RÉSUMÉ
Portland cements (PCs) and cement blends are multiphase materials of different fineness, and quantitatively analysing their hydration pathways is very challenging. The dissolution (hydration) of the initial crystalline and amorphous phases must be determined, as well as the formation of labile (such as ettringite), reactive (such as portlandite) and amorphous (such as calcium silicate hydrate gel) components. The microstructural changes with hydration time must also be mapped out. To address this robustly and accurately, an innovative approach is being developed based on in situ measurements of pastes without any sample conditioning. Data are sequentially acquired by Mo Kα1 laboratory X-ray powder diffraction (LXRPD) and microtomography (µCT), where the same volume is scanned with time to reduce variability. Wide capillaries (2â mm in diameter) are key to avoid artefacts, e.g. self-desiccation, and to have excellent particle averaging. This methodology is tested in three cement paste samples: (i) a commercial PC 52.5 R, (ii) a blend of 80â wt% of this PC and 20â wt% quartz, to simulate an addition of supplementary cementitious materials, and (iii) a blend of 80â wt% PC and 20â wt% limestone, to simulate a limestone Portland cement. LXRPD data are acquired at 3â h and 1, 3, 7 and 28 days, and µCT data are collected at 12â h and 1, 3, 7 and 28 days. Later age data can also be easily acquired. In this methodology, the amounts of the crystalline phases are directly obtained from Rietveld analysis and the amorphous phase contents are obtained from mass-balance calculations. From the µCT study, and within the attained spatial resolution, three components (porosity, hydrated products and unhydrated cement particles) are determined. The analyses quantitatively demonstrate the filler effect of quartz and limestone in the hydration of alite and the calcium aluminate phases. Further hydration details are discussed.
RÉSUMÉ
Cement hydration is a very complex set of processes. The evolution of the crystalline phases during hydration can be accurately followed by X-ray powder diffraction data evaluated by the Rietveld method. However, accurate measurements of some microstructural features, including porosity and amorphous content developments, are more challenging. Here, we combine laboratory X-ray powder diffraction and computed microtomography (µCT) to better understand the results of the µCT analyses. Two pastes with different water-cement ratios, 0.45 and 0.65, filled within capillaries of two sizes, Ï = 0.5 and 1.0 mm, were analysed at 50 days of hydration. It was shown that within the spatial resolution of the measured µCTs, ~2 µm, the water capillary porosity was segmented within the hydrated component fraction. The unhydrated part could be accurately quantified within 2 vol% error. This work is a first step to accurately determining selected hydration features like the hydration degree of amorphous phases of supplementary cementitious materials within cement blends.
RÉSUMÉ
The fabrication of pectin-cellulose nanocrystal (CNC) biocomposites has been systematically investigated by blending both polysaccharides at different relative concentrations. Circular free-standing films with a diameter of 9 cm were prepared by simple solution of these carbohydrates in water followed by drop-casting and solvent evaporation. The addition of pectin allows to finely tune the properties of the biocomposites. Textural characterization by AFM showed fibrous morphology and an increase in fiber diameter with pectin content. XRD analysis demonstrated that pectin incorporation also reduced the degree of crystallinity though no specific interaction between both polysaccharides was detected, by ATR-FTIR spectroscopy. The optical properties of these biocomposites were characterized for the first time and it was found that pectin in the blend reduced the reflectance of visible light and increased UV absorbance. Thermal stability, analyzed by TGA, was improved with the incorporation of pectin. Finally, pectin-cellulose nanocrystal biocomposites showed a good biodegradability in seawater, comparable to other common bioplastics such as cellulose and low-molecular weight polylactide, among others.
Sujet(s)
Cellulose/composition chimique , Nanocomposites/composition chimique , Nanoparticules/composition chimique , Pectine/composition chimique , Hydrolyse , Microscopie à force atomique , Microscopie électronique à balayage , Nanocomposites/ultrastructure , Nanoparticules/ultrastructure , Phénomènes physiques , Polyosides/composition chimique , Eau de mer/composition chimique , Spectroscopie infrarouge à transformée de Fourier , Diffraction des rayons XRÉSUMÉ
Herein, we exploit the well-known swelling behaviour of metal-organic frameworks (MOFs) to create a self-folding polymer film. Namely, we show that incorporating crystals of the flexible MOF MIL-88A into a polyvinylidene difluoride (PVDF) matrix affords a polymer composite film that undergoes reversible shape transformations upon exposure to polar solvents and vapours. Since the self-folding properties of this film correlate directly with the swelling properties of the MIL-88A crystals, it selectively bends to certain solvents and its degree of folding can be controlled by controlling the relative humidity. Moreover, it shows a shape-memory effect at relative humidity values from 60 % to 90 %. As proof of concept, we demonstrate that these composite films can lift cargo and can be used to assemble 3D structures from 2D patterns. Our strategy is a straightforward method for designing autonomous soft materials with folding properties that can be tuned by judicious choice of the constituent flexible MOF.
RÉSUMÉ
We report the synthesis, structural characterization, and functionality (framework interconversions together with proton conductivity) of an open-framework hybrid that combines Ca(2+) ions and the rigid polyfunctional ligand 5-(dihydroxyphosphoryl)isophthalic acid (PiPhtA). Ca2[(HO3PC6H3COOH)2]2[(HO3PC6H3(COO)2H)(H2O)2]·5H2O (Ca-PiPhtA-I) is obtained by slow crystallization at ambient conditions from acidic (pH ≈ 3) aqueous solutions. It possesses a high water content (both Ca coordinated and in the lattice), and importantly, it exhibits water-filled 1D channels. At 75 °C, Ca-PiPhtA-I is partially dehydrated and exhibits a crystalline diffraction pattern that can be indexed in a monoclinic cell with parameters close to the pristine phase. Rietveld refinement was carried out for the sample heated at 75 °C, Ca-PiPhtA-II, using synchrotron powder X-ray diffraction data, which revealed the molecular formula Ca2[(HO3PC6H3COOH)2]2[(HO3PC6H3(COO)2H)(H2O)2]. All connectivity modes of the "parent" Ca-PiPhtA-I framework are retained in Ca-PiPhtA-II. Upon Ca-PiPhtA-I exposure to ammonia vapors (28% aqueous NH3) a new derivative is obtained (Ca-PiPhtA-NH3) containing 7 NH3 and 16 H2O molecules according to elemental and thermal analyses. Ca-PiPhtA-NH3 exhibits a complex X-ray diffraction pattern with peaks at 15.3 and 13.0 Å that suggest partial breaking and transformation of the parent pillared structure. Although detailed structural identification of Ca-PiPhtA-NH3 was not possible, due in part to nonequilibrium adsorption conditions and the lack of crystallinity, FT-IR spectra and DTA-TG analysis indicate profound structural changes compared to the pristine Ca-PiPhtA-I. At 98% RH and T = 24 °C, proton conductivity, σ, for Ca-PiPhtA-I is 5.7 × 10(-4) S·cm(-1). It increases to 1.3 × 10(-3) S·cm(-1) upon activation by preheating the sample at 40 °C for 2 h followed by water equilibration at room temperature under controlled conditions. Ca-PiPhtA-NH3 exhibits the highest proton conductivity, 6.6 × 10(-3) S·cm(-1), measured at 98% RH and T = 24 °C. Activation energies (Ea) for proton transfer in the above-mentioned frameworks range between 0.23 and 0.4 eV, typical of a Grothuss mechanism of proton conduction. These results underline the importance of internal H-bonding networks that, in turn, determine conductivity properties of hybrid materials. It is highlighted that new proton transfer pathways may be created by means of cavity "derivatization" with selected guest molecules resulting in improved proton conductivity.
Sujet(s)
Phosphates de calcium/composition chimique , Cristallisation , Cristallographie aux rayons X , Protons , Solutions , Spectroscopie infrarouge à transformée de FourierRÉSUMÉ
Multifunctional materials, especially those combining two or more properties of interest, are attracting immense attention due to their potential applications. MOFs, metal organic frameworks, can be regarded as multifunctional materials if they show another useful property in addition to the adsorption behavior. Here, we report a new multifunctional light hybrid, MgH(6)ODTMP·2H(2)O(DMF)(0.5) (1), which has been synthesized using the tetraphosphonic acid H(8)ODTMP, octamethylenediamine-N,N,N',N'-tetrakis(methylenephosphonic acid), by high-throughput methodology. Its crystal structure, solved by Patterson-function direct methods from synchrotron powder X-ray diffraction, was characterized by a 3D pillared open framework containing cross-linked 1D channels filled with water and DMF. Upon H(2)O and DMF removal and subsequent rehydration, MgH(6)ODTMP·2H(2)O (2) and MgH(6)ODTMP·6H(2)O (3) can be formed. These processes take place through crystalline-quasi-amorphous-crystalline transformations, during which the integrity of the framework is maintained. A water adsorption study, at constant temperature, showed that this magnesium tetraphosphonate hybrid reversibly equilibrates its lattice water content as a function of the water partial pressure. Combination of the structural study and gas adsorption characterization (N(2), CO(2), and CH(4)) indicates an ultramicroporous framework. High-pressure CO(2) adsorption data are also reported. Finally, impedance data indicates that 3 has high proton conductivity σ = 1.6 × 10(-3) S cm(-1) at T = 292 K at ~100% relative humidity with an activation energy of 0.31 eV.
Sujet(s)
Réactifs réticulants/composition chimique , Magnésium/composition chimique , Composés organométalliques/composition chimique , Acides phosphoreux/composition chimique , Protons , Conductivité électrique , Modèles moléculaires , Composés organométalliques/synthèse chimique , Porosité , Diffraction sur poudre , Propriétés de surface , TempératureRÉSUMÉ
A new flexible ultramicroporous solid, La(H(5)DTMP)·7H(2)O (1), has been crystallized at room temperature using the tetraphosphonic acid H(8)DTMP, hexamethylenediamine-N,N,N',N'-tetrakis(methylenephosphonic acid). Its crystal structure, solved by synchrotron powder X-ray diffraction, is characterised by a 3D pillared open-framework containing 1D channels filled with water. Upon dehydration, a new related crystalline phase, La(H(5)DTMP) (2) is formed. Partial rehydration of 2 led to La(H(5)DTMP)·2H(2)O (3). These new phases contain highly corrugated layers showing different degrees of conformational flexibility of the long organic chain. The combination of the structural study and the gas adsorption characterization (N(2) and CO(2)) suggests an ultramicroporous flexible framework. NO isotherms are indicative of a strong irreversible adsorption of NO within the pores. Impedance data indicates that 1 is a proton-conductor with a conductivity of 8 × 10(-3) S cm(-1) at 297 K and 98% of relative humidity, and an activation energy of 0.25 eV.
RÉSUMÉ
Este es el primer estudio hecho en Honduras, sobre incidencia de "Helicobacter) pylori" basado en 50 biopsias endoscópicas paracticadas en le Instituto Hondureño de Seguridad Social. Veinte y cuatro pacientes del sexo masculino y 26 del femenino, cuyas edades oscilaban entre los 23 y 81 años de edad. De los 50 casos estudiados, 14 pacientes tenían endoscopía normal, 17 con gastritis antral, 7 con gastritis corporal. El 64% de los pacientes albergaba la bacteria, identificada con métodos microbiológicos e histológicos. Todos ellos presentaban gastrítis histológica activa (100%), 3 asociados a úlcera y uno de úlcera duodenal. No se encontró la bacteria en un caso de carcinoma gástrico y otro con displasia severa. Estos resultados son similares a los encontrados en otras partes del mundo
Sujet(s)
Adulte , Adulte d'âge moyen , Humains , Mâle , Femelle , Infections à Campylobacter/anatomopathologie , Biopsie , Campylobacter/isolement et purification , Infections à Campylobacter/anatomopathologie , Infections à Campylobacter/épidémiologie , Études prospectives , EndoscopieRÉSUMÉ
Este es el primer estudio hecho en Honduras, sobre incidencia de "Helicobacter (Campylobacter) Pylori" basodo en 50 biopsias endoscópicas practicadas en el Instituto Hondureño de Seguridad Social. Veinte y cuatro pacientes del sexo masculino y 26 del femenino, cuyas edades oscilaban entre los 23 y 81años de edad. De los 50 casos estudiados, 14 pacientes tenian endoscopia normal, 17 con gastritis antral, 7 con gastritis corporal. El 64
de los pacientes albergaba la bacteria, identificada con métodos microbiológicos e histológicos. Todos ellos presentaban gastrítis histologica activa (100
), 3 asociados a úlcera gástrica y uno a úlcera duodenal. No se encontró la bacteria en un caso de carcicoma gástrico y otro con displcia severa. Estos resultados son similares a los encontrados en otras partes del mundo.