ABSTRACT
This study analyzed the stress distributions on zygomatic and dental implants placed in the zygomatic bone, supporting bones, and superstructures under occlusal loads after maxillary reconstruction with obturator prostheses. A total of 12 scenarios of 3-dimensional finite element models were constructed based on computerized tomography scans of a hemimaxillectomy patient. Two obturator prostheses were analyzed for each model. A total force of 600 N was applied from the palatal to buccal bones at an angle of 45°. The maximum and minimum principal stress values for bone and von Mises stress values for dental implants and prostheses were calculated. When zygomatic implants were applied to the defect area, the maximum principal stresses were similar in intensity to the other models; however, the minimum principal stress values were higher than in scenarios without zygomatic implants. In models that used zygomatic implants in the defect area, von Mises stress levels were significantly higher in zygomatic implants than in dental implants. In scenarios where the prosthesis was supported by tissue in the nondefect area, the maximum and minimum principal stress values on cortical bone were higher than in scenarios where implants were applied to defect and nondefect areas. In patients who lack an alveolar crest after maxillectomy, a custom bar-retained prosthesis placed on the dental implant should reduce stress on the zygomatic bone. The stress was higher on zygomatic implants without alveolar crest support than on dental implants.
Subject(s)
Dental Implants , Finite Element Analysis , Maxilla , Palatal Obturators , Zygoma , Humans , Zygoma/surgery , Maxilla/surgery , Imaging, Three-Dimensional , Dental Stress Analysis , Bite Force , Biomechanical Phenomena , Computer Simulation , Stress, Mechanical , Cortical Bone , Tomography, X-Ray Computed , Dental Implantation, Endosseous/methods , Dental Prosthesis, Implant-SupportedABSTRACT
PURPOSE: This study analyzed the stress distributions on zygomatic and dental implants placed in the zygomatic bone, supporting bones, and superstructures under occlusal loads after maxillary reconstruction with obturator prostheses. MATERIALS AND METHODS: 12 scenarios of three-dimensional finite element models were constructed based on computed tomography scans of a patient who had hemimaxillectomy. Two obturator prostheses were analyzed for each model. A total force of 600 N was applied from the palatal to buccal bones at an angle of 45°. The maximum and minimum principal stress values for bone and also the von Misses stress values for dental implants and prostheses were calculated. RESULTS: When zygomatic implants were applied to the defect area, the maximum principal stresses were similar in intensity to the other models; however, the minimum principal stress values were higher than in scenarios without zygomatic implants. In models that used zygomatic implants in the defect area, von Misses stress levels were significantly higher in zygomatic implants than in dental implants. In scenarios where the prosthesis was supported by tissue in the non-defect area, the maximum and minimum principal stress values on cortical bone were higher than in scenarios where implants were applied to both defect and non-defect areas. CONCLUSIONS: In patients who lack an alveolar crest after maxillectomy, reduced stress on the zygomatic bone is expected if a custom bar-retained prosthesis is placed on the dental implant. The stress was higher on zygomatic implants without alveolar crest support than on dental implants.
ABSTRACT
The aim of this study was to assess the prevalence of denture-related stomatitis (DRS) in different attachment-retained overdenture wearers and its association with particular colonizing Candida species. Thirty-seven edentulous patients with implant-supported maxillary or mandibular overdentures were enrolled. A full clinical history was obtained, including details of patients' oral hygiene practices and the levels of erythema based on Newton's classification scale. Swabs were taken from the palate and investigated mycologically to identify the yeast colonies. Quantitative and qualitative microbiological assessments were performed, which included recording the total numbers of colonies (cfu), their color, and their morphological characteristics. Significant differences were found in cfu values between the attachment and inner surfaces of locator- and bar-retained overdentures (P < .05). Candida albicans was the most common species in both evaluations, being isolated from 81.3% of bar-retained overdentures and 38.1% of locator-retained overdentures. DRS developed in all patients using bar-retained overdentures but in only 71.4% of those using locator-retained overdentures. No statistically significant relationship was found between bar and locator attachments according to smoking habit, overnight removal, or plaque and gingival indices (P > .05).