Institutional outbreaks of influenza-like illnesses in the state of São Paulo: an analysis of the epidemiological profile during the COVID-19 pandemic.

OBJECTIVES: This study aimed to spatiotemporally analyze the profile of influenza-like illness (ILI) outbreaks in the state of São Paulo, Brazil, between 2020 and 2022. STUDY DESIGN: This was a cross-sectional retrospective study. METHODS: Outbreaks of ILI with final diagnoses of COVID-19, influenza, or other respiratory viruses (ORVs) recorded between January 2020 and November 2022, obtained from the Notifiable Diseases Information System (SINAN NET) Outbreak module, were analyzed. Kernel density estimates and Getis-Ord Gi∗ statistics were performed to identify spatial clusters. RESULTS: A total of 13,314 ILI outbreaks were identified, involving 130,568 cases and 2649 deaths. Of these, 104,399 (80%) were confirmed as COVID-19, 15,861 (12%) were confirmed as ORV, and 10,308 (8%) were confirmed as influenza. The year 2021 had the highest number of outbreaks and cases. Schools recorded the most outbreaks and cases, followed by long-term care facilities for older adults (LTCs). The highest average number of cases per outbreak and the highest attack rates occurred at social gatherings and prisons. Prisoners were three times more likely to contract COVID-19 during outbreaks than people in other institutions. The highest hospitalization and mortality rates for all virus types occurred in the LTC group. The occurrence and intensity of outbreaks were highly heterogeneous among the different institutions after the introduction of new SARS-CoV-2 variants in the state. CONCLUSIONS: ILI outbreaks were not randomly distributed; they clustered in specific areas. Transmissibility varied among different institutions with different responses to the COVID-19 pandemic. These results can be used as a basis for prioritizing actions and allocating resources during future pandemics.

Hydrodynamic and Performance Evaluation of a Porous Ceramic Membrane Module Used on the Water-Oil Separation Process: An Investigation by CFD.

Wastewater from the oil industry can be considered a dangerous contaminant for the environment and needs to be treated before disposal or re-use. Currently, membrane separation is one of the most used technologies for the treatment of produced water. Therefore, the present work aims to study the process of separating oily water in a module equipped with a ceramic membrane, based on the Eulerian-Eulerian approach and the Shear-Stress Transport (SST k-ω) turbulence model, using the Ansys Fluent® 15.0. The hydrodynamic behavior of the water/oil mixture in the filtration module was evaluated under different conditions of the mass flow rate of the fluid mixture and oil concentration at the entrance, the diameter of the oil particles, and membrane permeability and porosity. It was found that an increase in the feed mass flow rate from 0.5 to 1.5 kg/s significantly influenced transmembrane pressure, that varied from 33.00 to 221.32 kPa. Besides, it was observed that the particle diameter and porosity of the membranes did not influence the performance of the filtration module; it was also verified that increasing the permeability of the membranes, from 3 × 10-15 to 3 × 10-13 m2, caused transmembrane pressure reduction of 22.77%. The greater the average oil concentration at the permeate (from 0.021 to 0.037 kg/m3) and concentrate (from 1.00 to 1.154 kg/m3) outlets, the higher the average flow rate of oil at the permeate outlets. These results showed that the filter separator has good potential for water/oil separation.

A New Design of Tubular Ceramic Membrane Module for Oily Water Treatment: Multiphase Flow Behavior and Performance Evaluation.

Petroleum has been extracted from oil reservoirs using different techniques. This activity is accompanied for a large amount of water and sometimes mixed with gas. This produced water has a high oil concentration and other toxic chemical compounds, thus, it must be treated to be reused or released to environment according to environmental protection regulations. Currently, ceramic membrane technology has been employed in the wastewater treatment, due to its high benefit-cost ratio. In this sense, this work aims to study the oil-water mixture separation process using a new configuration of tubular ceramic membrane module by computational fluid dynamic (ANSYS Fluent software). The proposed model is composed of mass and linear momentum conservation equations coupled to Darcy's law and SST k-ω turbulence model. Results of the volumetric fraction, pressure, and velocity distribution of the oil and water phases are presented and discussed. The results indicated that the proposed model and new device both have great potential to be used on the water/oil separation process and that the transmembrane pressure remains constant in the axial direction and decreases radially through the membranes, indicating an efficient system that favors the transport of clean water and oil retention.

Impact of Permeable Membrane on the Hydrocyclone Separation Performance for Oily Water Treatment.

In the oil industry and academy, the treatment of water contaminated with oil using conventional hydrocyclones and membranes has been an alternative to meet the requirements established by environmental control agencies. However, such equipment is not fully efficient in the treatment of much diluted oily water, with both presenting restrictions in their performance. In this sense, the present work proposes to study the separation process of oily water using a new configuration of hydrocyclone, equipped with a porous ceramic membrane in the conical part's wall (filtering hydrocyclone). For the theoretical study, a Eulerian-Eulerian approach was applied to solve the mass and momentum conservation equations, and the turbulence model, using the computational fluid dynamics technique. The results of the velocity, pressure and volumetric fraction of the involved phases, and the separation performance of the hydrocyclone, are presented, analyzed, and compared with those obtained with a conventional hydrocyclone. The results confirmed the high potential of the proposed equipment to be used in the separation of the water and oil mixture.

A naturalistic study of high-dose unilateral ECT among severely depressed inpatients: how does it work in the clinical practice?

BACKGROUND: Naturalistic studies can be useful tools to understand how an intervention works in the real clinical practice. This study aims to investigate the outcomes in a naturalistically treated depressed inpatients cohort, who were referred, or not, to unilateral ECT. METHODS: Depressed adults according to MINI admitted in a psychiatric unit were divided in unilateral ECT treated and non-ECT treated. Main outcomes were: depression improvement in Hamilton Rating Scale for Depression (HDRS-17) scores; response (HDRS-17 improvement ≥50 %); remission (HDRS-17 score ≤7); length of hospitalization. RESULTS: Forty-three patients were included in unilateral ECT group and 104 in non-ECT group. No differences of psychotic symptoms, melancholic features or past maniac episode were found between groups. Unilateral ECT group had a mean HDRS-17 score higher than non-ECT group at admission (ECT: 25.05 ± 1.03; non-ECT: 21.61 ± 0.69; p = 0.001), but no significant difference was found at discharge (ECT: 7.70 ± 0.81; non-ECT: 7.40 ± 0.51; p = 0.75). Unilateral ECT group had a larger HDRS-17 score reduction during treatment (ECT: 18.24 ± 1.18; non-ECT:14.20 ± 0.76; p = 0.004). There were no significant differences in response and remission rates between groups. Unilateral ECT group had longer mean duration of hospitalization in days (ECT: 35.48 ± 2.48; non-ECT: 24.57 ± 1.50; p < 0.001), but there were no difference in mean time of treatment (ECT group:27.66 ± 1.95; non-ECT: 24.57 ± 1.50; p = 0.25). CONCLUSIONS: Unilateral high-dose ECT is still a useful treatment option, in the real world clinical practice, to reduce the intensity of depressive symptoms in highly depressed inpatients.