Prevalidation study of the BALB/c 3T3 cell transformation assay for assessment of carcinogenic potential of chemicals.

The cell transformation assays (CTAs) have attracted attention within the field of alternative methods due to their potential to reduce the number of animal experiments in the field of carcinogenicity. The CTA using BALB/c 3T3 cells has proved to be able to respond to chemical carcinogens by inducing morphologically transformed foci. Although a considerable amount of data on the performance of the assay has been collected, a formal evaluation focusing particularly on reproducibility, and a standardised protocol were considered important. Therefore the European Centre for the Validation of Alternative Methods (ECVAM) decided to coordinate a prevalidation study of the BALB/c 3T3 CTA. Three different laboratories from Japan and Europe participated. In the study the following modules were assessed stepwise: test definition (Module 1) consisted of the standardisation of the protocol, the selection of the cell lineage, and the preparation of a photo catalogue on the transformed foci. The within-laboratory reproducibility (Module 2) and the transferability (Module 3) were assessed using non-coded and coded 3-methylcholanthrene. Then, five coded chemicals were tested for the assessment of between-laboratory reproducibility (Module 4). All three laboratories obtained positive results with benzo[a]pyrene, phenanthrene and o-toluidine HCl. 2-Acetylaminofluorene was positive in two laboratories and equivocal in one laboratory. Anthracene was negative in all three laboratories. The chemicals except phenanthrene, which is classified by IARC (http://monographs.iarc.fr) as group 3 "not classifiable as to its carcinogenicity to human", were correctly predicted as carcinogens. Further studies on phenanthrene will clarify this discrepancy. Thus, although only a few chemicals were tested, it can be seen that the predictive capacity of the BALB/c 3T3 CTA is satisfactory. On the basis of the outcome of this study, an improved protocol, incorporating some changes related to data interpretation, has been developed. It is recommended that this protocol be used in the future to provide more data that may confirm the robustness of this protocol and the performance of the assay itself. During the study it became clear that selecting the most appropriate concentrations for the transformation assay is crucial.

Genotoxicity and morphological transformation induced by cobalt nanoparticles and cobalt chloride: an in vitro study in Balb/3T3 mouse fibroblasts.

Nanotechnology is an emerging field that involves the development, manufacture and measurement of materials and systems in the submicron to nanometer range. Its development is expected to have a large socio-economical impact in practically all fields of industrial activity. However, there is still a lack of information about the potential risks of manufactured nanoparticles for the environment and for human health. In this work, we studied the cytotoxicity, genotoxicity and morphological transforming activity of cobalt nanoparticles (Co-nano) and cobalt ions (Co(2+)) in Balb/3T3 cells. We also evaluated Co-nano dissolution in culture medium and cellular uptake of both Co-nano and Co(2+). Our results indicated dose-dependent cytotoxicity, assessed by colony-forming efficiency test, for both compounds. The toxicity was higher for Co-nano than for Co(2) after 2 and 24 h of exposure, while dose-effect relationships were overlapping after 72 h. Statistically significant results were observed for Co-nano with the micronucleus test and the comet assay, while for Co(2+) positive results were observed only with the latter. In addition, even when Co-nano was genotoxic (at >1 microM), no evident dose-dependent effect was observed. Concerning morphological transformation, we found a statistically significant increase in the formation of type III foci (morphologically transformed colonies) only for Co-nano. Furthermore, we observed a higher cellular uptake of Co-nano compared with Co(2+).

Comparison of impedance-based sensors for cell adhesion monitoring and in vitro methods for detecting cytotoxicity induced by chemicals.

The recent European Commission REACH (Registration, Evaluation and Authorisation of Chemicals) policy outlines a plan for toxicological testing by using alternative non-animal in vitro methods. In this context, there is a need to develop and standardise high-throughput screening (HTS) methods for studying the cytotoxicity induced by chemicals. Electrochemical impedance spectroscopy (EIS) can be considered as a complementary technique to alternative in vitro testing for studying cell adhesion to the substrate, and can give real-time and kinetic information on cell responses to a toxicant. This paper describes the development of a home-made chip based on impedance spectroscopy, and its application in studying the kinetics of BALB/3T3 cell adhesion and the cellular responses to a toxic product as a function of time. Concentrations of sodium arsenite, ranging from 10 microM up to 1000 microM, were tested in the system, and the results were compared with those obtained with standard protocols used to study basal cytotoxicity induced by chemicals in the BALB/3T3 cell line. The results show that the sensitivity of the developed chip was better than that with the MTT test, with the additional advantages of online monitoring.