Improved Electrochemical Performance of 0.5Li2MnO3·0.5LiNi0.5Mn0.5O2 Cathode Materials for Lithium Ion Batteries Synthesized by Ionic-Liquid-Assisted Hydrothermal Method.

Well-dispersed Li-rich Mn-based 0.5Li2MnO3·0.5LiNi0.5Mn0.5O2 nanoparticles with diameter ranging from 50 to 100 nm are synthesized by a hydrothermal method in the presence of N-hexyl pyridinium tetrafluoroborate ionic liquid ([HPy][BF4]). The microstructures and electrochemical performance of the prepared cathode materials are characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), and electrochemical measurements. The XRD results show that the sample prepared by ionic-liquid-assisted hydrothermal method exhibits a typical Li-rich Mn-based pure phase and lower cation mixing. SEM and TEM images indicate that the extent of particle agglomeration of the ionic-liquid-assisted sample is lower compared to the traditional hydrothermal sample. Electrochemical test results indicate that the materials synthesized by ionic-liquid-assisted hydrothermal method exhibit better rate capability and cyclability. Besides, electrochemical impedance spectroscopy (EIS) results suggest that the charge transfer resistance of 0.5Li2MnO3· 0.5LiNi0.5Mn0.5O2 synthesized by ionic-liquid-assisted hydrothermal method is much lower, which enhances the reaction kinetics.

Cryptomelane-Type KMn8O16 as Potential Cathode Material - for Aqueous Zinc Ion Battery.

Aqueous battery has been gained much more interest for large-scale energy storage fields due to its excellent safety, high power density and low cost. Cryptomelane-type KMn8O16 confirmed by X-ray diffraction (XRD) was successfully synthesized by a modified hydrothermal method, followed by annealed at 400°C for 3 h. The morphology and microstructure of as-prepared KMn8O16 investigated by field-emission scanning electron microscopy (FE-SEM) with the energy spectrum analysis (EDS) and transmission electron microscopy (TEM) demonstrate that one-dimensional nano rods with the length of about 500 nm constitute the microspheres with the diameter about 0.5~2 µm. The cyclic voltammetry measurement displays that the abundant intercalation of zinc ions on the cathode takes place during the initial discharge process, indicating that cryptomelane-type KMn8O16 can be used as the potential cathode material for aqueous zinc ion batteries. The electrode shows a good cycling performance with a reversible capacity of up to 77.0 mAh/g even after 100 cycles and a small self-discharge phenomenon.

Three-Dimension Hierarchical Al2O3 Nanosheets Wrapped LiMn2O4 with Enhanced Cycling Stability as Cathode Material for Lithium Ion Batteries.

A three dimensional (3D) Al2O3 coating layer was synthesized by a facile approach including stripping and in situ self-assembly of γ-AlOOH. The uniform flower-like Al2O3 nanosheets with high specific area largely sequesters acidic species produced by side reaction between electrode and electrolyte. The inner coating layer wrapping spinel LiMn2O4 effectively inhibits the dissolution of Mn by suppressing directive contact with electrolyte to enhance cycling stability. The rate performance is improved because of the better electrolyte storage of the assembled hierarchical architecture of the 3D coating layer affording unimpeded Li(+) diffusion from electrode to electrolyte. The electrochemical results reveal the as-prepared coated LiMn2O4 sample with the amount of Al2O3 at 1 wt % exhibits superior cycle stability under room temperature even at elevated temperature. The initial specific discharge capacity is 128.5 mAh g(-1) at 0.1 C and retains 89.8% of the initial capacity after 800 cycles at 1 C rate. When cycling at 55 °C, the composite shows 93.6% capacity retention after 500 cycles. This facile surface modification and effective structure of coating layer can be adopted to enhance the cycling performance and thermal stability of other electrode materials for which Al2O3 plays its role.

Bacillus crassostreae sp. nov., isolated from an oyster (Crassostrea hongkongensis).

A novel Gram-stain-positive, motile, catalase- and oxidase-positive, endospore-forming, facultatively anaerobic rod, designated strain JSM 100118(T), was isolated from an oyster (Crassostrea hongkongensis) collected from the tidal flat of Naozhou Island in the South China Sea. Strain JSM 100118(T) was able to grow with 0-13% (w/v) NaCl (optimum 2-5%), at pH 5.5-10.0 (optimum pH 7.5) and at 5-50 °C (optimum 30-35 °C). The cell-wall peptidoglycan contained meso-diaminopimelic acid as the diagnostic diamino acid. The predominant respiratory quinone was menaquinone-7 and the major cellular fatty acids were anteiso-C15 : 0, iso-C15 : 0, C16 : 0 and C16 : 1ω11c. The polar lipids consisted of diphosphatidylglycerol, phosphatidylethanolamine, phosphatidylglycerol, an unknown glycolipid and an unknown phospholipid. The genomic DNA G+C content was 35.9 mol%. Phylogenetic analysis based on 16S rRNA gene sequences indicated that strain JSM 100118(T) belonged to the genus Bacillus , and was most closely related to Bacillus litoralis SW-211(T) (98.9% 16S rRNA gene sequence similarity), Bacillus halosaccharovorans E33(T) (98.3%), Bacillus niabensis 4T19(T) (97.8%) and Bacillus herbersteinensis D-1,5a(T) (97.1%). The combination of results from the phylogenetic analysis, DNA-DNA hybridization, and phenotypic and chemotaxonomic characterization supported the conclusion that strain JSM 100118(T) represents a novel species of the genus Bacillus , for which the name Bacillus crassostreae sp. nov. is proposed. The type strain is JSM 100118(T) ( = CTCC AB 2010452(T) =DSM 24486(T) =JCM 17523(T)).