ABSTRACT
With the rapid development of Carbon Capture, Utilization and Storage (CCUS) technology, it is necessary to explore the feasibility of coal slime as a porous carbon material for CO2 capture. In this paper, scanning electron microscopy (SEM) was used to observe the morphological characteristics of coal slime samples with different metamorphic degrees, and the pore structure of coal slime was explored by low temperature N2 adsorption and low-pressure CO2 adsorption experiments. The pore distribution characteristics were analyzed, and the adsorption law of different metamorphic degrees were summarized through CO2 isothermal adsorption experiments. The results showed that: The specific surface area (SSA) and pore volume (PV) of the mesopores of the coal slime exhibited a U-shaped distribution with coal rank, and are much smaller than that of its micropores. Micropores less than 2 nm are the main adsorption space of coal slime, its PV accounted for 59%, 60%, 71%, and SSA accounted for 92%, 93%, 95%, obviously, which are dominant at all stages. The linear correlation fitting coefficients R2 between the limiting adsorbed amount a of CO2 and the micropores PV and the SSA were up to 0.830 and 0.887, respectively. The coal slime has good adsorption performance for CO2. Based on the Langmuir model to fit the limit adsorption amount, a-value can reach 41.774 cm3 g-1, 32.072 cm3 g-1, 38.457 cm3 g-1 at 303 K with the increase of Rmax. Studying the impact of coal slime on CO2 adsorption performance provides a theoretical basis for the subsequent preparation of energy storage materials and is of great significance for the safe, efficient and economic capture and sequestration of CO2, to alleviate the serious situation of the environment and realizing the dual-carbon goal.