Fabrication of one-dimensional Zn-doped Bi2S3 nanorods for photodiode applications.

In this research, the impact of the different zinc (Zn) concentrations on the physical and optoelectronic properties of Bi2S3 nanorods as self-powered and photodiode applications was investigated. The performance of P-N junction photodiodes has been for decades since they are crucial in energy applications. The structure, degree of crystallinity, and shape of Zn-doped Bi2S3 nanorods of various doping percentages formed onto the indium tin oxide (ITO) substrates by the dip coating technique are investigated using X-ray powder diffraction (XRD) and SEM. With increasing illumination time, the current-voltage (I-V) graphs demonstrate a rise in photocurrent. The diode's idealist factor was estimated using the I-V technique under 30 min of light illumination.

Fluorometric detection of copper and imidacloprid using nitrogen-doped graphitic carbon dots: A promising method for environmental monitoring.

Pesticides in environmental samples pose significant risks to ecosystems and human health since they require precise and efficient detection methods. Imidacloprid (IMI), a widely used neonicotinoid insecticide, exemplifies these hazards due to its potential toxicity. This study addresses the urgent need for improved monitoring of such contaminants by introducing a novel fluorometric method for detecting IMI using nitrogen-doped graphite carbon dots (N-GCDs). The sensor operates by quenching fluorescence through the interaction of Cu2+ ions with N-GCDs. Subsequently, IMI binds to the imidazole group, chelates with Cu2+, and restores the fluorescence of N-GCDs. This alternating fluorescence behavior allows for the accurate identification of both Cu2+ and IMI. The sensor exhibits linear detection ranges of 20-100 nM for Cu2+ and 10-140 µg/L for IMI, with detection limits of 18 nM and 1.2 µg/L, respectively. The high sensitivity of this sensor enables the detection of real-world samples, which underscores its potential for practical use in environmental monitoring and agricultural safety.

Construction of SnO2/g-C3N4 an effective nanocomposite for photocatalytic degradation of amoxicillin and pharmaceutical effluent.

The current study mainly focused on the fabrication of 2D graphitic carbon nitride-supported tin oxide nanoparticles (SnO2/g-C3N4) for the effective degradation of Amoxicillin (AMX). Tin oxide (SnO2) NPs were prepared by green and easy modification technique, and then it is decorated over g-C3N4 nanosheets. The structural morphology and surface composition of the synthesized SnO2/g-C3N4 nanocomposite were fully analysed by UV-Vis, XRD, XPS, and HR-SEM with EDAX, FT-IR, and BET analysis. The (HR-TEM) microscopy, the size of SnO2 NPs which as a diameter is about 6.2 nm. The Raman analysis revealed that the SnO2/g-C3N4 composite had a moderate graphitic structure, with a measured ID/Ig value of 0.79. The degradation efficiency of antibiotic pollutant AMX and pharma effluent treatment was monitored by UV spectroscopy. The optical band gap of SnO2 (2.9 eV) and g-C3N4 (2.8 eV) photocatalyst was measured by Tauc plots. To investigate the mechanism through the photodegradation efficiency of the catalyst was analysed by using different Scavenger EDTA-2Na holes (h+) has a greater contribution towards the degradation process. Under visible irradiation, SnO2/g-C3N4 nanocomposite has exhibited an excellent degradation performance of 92.1% against AMX and 90.8% for pharmaceutical effluent in 80 min.