RÉSUMÉ
The efficient recovery of nickel from chloride systems has long presented a challenge in the field. While solvent extraction is a viable approach, conventional extractants have been associated with drawbacks such as a high requirement for chloride ions and substantial consumption of acids and alkalis. In response to these challenges, this investigation developed and synthesized a novel thiazole-based extractant, N, N-Bis(4-thiazolylmethyl)octylamine (NNBT), tailored for the selective extraction of nickel from chloride systems. Findings from the study indicate that the nitrogen atom situated on the benzylamine framework within NNBT can interact synergistically with the chelating thiazole ring, facilitating effective nickel extraction and notably reducing the need for chloride ions. Furthermore, the extractant can be regenerated using deionized water, thereby obviating the necessity for additional consumption of acids and alkalis. Following the validation of NNBT as an environmentally sustainable and efficient nickel extractant within the chloride ion system, it was successfully employed to selectively and effectively extract nickel from the nickel-aluminum slag of spent HDP catalyst. The extracted nickel and aluminum were subsequently processed into electroplated nickel chloride and polyaluminum chloride, respectively, meeting the national standards of China. These outcomes underscore the eco-friendliness and promise of NNBT for nickel extraction from chloride systems.
RÉSUMÉ
The recovery of valuable metals from spent lithium-ion batteries (LIBs) is crucial for environmental protection and resource optimization. In the traditional recovery process of spent LIBs, the leaching of high-valence metals has the problems of high cost and limited reagent utilization, and some valuable metals are lost in the subsequent purification process of the leaching solution. To reduce the cost of reagents, this study proposes the use of low-cost SO2 as a reagent combined with pressure leaching to efficiently recover high-valence metals from delithiated materials of spent LIBs, while selective solvent extraction is used to remove trace impurities in the leaching solution to avoid the loss of valuable metals. Experimental results demonstrated that by optimizing the conditions to 0.25 MPa SO2 partial pressure and 60 min reaction time at 70 °C, the leaching efficiencies for Ni, Co, and Mn reached 99.6%, 99.3%, and 99.6%, respectively. The kinetic study indicated that the leaching process was diffusion-controlled. Furthermore, the delithiated materials were used to completely utilize the residual SO2 in the solution to obtain a high concentration Ni-Co-Mn rich solution. Subsequently, Fe and Al impurities were deeply removed through a synergistic extraction of Di-2-ethylhexyl phosphoric acid (D2EHPA) and tributyl phosphate (TBP) without loss of valuable metals, achieving a high-purity Ni-Co-Mn solution. The process developed based on this work has the characteristics of environmental friendliness, high valuable metal recovery, and high product purity, providing a reference technical method for the synergistic treatment of waste SO2 flue gas with spent LIBs and the deep purification of impurities in spent LIBs.
Sujet(s)
Lithium , Recyclage , Recyclage/méthodes , Métaux , Alimentations électriques , CinétiqueRÉSUMÉ
Objective: Breast cancer is one of the most prevalent cancers in females worldwide and is one of the leading causes of cancer death and disability in women. Multiple therapies have been applied to breast cancer treatment; however, the long-term survival rate remains low. Although cisplatin has been widely utilized for cancer therapy, chemoresistance still influences the outcome. Methods: After collecting the breast cancer cell line MDA-MB-231 treated with or without cisplatin and sample information from The Cancer Genome Atlas Program (TCGA), we screened out their common parameters and influences on the prognoses of patients' potential targets. Surgical excisional tissue sections of patients with breast cancer who were admitted and treated in the Department of Breast and Thyroid Surgery, Liuzhou People's Hospital from 2017 to 2020 was collected and follow up. After a series of assays combined with clinical information, we tested the reliability of the target. Results: We found that a high expression level of ZNF268 in breast cancer cell lines significantly enhances the sensitivity to cisplatin, contrary to the effects of low expression. Furthermore, a significantly worse prognosis was observed in patients with a high expression of ZNF268 after cisplatin chemotherapy. Conclusion: The expression level of ZNF268 in breast cancer patients after cisplatin chemotherapy may become a potential target to predict the chemoresistance of patients to cisplatin. This study provides a novel idea for improving breast cancer treatment and survival rates.
RÉSUMÉ
Tungsten residue waste (TRW), considered an environmental burden due to high content and excessive leaching toxicity of arsenic (As), are also secondary tungsten (W) resources. A novel method for simultaneous extraction of arsenic and tungsten from TRW via alkaline pressure oxidative leaching was proposed. The results show that As in the TRW mainly exists in the form of As coprecipitated with Mn(â ¡) oxides and FeAsS. In addition, As coprecipitated with Mn(â ¡) oxides and W are encapsulated in Fe, Mn oxides. The structure of Fe, Mn oxides with dense surface can be destroyed and the chemically stable arsenopyrite can be efficiently oxidized by oxygen in alkaline solutions. The leaching efficiency of As and S reached 97% and 99% at 80 min, respectively, while that of W reached 82% at 10 min. The leaching rate of As and S is controlled by diffusion with the apparent activation energies of 16.67 kJ/mol and 15.66 kJ/mol, respectively. Compared with TRW, the leaching toxicity of As in the leach residue decreased from 10.2 mg/L to only 0.071 mg/L. The new process suggests new possibilities for removal and recovery of As and W from TRW that will contribute to circular economy and environmental protection.