Comparison of superficially porous and fully porous silica supports used for a cyclofructan 6 hydrophilic interaction liquid chromatographic stationary phase.

A new HILIC stationary phase comprised of native cyclofructan-6 (CF6) bonded to superficially porous silica particles (2.7µm) was developed. Its performance was evaluated and compared to fully porous silica particles with 5µm (commercially available as FRULIC-N) and 3µm diameters. Faster and more efficient chromatography was achieved with the superficially porous particles (SPPs). The columns were also evaluated in the normal phase mode. The peak efficiency, analysis time, resolution, and overall separation capabilities in both HILIC and normal phase modes were compared. The analysis times using the superficially porous based column in HILIC mode were shorter and the theoretical plates/min were higher over the entire range of flow rates studied. The column containing the superficially porous particles demonstrated higher optimum flow rates than the fully porous particle packed columns. At higher flow rates, the advantages of the superficially porous particles was more pronounced in normal phase separations than in HILIC, clearly demonstrating the influence that the mode of chromatography has on band broadening. However, the minimum reduced plate heights (hmin) were typically lower in HILIC than in the normal phase mode. Overall, the superficially porous particle based CF6 column showed clear advantages over the fully porous particle columns, in terms of high throughput and efficient separations of polar compounds in the HILIC mode.

Superficially porous particles vs. fully porous particles for bonded high performance liquid chromatographic chiral stationary phases: isopropyl cyclofructan 6.

This work reports a comparison of HPLC separations of enantiomers with chiral stationary phases (CSPs) prepared by chemically bonding cyclofructan-6, functionalized with isopropyl carbamate groups on fully and superficially porous particles (SPPs). The chromatographic performance of the superficially porous CSP based column was compared with columns packed with 5 µm and 3 µm fully porous particles (FPPs). At a flow rate of 3.0 mL/min the number of plates on column afforded by the SPP column was ∼7× greater than the number of plates on column (same length) obtained when using the 5 µm FPP based column. The flow rate providing the highest efficiency separation was ∼1.0 mL/min for the SPP column while it was ∼0.5 mL/min for both FPP columns. It was found that the selectivity and resolution of the separations were comparable between fully porous and superficially porous based columns (under constant mobile phase conditions), even though the SPP column contained lower absolute amounts of chiral selector. When tested under constant retention conditions, the SPP based CSP greatly improved resolution compared to the FPP based columns. At high flow rates the efficiency gained by using superficially porous CSP was accentuated. The advantages of columns based on SPPs become more obvious from the viewpoint of plate numbers and resolution per analysis time.