A hybrid enrichment process combining conjugated polymer extraction and silica gel adsorption for high purity semiconducting single-walled carbon nanotubes (SWCNT).

A novel purification process for the enrichment of sc-SWCNTs that combines selective conjugated polymer extraction (CPE) with selective adsorption using silica gel, termed hybrid-CPE (h-CPE), has been developed, providing a high purity sc-SWCNT material with a significant improvement in process efficiency and yield. Using the h-CPE protocol, a greater than 5 fold improvement in yield can be obtained compared to traditional CPE while obtaining sc-SWCNT with a purity >99.9% as assessed by absorption spectroscopy and Raman mapping. Thin film transistor devices using the h-CPE derived sc-SWCNTs as the semiconductor possess mobility values ranging from 10-30 cm(2) V(-1) s(-1) and current ON/OFF ratio of 10(4)-10(5) for channel lengths between 2.5 and 20 µm.

Enrichment of large-diameter semiconducting SWCNTs by polyfluorene extraction for high network density thin film transistors.

A systematic study on the use of 9,9-dialkylfluorene homopolymers (PFs) for large-diameter semiconducting (sc-) single-walled carbon nanotube (SWCNT) enrichment is the focus of this report. The enrichment is based on a simple three-step extraction process: (1) dispersion of as-produced SWCNTs in a PF solution; (2) centrifugation at a low speed to separate the enriched sc-tubes; (3) filtration to collect the enriched sc-SWCNTs and remove excess polymer. The effect of the extraction conditions on the purity and yield including molecular weight and alkyl side-chain length of the polymers, SWCNT concentration, and polymer/SWCNT ratio have been examined. It was observed that PFs with alkyl chain lengths of C10, C12, C14, and C18, all have an excellent capability to enrich laser-ablation sc-SWCNTs when their molecular weight is larger than ∼10 000 Da. More detailed studies were therefore carried out with the C12 polymer, poly(9,9-di-n-dodecylfluorene), PFDD. It was found that a high polymer/SWCNT ratio leads to an enhanced yield but a reduced sc-purity. A ratio of 0.5-1.0 gives an excellent sc-purity and a yield of 5-10% in a single extraction as assessed by UV-vis-NIR absorption spectra. The yield can also be promoted by multiple extractions while maintaining high sc-purity. Mechanistic experiments involving time-lapse dispersion studies reveal that m-SWCNTs have a lower propensity to be dispersed, yielding a sc-SWCNT enriched material in the supernatant. Dispersion stability studies with partially enriched sc-SWCNT material further reveal that m-SWCNTs : PFDD complexes will re-aggregate faster than sc-SWCNTs : PFDD complexes, providing further sc-SWCNT enrichment. This result confirms that the enrichment was due to the much tighter bundles in raw materials and the more rapid bundling in dispersion of the m-SWCNTs. The sc-purity is also confirmed by Raman spectroscopy and photoluminescence excitation (PLE) mapping. The latter shows that the enriched sc-SWCNT sample has a narrow chirality and diameter distribution dominated by the (10,9) species with d = 1.29 nm. The enriched sc-SWCNTs allow a simple drop-casting method to form a dense nanotube network on SiO2/Si substrates, leading to thin film transistors (TFTs) with an average mobility of 27 cm(2) V(-1) s(-1) and an average on/off current ratio of 1.8 × 10(6) when considering all 25 devices having 25 µm channel length prepared on a single chip. The results presented herein demonstrate how an easily scalable technique provides large-diameter sc-SWCNTs with high purity, further enabling the best TFT performance reported to date for conjugated polymer enriched sc-SWCNTs.

Adsorption and dynamics of long-range interacting fullerenes in a flexible, two-dimensional, nanoporous porphyrin network.

Herein, a detailed investigation of the adsorption and dynamics of C60 and C70 fullerenes hosted in a self-assembled, two-dimensional, nanoporous porphyrin network on a solid Ag surface is presented. Time-resolved scanning tunneling microscopy (STM) studies of these supramolecular systems at the molecular scale reveal distinct host-guest interactions giving rise to a pronounced dissimilar mobility of the two fullerenes within the porphyrin network. Furthermore, long-range coverage-dependent interactions between the all-carbon guests, which clearly affect their mobility and are likely mediated by a complex mechanism involving the Ag substrate and the flexible porphyrin host network, are observed. At increased fullerene coverage, this unprecedented interplay results in the formation of large fullerene chains and islands. By applying a lattice gas model with nearest-neighbor interactions and by evaluating the fullerene-pair distribution functions, the respective coverage-dependent guest-guest interaction energies are estimated.

Triply fused Zn(II)-porphyrin oligomers: synthesis, properties, and supramolecular interactions with single-walled carbon nanotubes (SWNTs).

The photophysical, electrochemical, and self-assembly properties of a novel triply fused Zn(II)-porphyrin trimer were investigated and compared to the properties of a triply fused porphyrin dimer and the analogous monomer. The trimer exhibited significantly red-shifted absorption bands relative to the corresponding monomer and dimer. Electrochemical investigations indicated a clear trend in redox properties amongst the three porphyrin structures, with the lowest oxidation potential and the lowest HOMO-LUMO gap exhibited by the triply fused trimer. This electrochemical behavior is attributed to the extensive pi-electron delocalization in the trimeric structure relative to the monomer and dimer. Additionally, it was found that the trimer forms extremely strong and nearly irreversible supramolecular interactions with single-walled carbon nanotubes (SWNTs), resulting in stable solutions of porphyrin-nanotube complexes in THF. Formation of these complexes required the addition of trifluoroacetic acid (TFA) to the solvent. This allowed the oligomers to make close contact with the nanotubes, enabling the formation of stable supramolecular assemblies. Atomic force microscopy (AFM) was used to observe the supramolecular porphyrin-nanotube complexes and revealed that the porphyrin trimer formed a uniform coating on the SWNTs. Height profiles indicated that nanotube bundles could be exfoliated into either individual tubes or very small bundles by exposure to the porphyrin trimer during sonication.

Noncovalent functionalization and solubilization of carbon nanotubes by using a conjugated Zn-porphyrin polymer.

A highly soluble, conjugated Zn-porphyrin polymer was synthesized and found to strongly interact with the surface of single-walled carbon nanotubes, producing a soluble polymer-nanotube complex. Successful complexation required the addition of trifluoroacetic acid to the solvent (THF). It was found that the complex remained soluble after excess free polymer was removed from solution, and could be centrifuged at high speed with no observable sedimentation. Furthermore, the polymer-nanotube assembly resulted in enhanced planarization and conjugation within the porphyrin polymer, which was manifested in a 127 nm bathochromic shift of the Q-band absorption. Control experiments with the Zn-porphyrin monomer indicated that homogeneous solutions could be prepared by means of sonication, but the monomer-nanotube interactions were significantly weaker, leading to nanotube precipitation within minutes. Atomic force microscopy (AFM) studies indicated that the polymer enables exfoliation of nanotube bundles and is able to "stitch" multiple nanotubes together into a series of long, interconnected strands.

Functionalization of single-walled carbon nanotubes with well-defined polystyrene by "click" coupling.

Covalent functionalization of alkyne-decorated SWNTs with well-defined, azide-terminated polystyrene polymers was accomplished by the Cu(I)-catalyzed [3 + 2] Huisgen cycloaddition. This reaction was found to be extremely efficient in producing organosoluble polymer-nanotube conjugates, even at relatively low reaction temperatures (60 degrees C) and short reaction times (24 h). The reaction was found to be most effective when a CuI catalyst was employed in the presence of 1,8-diazabicyclo[5.4.0]undec-7-ene as an additive. IR spectroscopy was utilized to follow the introduction and consumption of alkyne groups on the SWNTs, and Raman spectroscopy evidenced the conversion of a high proportion of sp(2) carbons to sp(3) hybridization during alkyne introduction. Thermogravimetric analysis indicated that the polymer-functionalized SWNTs consisted of 45% polymer, amounting to approximately one polymer chain for every 200-700 carbons of the nanotubes, depending on polymer molecular weight. Transmission electron microscopy and atomic force microscopy were utilized to image polymer-functionalized SWNTs, showing relatively uniform polymer coatings present on the surface of individual, debundled nanotubes.

Resonant tunnelling through a C(60) molecular junction in a liquid environment.

We present electronic transport measurements through thiolated C(60) molecules in a liquid environment. The molecules were placed within a mechanically controllable break junction using a single anchoring group per molecule. On varying the electrode separation of the C(60)-modified junctions, we observed a peak in the conductance traces. The shape of the curves is strongly influenced by the environment of the junction as shown by measurements in two distinct solvents. In the framework of a simple resonant tunnelling model, we can extract the electronic tunnelling rates governing the transport properties of the junctions.

Generation of fullerenyl cation (EtO)2P+(OH)CH2-C60+ from RC60-H and from RC60-C60R (R = CH2P(O)(OEt)2).

A novel fullerenyl cation (EtO)2P+(OH)CH2-C60+ was generated by simply dissolving the monofunctionalized hydrofullerene RC60-H or singly bonded dimer RC60-C60R (R = CH2P(O)(OEt)2) in oxidizing acids such as H2SO4 and FSO3H. The cation was also formed in CH2Cl2 by one-electron oxidation with aminium radical cation and was used for further functionalization of C60.

Synthesis, X-ray structure, and properties of the singly bonded C60 dimer having diethoxyphosphorylmethyl groups utilizing the chemistry of C60(2-).

[reaction: see text] A singly bonded C60 dimer having a diethoxyphosphorylmethyl group on each C60 cage was obtained by the reaction of C60(2-) dianion with diethyl iodomethylphosphonate followed by the treatment with iodine. The precise structure of the dimer was determined for the first time by X-ray crystallography, and its homolytic dissociation as well as spectroscopic and electrochemical properties were clarified.