Optimization of Initial Cation Concentrations for L-Lactic Acid Production from Fructose by Lactobacillus pentosus Cells.

In this study, Box-Behnken design was applied to optimize the initial concentrations of 4 cations for L-lactic acid production from fructose by homologous batch fermentation of Lactobacillus pentosus cells. The optimum initial cation concentrations were obtained as 6.542 mM Mg2+, 3.765 mM Mn2+, 2.397 mM Cu2+, and 3.912 mM Fe2+, respectively. The highest L-lactic acid yield and productivity were obtained as 0.935 ± 0.005 g/g fructose and 1.363 ± 0.021 g/(L × h), respectively, with a maximum biomass concentration of 7.97 ± 0.17 g/L. The effectiveness of the optimization by Box-Behnken design was confirmed based on the small errors between predicted results and experimental results shown as 0.3%, - 0.2%, and - 1.2%, respectively. The quadratic models with high accuracy and reliability can be applied to mathematically forecasted the fermentation performance. After the optimization, the lactic acid yield and productivity were significantly improved by 3.7% and 21.0%, respectively.

Parametric optimization and kinetic study of l-lactic acid production by homologous batch fermentation of Lactobacillus pentosus cells.

Parametric optimization always plays important roles in bioengineering systems to obtain a high product yield under the proper conditions. The parametric conditions of lactic acid production by homologous batch fermentation of Lactobacillus pentosus cells was optimized by the Box-Behnken design. The highest l-lactic acid yield was obtained as 0.836 ± 0.003 g/g glucose with the productivity of 0.906 ± 0.003 g/(L × H) under the optimum conditions of 34.7 °C, pH 6.2, 148 rpm agitation speed, and 9.3 g/L nitrogen source concentration determined by quadratic response surface with high accuracy. The adequate kinetic models of cell growth rate, lactic production rate, and glucose consumption rate were also established to describe the fermentation behavior of L. pentosus cells with the correlation coefficients of 09985, 0.9990, and 0.9989, respectively.

L-Lactic acid production from fructose by chitosan film-coated sodium alginate-polyvinyl alcohol immobilized Lactobacillus pentosus cells and its kinetic analysis.

Under the optimal conditions of immobilization and fermentation, the highest LA yield of 0.966 ± 0.006 g/g fructose and production rate of 2.426 ± 0.018 g/(L × h) with an error of -0.5% and -0.2% to the predicted results were obtained from batch fermentation by the CS film-coated SA-PVA immobilized L. pentosus cells. The LA yield and production rate of these immobilized cells were 2.7% and 10.1% higher than that of normal SA-PVA immobilized cells respectively, and they were 5.7% and 48.4% higher than that of free cells, respectively. The effect of temperature on different types of immobilized cells and free cells was significantly different, but the effect of pH on different types of cells was not much different. The kinetic models could effectively describe the different fermentation performances of three types of cells. The immobilized cells have excellent reusability to conduct 9 runs of repeated batch fermentation.

Effects of different sodium salts and nitrogen sources on the production of 3-hydroxybutyrate and polyhydroxybutyrate by Burkholderia cepacia.

The effects of NaCl, Na2SO4, Na2HPO4, and Na3C6H5O7 on the production of 3-hydroxybutyrate, polyhydroxybutyrate, and by-products by Burkholderia cepacia. Proper addition of Na3C6H5O7 can significantly promote the production of 3-hydroxybutyric acid and polyhydroxybutyrate. The concentration, productivity, and yield of 3-hydroxybutyrate were increased by 48.2%, 55.6%, and 48.3% at 16 mM Na3C6H5O7. The increases of 80.1%, 47.1%, and 80.0% in the concentration, productivity, and yield of polyhydroxybutyrate were observed at 12 mM Na3C6H5O7. Na2SO4 and Na2HPO4 also have positive effects on the production capacity of 3-hydroxybutyrate and polyhydroxybutyrate within a certain range of concentration. NaCl is not conducive to the improvement of fermentation efficiency. Compared with a single nitrogen source, a mixed nitrogen source is more conducive to enhancing the production of 3-hydroxybutyrate and polyhydroxybutyrate.

Optimization of immobilization conditions for Lactobacillus pentosus cells.

In this study, the immobilization technology was used to improve the LA yield and shorten the fermentation time. The optimum conditions to immobilize Lactobacillus pentosus ATCC 8041 cell were determined by Taguchi design L16 (45). The immobilized L. pentosus ATCC 8041 cells prepared by 2% sodium alginate (SA) and 6% polyvinyl alcohol (PVA) with the immobilization process by 0.10 M calcium chloride (CaCl2) and 2.5% boric acid (H3BO3) had the best performance of LA yield at the temperature of 35 °C, which is significantly higher than that of L. pentosus ATCC 8041 free cells. These cells maintained the stable and efficient performance in 15 repeated batch fermentation, and they also have excellent mechanical strength to keep from breakage caused by cell growth and agitation.