RÉSUMÉ
Objective: To evaluate the hydrothermal aging effect on the translucency of partially stabilized tetragonal zirconia with yttria (Y-TZP) used as monolithic or fully milled zirconia and of core type. Methods: Twenty disc-shaped specimens (1 and 10 mm) for each type of monolithic and core Y-TZP materials were milled and sintered according to the manufacturer's instruction. The final specimens were divided into two groups according to the type of Y-TZP used. Translucency parameter (TP) was measured over white and black backgrounds with the diffuse reflectance method; X-ray diffraction (XRD) and scanning electron microscope (SEM) were used to analyze the microstructure of both Y-TZP types before and after aging. Data for TP values was statistically analyzed using Student's t-test. Results: Monolithic Y-TZP showed the highest TP mean value (16.4 ± 0.316) before aging while core Y-TZP showed the lowest TP mean value (7.05 ± 0.261) after aging. There was a significant difference between the two Y-TZP types before and after hydrothermal aging. XRD analysis showed increases in monoclinic content in both Y-TZP surfaces after aging. Conclusion: Monolithic Y-TZP has a higher chance to low-temperature degradation than core type, which may significantly affect the esthetic appearance and translucency hence durability of translucent Y-TZP.
RÉSUMÉ
PURPOSE: To study the effect of addition of poly(acrylamide-co-sodium acrylate) copolymer and/or TiO2 nanoparticles on the mechanochemical properties of conventional glass ionomer (GIC)-based restorative materials. MATERIALS AND METHODS: The copolymer was prepared, characterized and then added, either separately or in combination with different proportions of TiO2 nanoparticles to the conventional GIC powder. The developed composites were characterized using FTIR spectrometry, x-ray diffraction, and scanning electron microscopy. The mechanical properties of the obtained series of modified GIC formulations were investigated in comparison with other formulations containing only TiO2 nanoparticles through testing their compressive strength, flexural strength, and dentin shear bond strength. RESULTS: The preliminary data of the study showed a significant increase in the compressive strength of the conventional GIC after addition of 3% and 5% TiO2 nanoparticles by weight, but 7% decreased it. Upon addition of copolymer, the compressive strength was lower than that of the conventional GIC. The highest average compressive strength value was obtained upon incorporation of 7% 1:1 combination of copolymer-TiO2 nanoparticles. The results also demonstrated a significant increase in the flexural strength values after addition of both copolymer and TiO2 nanoparticles to the GIC powder. In addition, the results revealed a significant increase in values of dentin shear bond strength after copolymer addition with the highest value noted upon addition of 7% by weight of copolymer. CONCLUSION: The new series of modified glass ionomers developed here can be tailored to act as restorative materials with high quality performance in high stress-bearing areas.