Studies on Surfactants, Cosurfactants, and Oils for Prospective Use in Formulation of Ketorolac Tromethamine Ophthalmic Nanoemulsions.

Nanoemulsions (NE) are isotropic, dispersions of oil, water, surfactant(s) and cosurfactant(s). A range of components (11 surfactants, nine cosurfactants, and five oils) were investigated as potential excipients for preparation of ketorolac tromethamine (KT) ocular nanoemulsion. Diol cosurfactants were investigated for the effect of their carbon chain length and dielectric constant (DEC), Log P, and HLB on saturation solubility of KT. Hen's Egg Test-ChorioAllantoic Membrane (HET-CAM) assay was used to evaluate conjunctival irritation of selected excipients. Of the investigated surfactants, Tween 60 achieved the highest KT solubility (9.89 ± 0.17 mg/mL), followed by Cremophor RH 40 (9.00 ± 0.21 mg/mL); amongst cosurfactants of interest ethylene glycol yielded the highest KT solubility (36.84 ± 0.40 mg/mL), followed by propylene glycol (26.23 ± 0.82 mg/mL). The solubility of KT in cosurfactants was affected by four molecular descriptors: carbon chain length, DEC, log P and HLB. KT solubility was directly proportional to DEC and the HLB yet, inversely proportional to carbon chain length and log P. All surfactants, except Labrasol ALF, were non-irritant. The majority of cosurfactants were slightly irritant, butylene glycol was a moderate irritant, pentylene and hexylene glycols were strong irritants. These findings will inform experiments aimed at developing NE formulations for ocular administration of KT.

Spray-Dried Proliposome Microparticles for High-Performance Aerosol Delivery Using a Monodose Powder Inhaler.

Proliposome formulations containing salbutamol sulphate (SS) were developed using spray drying, and the effects of carrier type (lactose monohydrate (LMH) or mannitol) and lipid to carrier ratio were evaluated. The lipid phase comprised soy phosphatidylcholine (SPC) and cholesterol (1:1), and the ratios of lipid to carrier were 1:2, 1:4, 1:6, 1:8 or 1:10 w/w. X-ray powder diffraction (XRPD) revealed an interaction between the components of the proliposome particles, and scanning electron microscopy (SEM) showed that mannitol-based proliposomes were uniformly sized and spherical, whilst LMH-based proliposomes were irregular and relatively large. Using a two-stage impinger (TSI), fine particle fraction (FPF) values of the proliposomes were higher for mannitol-based formulations, reaching 52.6%, which was attributed to the better flow properties when mannitol was used as carrier. Following hydration of proliposomes, transmission electron microscopy (TEM) demonstrated that vesicles generated from mannitol-based formulations were oligolamellar, whilst LMH-based proliposomes generated 'worm-like' structures and vesicle clusters. Vesicle size decreased upon increasing carrier to lipid ratio, and the zeta potential values were negative. Drug entrapment efficiency (EE) was higher for liposomes generated from LMH-based proliposomes, reaching 37.76% when 1:2 lipid to carrier ratio was used. The in vitro drug release profile was similar for both carriers when 1:6 lipid to carrier ratio was used. This study showed that spray drying can produce inhalable proliposome microparticles that can generate liposomes upon contact with an aqueous phase, and the FPF of proliposomes and the EE offered by liposomes were formulation-dependent.

Studies of the precipitation pattern of paclitaxel in intravenous infusions and rat plasma using laser nephelometry.

Cremophor EL (CrEL) is commonly used to solubilize paclitaxel (Ptx); a widely established anticancer agent used against many types of cancer. Using laser-based microplate nephelometry, in this work we assessed the precipitation kinetics of Ptx in CrEL-containing formulations upon dilutions with different infusion media or upon introduction into rat plasma. The precipitation profile of Ptx was assessed for a Taxol-like formulation and compared with a preparation with reduced CrEL content. These two formulations were diluted at various ratios in compatible infusion media and with or without rat plasma. The percentages of Ptx precipitated in dilution media and protein-binding in plasma were quantified using HPLC. The findings of turbidity measurements were in good agreement with HPLC. Despite the presence of albumin, it was possible to assess turbidity within infusion solutions and predict Ptx precipitation. Upon addition to plasma, no precipitation in Taxol-like formulation occurred after 2 h. In contrast, precipitation occurred immediately in CrEL-reduced formulation. It is possible that the high percentage of protein-bound Ptx in plasma (98.5-99.2%) has inhibited drug precipitation. Turbidity measurements using laser nephelometry can provide a rapid screening tool when developing intravenous formulations for poorly soluble drugs, such as Ptx and assess its stability upon dilution in animal plasma.

A facile approach to manufacturing non-ionic surfactant nanodipsersions using proniosome technology and high-pressure homogenization.

In this study, a niosome nanodispersion was manufactured using high-pressure homogenization following the hydration of proniosomes. Using beclometasone dipropionate (BDP) as a model drug, the characteristics of the homogenized niosomes were compared with vesicles prepared via the conventional approach of probe-sonication. Particle size, zeta potential, and the drug entrapment efficiency were similar for both size reduction mechanisms. However, high-pressure homogenization was much more efficient than sonication in terms of homogenization output rate, avoidance of sample contamination, offering a greater potential for a large-scale manufacturing of noisome nanodispersions. For example, high-pressure homogenization was capable of producing small size niosomes (209 nm) using a short single-step of size reduction (6 min) as compared with the time-consuming process of sonication (237 nm in >18 min) and the BDP entrapment efficiency was 29.65% ± 4.04 and 36.4% ± 2.8. In addition, for homogenization, the output rate of the high-pressure homogenization was 10 ml/min compared with 0.83 ml/min using the sonication protocol. In conclusion, a facile, applicable, and highly efficient approach for preparing niosome nanodispersions has been established using proniosome technology and high-pressure homogenization.