ABSTRACT
We have used pulsed field gradient (PFG)-NMR diffusion experiments, also known as DOSY, in combination with small angle X-ray scattering measurements to investigate structure and molecular exchange dynamics between pharmaceutical lipid nanoparticles and the bulk phase. Using liposomes and lipoplexes formed after complexation of the liposomes with messenger mRNA as test systems, information on dynamics of encapsulated water molecules, lipids and excipients was obtained. The encapsulated fraction, having a diffusivity similar to that of the liposomes, could be clearly identified and quantified by the NMR diffusion measurements. The unilamellar liposome membranes allowed a fast exchange of water molecules, while sucrose, used as an osmolyte and model solute, showed very slow exchange. Upon interactions with mRNA a topological transition from a vesicular to a lamellar organization took place, where the mRNA was inserted in repeating lipid bilayer stacks. In the lipoplexes, a small fraction of tightly bound water molecules was present, with a diffusivity that was influenced by the additional presence of sucrose. This extended information on dynamic coherencies inside pharmaceutical nanoparticle products, provided by the combined application of SAXS and PFG-NMR diffusion measurements, can be valuable for evaluation of quality and comparability of nanoscaled pharmaceuticals.
Subject(s)
Liposomes , Magnetic Resonance Spectroscopy , Nanoparticles , RNA, Messenger , Scattering, Small Angle , X-Ray Diffraction , Nanoparticles/chemistry , Magnetic Resonance Spectroscopy/methods , Diffusion , Kinetics , X-Ray Diffraction/methods , Sucrose/chemistry , Lipids/chemistry , Water/chemistry , Excipients/chemistry , Lipid Bilayers/chemistryABSTRACT
The phase transition behavior of differently crosslinked poly(N-isopropylacrylamide)/N,N'-methylenebisacrylamide (PNiPAM/BIS) microgels with varying crosslinker content is investigated in presence of aromatic additives. The influence of meta-hydroxybenzaldehyde (m-HBA) and 2,4-dihydroxybenzaldehyde (2,4-DHBA), chosen as model drugs, on the volume phase transition temperature (VPTT) is analyzed by dynamic light scattering (DLS), differential scanning calorimetry (DSC), and 1H-NMR, monitoring and comparing the structural, calorimetric, and dynamic phase transition, respectively. Generally, the VPTT is found to increase with crosslinker content, accompanied by a drastic decrease of transition enthalpy. The presence of an additive generally decreases the VPTT, but with distinct differences concerning the crosslinker content. While the structural transition is most affected at lowest crosslinker content, the calorimetric and dynamic transitions are most affected for an intermediate crosslinker content. Additive uptake of the collapsed gel is largest for low crosslinked microgels and in case of large additive-induced temperature shifts. Furthermore, as temperature is successively raised, 1H NMR data, aided by spin relaxation rates, reveal an interesting uptake behavior, as the microgels act in a sponge-like fashion including a large initial uptake and a squeeze-out phase above VPTT.
ABSTRACT
Redispersing block copolymer (BCP) bulk films in selective solvents is a simple and efficient method to prepare BCP micelles and polymersomes. While ABC triblock terpolymers are known to form multicompartment micelles (MCMs) with intricate nanoarchitecture, this is typically done by solvent exchange instead of redispersion of bulk films despite obvious advantages of greatly reduced solvent usage. Here, we provide guidelines on how to form MCMs with defined shapes and inner structure through direct redispersion of terpolymer bulk morphologies in selective plasticizing solvents. For this purpose, we redisperse a series of polystyrene-b-polybutadiene-b-poly(tert-butyl methacrylate) (PS-b-PB-b-PT) triblock terpolymers in acetone/isopropanol mixtures, where PT is always soluble, PB always insoluble, and PS will range from soft (high acetone content) to kinetically frozen (high isopropanol content). We investigate the effect of solvent mixtures, block composition, and thermal annealing on MCM shape and core morphology. Additionally, we performed terpolymer blend experiments to open up a simple route to further diversify the range of accessible MCM morphologies.
ABSTRACT
Hydroxypropyl cellulose (HPC) and arylazopyrazole (AAP) mixtures can be remotely controlled by light and temperature. We show that the hydrophobic interactions between HPC polymers with AAP surfactants can be drastically changed by changing the surfactants configuration through E/Z photo-isomerization. E-AAP interacts strongly with HPC which causes a dramatic increase of the critical temperature Tc of the polymers' phase transition and a loss of the coil-to-globule transition, while the hydrophobic interactions of HPC with Z-AAP are drastically reduced. As a result, E/Z photo-isomerization of AAP in mixtures with HPC offers remote control of the polymers phase transition, size and solution viscosity in an unprecedented way, and allows for new directions in colloid science.