ABSTRACT
The wide-open side of an open magnetic resonance imaging (MRI) system allows a patient to easily contact the patient assistant during MRI scans. A wide-open-shaped magnet is highly effective when interventional procedures are necessary. Patient assistants can provide comfort by holding a part of the patient's body. Because current regulations or guidelines are concerned with only patient radio frequency (RF) safety, investigations on the safety of patient assistants exposed to high-magnetic field MRI (up to 1.2 T) are required. In this study, five different poses of patient assistants were numerically simulated at a 1.2 T open MRI system to determine the impact of poses on the RF exposure level. The 10-g averaged specific absorption rate (SAR) levels were analyzed for the poses of each patient assistant wearing gloves. Compared with the patient, up to 29.8% of the patient SAR was observed in the patient assistant. When the patient assistant wore latex gloves, a 63.7% reduction in the 10-g averaged SAR level was observed, which could be a remedy to minimize possible RF hazards. To prevent possible RF hazards during MRI scans, certain clauses regarding the patient assistant's poses or wearing gloves must be added to the existing MRI screening forms.
Subject(s)
Magnetic Resonance Imaging , Radio Waves , Humans , Magnetic Resonance Imaging/methodsABSTRACT
For the wireless power transfer (WPT) system in implantable medical devices (IMDs), human tissue is positioned between the transmitting and receiving coils which are different from general WPT systems. Because this space is where the strongest electromagnetic field (EMF) occurs, it is essential to reduce the EMF at the interspace to reduce human exposure to the EMF. In this paper, an out-of-phase coupled WPT system for IMDs is proposed to reduce human exposure to EMF. Considering the EMF exposure and power transfer efficiency (PTE) of the proposed system, a design procedure for determining the phase difference of each capacitor is analyzed and presented. Based on the equivalent circuit model analysis of the proposed system, the EMF and PTE characteristics of the WPT system depending on the design variables are comprehensively analyzed. The proposed system is compared with conventional systems through simulation and measurements. It is verified that the proposed system can reduce the EMF by 41.05% and increase the PTE by 9.62% compared to the conventional system. In addition, through simulation, human exposure to EMFs is assessed considering the exposure environment and electrical properties of human tissues. As a result, the current density, induced electric field, and specific absorption rate were reduced by 44.10%, 38.90%, and 63.82%, respectively.
Subject(s)
Electric Power Supplies , Electromagnetic Fields , Humans , Wireless Technology , Prostheses and Implants , ElectricityABSTRACT
The concept of a coupling factor was introduced in International Electrotechnical Commission (IEC) 62311 and 62233 to provide a product safety assessment that considers the localized exposure when an electromagnetic field (EMF) source is close to the human body. To calculate the coupling factors between the human body and EMF source, a numerical calculation should be carried out to calculate the internal quantities of the human body models. However, at frequencies below 10 MHz, the computed current density or internal electric field has computational artifacts from segmentation or discretization errors. Specifically, coupling factors are calculated based on the maximum values, which may include computational artifacts due to abnormal peaks. In this study, we propose an improved calculation method to remove computational artifacts by applying the 99.99th percentile in calculating the coupling factors without underestimation. The performance of the proposed method is verified through a comparison based on various human body models with wireless power transfer (WPT) systems and compliance with the reference levels and basic restrictions. The results indicate that the proposed method can provide uniform coupling factors by reducing the computational errors by up to 65.3% compared to a conventional method.
Subject(s)
Electromagnetic Fields , Wireless Technology , Electricity , HumansABSTRACT
Recently, a wireless charging system (WCS) for drones has been extensively studied, although standards for compliance testing of a WCS for drones have yet to be established. In this study, we propose methods for human exposure assessments of a WCS for drones by comprehensively considering the various positions of the system and the postures of human body models. The electromagnetic fields from a WCS are modeled and the internal quantities of the human body models, consisting of current density, internal electric field and specific absorption rate, are calculated. The incident fields around the WCS and the internal quantities are analyzed at 140 kHz, which is the operating frequency of the WCS applied. Results of an exposure assessment based on the confirmed worst-case scenario are presented. In addition, the internal quantities depending on the human body models and the material characteristics of the simplified models are also discussed using four different anatomical and simplified human body models.
Subject(s)
Electromagnetic Fields , Human Body , Electricity , Humans , PostureABSTRACT
This paper aims to implement average head models of Korean males and investigate age-related differences in the brain for exposure from radiation from mobile phones. Four male head models composed of a total of 69 structures were developed through a statistical investigation of the anatomical morphology for the age groups of 6, 9, 15 and 20-24 years in age, which are named KR-6, KR-9, KR-15, and KR-22 herein. Three numerical bar phone models with a dual-band built-in antenna were applied to calculate the specific absorption rate (SAR) in the brain; the body lengths of models M avg and M long have the mean value and upper 5th percentile value of commercial bar phone models, respectively, with an antenna at the bottom, whereas M rev has an antenna on top of the phone body, which is the same as in M avg but rotated 180°. The cheek and tilt positions were employed for SAR simulations. As a result, a higher peak spatial-average SAR (psSAR) was observed in the brain for the child groups of KR-6 and KR-9 than for the adult groups of KR-15 and KR-22. In most configurations, the position-averaged psSAR10 g in the child brain was 62% (M long, 835 MHz), 61% (M avg, 835 MHz), 102% (M long, 1850 MHz), 108% (M avg, 1850 MHz), and 125% (M rev, 1850 MHz) higher than in the adult brain. The higher frequency of 1850 MHz showed a wider difference in the brain psSAR between the child and adult groups owing to the shorter penetration depth. When a long phone with an antenna at the bottom operates at a higher frequency, it significantly reduces the brain exposure.
Subject(s)
Brain/radiation effects , Cell Phone , Head , Radiation Dosage , Radiation Exposure/adverse effects , Adolescent , Adult , Child , Humans , Male , Radio Waves/adverse effects , Republic of Korea , Young AdultABSTRACT
Mobile phones differ in terms of their operating frequency, outer shape, and form and location of the antennae, all of which affect the spatial distributions of their electromagnetic field and the level of electromagnetic absorption in the human head or brain. For this paper, the specific absorption rate (SAR) was calculated for four anatomical head models at different ages using 11 numerical phone models of different shapes and antenna configurations. The 11 models represent phone types accounting for around 86% of the approximately 1400 commercial phone models released into the Korean market since 2002. Seven of the phone models selected have an internal dual-band antenna, and the remaining four possess an external antenna. Each model was intended to generate an average absorption level equivalent to that of the same type of commercial phone model operating at the maximum available output power. The 1 g peak spatial SAR and ipsilateral and contralateral brain-averaged SARs were reported for all 11 phone models. The effects of the phone type, phone position, operating frequency, and age of head models on the brain SAR were comprehensively determined.
Subject(s)
Brain/radiation effects , Cell Phone , Head/radiation effects , Phantoms, Imaging , Radio Waves/adverse effects , Adolescent , Adult , Age Factors , Child , Female , Humans , Male , Models, TheoreticalABSTRACT
In this study, we investigated the electromagnetic dosimetry for smart-watches. At present, the standard for compliance testing of body-mounted and handheld devices specifies the use of a flat phantom to provide conservative estimates of the peak spatial-averaged specific absorption rate (SAR). This means that the estimated SAR using a flat phantom should be higher than the SAR in the exposure part of an anatomical human-body model. To verify this, we numerically calculated the SAR for a flat phantom and compared it with the numerical calculation of the SAR for four anatomical human-body models of different ages. The numerical analysis was performed using the finite difference time domain method (FDTD). The smart-watch models were used in the three antennas: the shorted planar inverted-F antenna (PIFA), loop antenna, and monopole antenna. Numerical smart-watch models were implemented for cellular commutation and wireless local-area network operation at 835, 1850, and 2450 MHz. The peak spatial-averaged SARs of the smart-watch models are calculated for the flat phantom and anatomical human-body model for the wrist-worn and next to mouth positions. The results show that the flat phantom does not provide a consistent conservative SAR estimate. We concluded that the difference in the SAR results between an anatomical human-body model and a flat phantom can be attributed to the different phantom shapes and tissue structures.