differences in the thermal response should be considered for clothing strategy and for race suit design.

Oxygen Uptake at Critical Speed and Power in Running: Perspectives and Practical Applications.

PURPOSE: Intensity domains are recommended when prescribing exercise, and critical power/speed (CP/CS) was designated the "gold standard" when determining maximal metabolic steady state. CS is the running analog of CP for cycle ergometry. However, a CP for running could be useful for controlling intensity when training in any type of condition. Therefore, this study aimed to estimate external, internal, and total CP (CPext, CPint, and CPtot), obtained based on running power calculations, and verified whether they occurred at the same percentage of peak oxygen uptake as the usual CS. Furthermore, this study examined whether selecting strides at the start, half, or end of the exhaustive runs to calculate running power influenced the estimation of the 3 CPs. METHODS: Thirteen male runners performed a maximal incremental aerobic test and 4 exhaustive runs (90%, 100%, 110%, 120% peak speed) on a treadmill. The estimations of CS and CPs were obtained using a 3-parameter mathematical model fitted using weighted least square. RESULTS: CS was estimated at 4.3 m/s while the estimates of CPext, CPint, and CPtot were 5.2, 2.6, and 7.8 W/kg, respectively. The corresponding V˙O2 for CS was 82.5 percentage of peak oxygen uptake and 81.3, 79.7, and 80.6 percentage of peak oxygen uptake for CPext, CPint, and CPtot, respectively. No systematic bias was reported when comparing CS and CPext, as well as the 3 different CPs, whereas systematic biases of 2.8% and 1.8% were obtained for the comparison among CS and CPint and CPtot, respectively. Nonetheless, the V˙O2 for CS and CPs were not statistically different (P = .09). Besides, no effect of the time stride selection for CPs as well as their resulting V˙O2 was obtained (P ≥ .44). CONCLUSIONS: The systematic biases among V˙O2 at CS and CPint and CPtot were not clinically relevant. Therefore, CS and CPs closely represent the same fatigue threshold in running. The knowledge of CP in running might prove to be useful for both athletes and coaches, especially when combined with instantaneous running power. Indeed, this combination might help athletes controlling their targeted training intensity and coaches prescribing a training session in any type of condition.

On the Use of the Repeated-Sprint Training in Hypoxia in Tennis.

PURPOSE: To examine physiological and technical responses to repeated-sprint training in normobaric hypoxia at ∼3,000 m (RSH, n = 11) or in normoxia (RSN, n = 11) compared to a control group (CON, n = 8) in well-trained tennis players. Participants were 28.8 ± 5.9 years old without any previous experience of training in hypoxia. METHODS: In addition to maintaining their usual training (CON), both RSH and RSN groups completed five tennis specific repeated-shuttle sprint sessions (4 × 5 × âˆ¼8 s maximal sprints with ∼22 s passive recovery and ∼5 min rest between sets) over 12 days. Before (Pre), the week after (Post-1) and 3 weeks after Post-1 (Post-2), physical/technical performance during Test to Exhaustion Specific to Tennis (TEST), repeated-sprint ability (RSA) (8 × âˆ¼20 m shuttle runs-departing every 20 s) and heart rate variability (HRV) were assessed. RESULTS: From Pre to Post-1 and Post-2, RSH improved TEST time to exhaustion (+18.2 and +17.3%; both P < 0.001), while the "onset of blood lactate accumulation" at 4 mmol L-1 occurred at later stages (+24.4 and +19.8%, both P < 0.01). At the same time points, ball accuracy at 100% V̇O2m ax increased in RSH only (+38.2%, P = 0.003 and +40.9%, P = 0.007). Markers of TEST performance did not change for both RSN and CON. Compared to Pre, RSA total time increased significantly at Post-1 and Post-2 (-1.9 and -2.5%, P < 0.05) in RSH only and this was accompanied by larger absolute Δ total hemoglobin (+82.5 and +137%, both P < 0.001). HRV did not change either supine or standing positions. CONCLUSION: Five repeated sprint training sessions in hypoxia using tennis specific shuttle runs improve physiological and technical responses to TEST, RSA, and accompanying muscle perfusion responses in well-trained tennis players.