Investigation of Interferences of Wearable Sensors with Plant Growth.

Plant wearable sensors have shown exceptional promise in continuously monitoring plant health. However, the potential adverse effects of these sensors on plant growth remain unclear. This study systematically quantifies wearable sensors' interference with plant growth using two ornamental species, Peperomia tetraphylla and Epipremnum aureum. We evaluated the impacts of four common disturbances-mechanical pressure, hindrance of gas exchange, hindrance of light acquisition, and mechanical constraint-on leaf growth. Our results indicated that the combination of light hindrance and mechanical constraint demonstrated the most significant interference. When the sensor weight was no greater than 0.6 g and the coverage was no greater than 5% of the leaf area, these four disturbances resulted in slight impacts on leaf growth. Additionally, we fabricated a minimally interfering wearable sensor capable of measuring the air temperature of the microclimate of the plant while maintaining plant growth. This research provides valuable insights into optimizing plant wearable sensors, balancing functionality with minimal plant interference.

Origami-inspired highly stretchable and breathable 3D wearable sensors for in-situ and online monitoring of plant growth and microclimate.

The emerging wearable plant sensors demonstrate the capability of in-situ measurement of physiological and micro-environmental information of plants. However, the stretchability and breathability of current wearable plant sensors are restricted mainly due to their 2D planar structures, which interfere with plant growth and development. Here, origami-inspired 3D wearable sensors have been developed for plant growth and microclimate monitoring. Unlike 2D counterparts, the 3D sensors demonstrate theoretically infinitely high stretchability and breathability derived from the structure rather than the material. They are adjusted to 100% and 111.55 mg cm-2·h-1 in the optimized design. In addition to stretchability and breathability, the structural parameters are also used to control the strain distribution of the 3D sensors to enhance sensitivity and minimize interference. After integrating with corresponding sensing materials, electrodes, data acquisition and transmission circuits, and a mobile App, a miniaturized sensing system is produced with the capability of in-situ and online monitoring of plant elongation and microclimate. As a demonstration, the 3D sensors are worn on pumpkin leaves, which can accurately monitor the leaf elongation and microclimate with negligible hindrance to plant growth. Finally, the effects of the microclimate on the plant growth is resolved by analyzing the monitored data. This study would significantly promote the development of wearable plant sensors and their applications in the fields of plant phenomics, plant-environment interface, and smart agriculture.