Analysis of BlaEC family class C beta-lactamase.

Recent years have witnessed an increased prevalence of intrinsic and acquired beta-lactamase-producing bacteria, severely limiting human and veterinary medicine therapeutic options. The present study aimed to design specific oligonucleotides for rapid PCR detection of the cephalosporinase-encoding gene blaEC (BlaEC family class C beta-lactamase). A total of three primers were designed to detect 2281 variants of the blaEC gene and two sets of primer pairs were also tested against DNA from 11 strains. The study indicates that the proposed primers should be able to detect 100% of all described blaEC genes in different bacterial strains and monitor their spread. After comparing the amino acid sequences, a phylogenetic tree was created based on the presence of conserved amino acids and homologous motifs. More than 24 760 mutations in BlaEC enzymes have been identified. The mutations involving 371 amino acid positions and these hotspots can change the structure and activity of the monitored enzymes. We predicted several BlaEC enzymes with a broadened substrate activity against higher-generation cephalosporins.

Long-term changes in Al thin-film extreme ultraviolet filters.

Thin-film Al filters are very popular owing to their high transmittance in the wavelength range of 17-67 nm and low transmittance in the visible and near-UV regions; however, they are prone to oxidation. The amorphous Al2O3 layers on the Al surfaces have much smaller transmittance than the bulk Al material; therefore, they strongly influence the total transmittance of the filter. This paper not only provides the transmittance of very old Al filters but also maps the transmittance development of Al filters over two years since their delivery (in 2016) in an uncontrolled atmosphere.

Calibration of windowless photodiode for extreme ultraviolet pulse energy measurement.

For energy measurement of extreme ultraviolet pulses, no universal commercially available device is available. Therefore, a co-axial setup of a vacuum photodiode was developed and tested. First its unsuccessful calibration at the National Institute of Standards and Technology (USA) is mentioned. Then our own single-wavelength (46.9 nm) calibration procedure is described in detail. It is based on tabulated photoemission efficiency and on measured (1) anode collection efficiency, (2) attenuation of Al filters, and (3) attenuation of measuring cables. Some other relevant attenuating factors are also taken into account.