RÉSUMÉ
The quest for artificial light sources mimicking sunlight has been a long-standing endeavor, particularly for applications in anticounterfeiting, agriculture, and color hue detection. Conventional sunlight simulators are often cost-prohibitive and bulky. Therefore, the development of a series of single-phase phosphors Ca9LiMg1-xAl2x/3(PO4)7:0.1Eu2+ (x = 0-0.75) with sunlight-like emission represents a welcome step towards compact and economical light source alternatives. The phosphors are obtained by an original heterovalent substitution method and emit a broad spectrum spanning from violet to deep red. Notably, the phosphor with x = 0.5 exhibits an impressive full width at half-maximum of 330 nm. A synergistic interplay of experimental investigations and theory unveils the mechanism behind sunlight-like emission due to the local structural perturbations introduced by the heterovalent substitution of Al3+ for Mg2+, leading to a varied distribution of Eu2+ within the lattice. Subsequent characterization of a series of organic dyes combining absorption spectroscopy with convolutional neural network analysis convincingly demonstrates the potential of this phosphor in portable photodetection devices. Broad-spectrum light source testing empowers the model to precisely differentiate dye patterns. This points to the phosphor being ideal for mimicking sunlight. Beyond this demonstrated application, the phosphor's utility is envisioned in other relevant domains, including visible light communication and smart agriculture.
RÉSUMÉ
Developing novel luminescent materials with ideal properties is an endless project, urged by growing requirements of advances in energy saving, healthy lighting and environmental friendliness. Herein, a series of ScCaOBO3:Ce3+,Mn2+ phosphors with excellent luminescence properties were synthesized by the high temperature solid state method. X-ray diffraction was applied to analyse the phase composition of the obtained phosphors. The morphology and dopant distribution were observed by scanning electron microscopy (SEM) and energy dispersive spectrometry (EDS), respectively. The Rietveld refinements and luminescence spectra indicate that Ce3+ preferentially occupies the Sc3+ site and produces a blue emission band at around 460 nm, which originates from the characteristic 5d-4f transitions, while Mn2+ preferentially occupies the Ca2+ site and emits red light due to its characteristic 4T1(4G)-6A1(6S) transitions. Upon excitation at 354 nm, both Ce3+ and Mn2+ emissions can be obtained and further investigations evidenced that the broad and intense light emission of Mn2+ located in the red spectral region is the result of energy transfer from Ce3+ to Mn2+. Theoretical calculations reveal that the energy transfer process from Ce3+ to Mn2+ is of the resonance type and is governed by electric dipole-dipole interactions. Since the ScCaOBO3:Ce3+,Mn2+ phosphors are capable of producing broadband emissions that widely cover the blue and red spectral regions, the introduction of a green light-emitting phosphor CMA:Tb3+ can conveniently generate high quality white light. Therefore, a white light-emitting diode device with extremely high color rendering indices, Ra = 93.7 and R9 = 91.9, was successfully obtained.
Sujet(s)
Luminescence , Manganèse , Transfert d'énergie , Manganèse/composition chimique , Rayons ultraviolets , Diffraction des rayons XRÉSUMÉ
A new generation of red phosphors of complex fluoride matrices activated with Mn4+ has gained a broad interest in getting high color quality and low color temperature of solid-state white light-emitting diodes (WLEDs). However, besides their instability toward moisture, the extremely irregular and nonuniform morphologies of these phosphors have limited their practical industry applications. In the present study, a novel type of K3ScF6:Mn4+ red phosphor with highly regular, uniform, and high color purity was obtained successfully through a facile coprecipitation route under mild conditions. The crystal structure was identified with aids of the powder X-ray diffraction, Rietveld refinement, and density functional theory calculations. The prototype crystallizes in the space group Fm3 m with a cubic structure, and the lattice parameters are fitted well to be a = b = c = 8.4859(8) Å and V = 611.074(2) Å3. The Mn4+ ions occupy Sc3+ sites and locate at the centers of the distorted ScF6 octahedrons. A wide band gap of approximately 6.15 eV can provide sufficient space to accommodate impurity energy levels. Unlike most other Mn4+ ion-activated fluoride phosphors, the as-prepared K3ScF6:Mn4+ phosphors demonstrate highly uniform and regular morphologies with shapes transforming from cube to octahedron with increasing Mn4+ ion concentration. Under blue light excitation, the as-prepared K3ScF6:Mn4+ sample exhibits intense sharp-line red fluorescence (the strongest peak located at 631 nm) with high color purity. An excellent recovery in luminescence upon heating and cooling processes implies high stability of K3ScF6:Mn4+. Furthermore, a warm WLED fabricated with blue GaN chips merged with the mixture of K3ScF6:Mn4+ and the well-known commercial YAG:Ce3+ yellow phosphors exhibits wonderful color quality with lower correlated color temperature (3250 K) and higher color-rendering index ( Ra = 86.4). These results suggest that the K3ScF6:Mn4+ phosphor possesses stupendous potentiality for practical applications.