Structural factors of benzylated glucopyranans for shear-induced adhesion.

We have prepared benzylated glucopyranans and evaluated the structural effects on the adhesion capacity. It was found that 97%-benzylated (1→2)-glucopyranan exhibited a unique shear-induced adhesion. The effects of structural factors on the adhesion behaviors are discussed through systematic adhesion tests, differential scanning calorimetry, theoretical models, and IR spectroscopy.

Colorimetric microchip assay using our own whole blood collected by a painless needle for home medical care.

We have developed a colorimetric measurement chip that measures triglycerides, total cholesterol, and high-density lipoprotein in 6 µL of whole blood collected with a painless needle. The chip can be used by patients to self-monitor certain health conditions at home. This chip contains a sharp 150 µm diameter stainless steel (SUS) needle that collects blood painlessly. The chip consists of three layers of injection-molded poly(methyl methacrylate) bonded together with two double-sided tapes. Two commercial reagents are used, and the volume ratio of plasma to reagent is doubled from the reagent specification to reduce the optical absorption length (and chip mass) by half. Centrifugal force separates the plasma from the blood, and then weighs out and mixes the plasma and reagents. A zigzag channel allows mixing of the plasma with the reagents mainly by vortex motion due to the centrifugal force generated at the corners of the channel. The measured values correlated well with conventionally tested values.

Low-voltage electroosmosis pump for stand-alone microfluidics devices.

Two types of low-voltage electroosmosis pumps were developed using microfabrication technology for usage in handy or stand-alone applications of the micrototal analysis systems (micro-TAS) and the lab-on-a-chip. This was done by making a thin (< 1 microm) region in the flow path and by only applying voltages near this thin region using electrodes inserted into the flow path. The inserted electrodes must be free from bubble formation and be gas-tight in order to avoid pressure leakage. For these electrodes, Ag/AgCl or a gel salt bridge was used. For patterning the gel on the chip, a hydrophilic photopolymerization gel and a photolithographic technique were optimized for producing a gel with higher electric conductivity and higher mechanical strength. For high flow rate application, wide (33.2 mm) and thin (400 nm) pumping channels were compacted into a 1 mm x 6 mm area by folding. This pump achieves an 800 Pa static pressure and a flow of 415 nL/min at 10 V. For high-pressure application, a pump was designed with the thin and thick regions in series and positive and negative electrodes were inserted between them alternatively. This pump could increase the pumping pressure without increasing the supply voltage. A pump with 10-stage connections generated a pressure of 25 kPa at 10 V.