ABSTRACT
Burkina, a traditional fermented dairy product, is consumed in most parts of West Africa, including Ghana. Studies on the microflora of Burkina have indicated the presence of Escherichia coli and other pathogenic organisms. Thus, predicting the survival of E. coli in the product will inform the best manufacturing and handling practices. This study investigated the combined effect of storage temperature and time on the survival of acid-adapted and acid-non-adapted E. coli O157:H7 in Burkina. Samples were pasteurised and inoculated with acid-adapted or acid-non-adapted E. coli O157:H7. They were stored at 5, 15, and 30°C for 0, 2, 4, 6, 8, 10, 12, 14, 18, and 48 h, and the bacteria colonies were enumerated. Growth rate (survival versus time) models were developed using MATLAB software. Observed data were fitted to the Baranyi model using the DMFit curve fitting software. The E. coli O157:H7 strain appeared inherently tolerant to acid, with storage time having the most significant effect on the response parameter, survival (log CFU/mL). A negative correlation was observed for the primary models (survival versus time), which accounted for 79-97% of the relationship (p < 0.05). Although E. coli survived, its growth was inhibited over time regardless of acid adaptation.
ABSTRACT
Iron and zinc deficiencies cause high health risk to young children and expectant mothers in sub Saharan Africa. The development of biofortified common bean (Phaseolus vulgaris L.) varieties could address the acute micronutrient deficiencies with associated improvement in the nutrition and health of women, children and adults. The objective of this study was to determine the mode of gene action and genetic advance in iron and zinc levels in common bean. Field experiment was carried out using six generations of two populations made of crosses between pairs of low iron, low zinc and high iron, moderate zinc genotypes (Cal 96 ˣ RWR 2154; MCR-ISD-672 ˣ RWR 2154). Each generation (P1, P2, F1, F2, BC1P1 and BC1P2) was evaluated on the field in a randomized complete block design with three replications. Generation mean analysis were performed for each trait measured in each of the crosses while iron and zinc levels were quantified by x-ray fluorescence. The study showed that both additive and non-additive gene effects were important in determining the expression of high iron and zinc levels. Iron concentration in the common bean seeds ranged from 60.68 to 101.66 ppm while zinc levels ranged from 25.87 to 34.04 ppm. Broad sense heritability estimates of iron and zinc were high in the two crosses (62-82% for Fe and 60-74% for Zn) while narrow sense heritability ranged from low to high (53-75% for Fe and 21-46% for Zn). Heritability and genetic gain were used as selection criteria for iron and zinc, and it was concluded that doing so would be beneficial for future improvement.
ABSTRACT
Forty common bean accessions of multiple genetic background trait attribution regarding drought tolerance were selected based on mean yield performance from an earlier field test evaluation conducted using augmented RCBD. The various bean genotypes were further evaluated with phosphorus and water treatment interactions at two different levels for each factor. The experiment was conducted in a 2 × 2 × 40 factorial using RCBD with three replications under screen-house conditions at the CSIR-Crops Research Institute, Kumasi-Ghana. The objective was to select drought- and low phosphorus-tolerant common bean genotypes; which are suitable for tropical climatic conditions. The results showed that common bean with drought and heat trait tolerance survived, developed flowers and podded with seeds to physiological maturity, whilst genotypes with no heat trait tolerance had impaired reproductive structural development and growth disruption; thus, flowers could not develop into pods with seeds. This reproductive developmental anomaly was due to prevailing average daytime and nighttime high temperatures of 35.45 °C and 29.95 °C, respectively, recorded during the growth period, which reduced pollen fertility. Among the 478 experimental bean plants (two plants were missing) analyzed, 141 (29.5%) did not flower, 168 (35.18%) had their pods dropped whilst 99 (20.7%) podded with seeds to achieve physiological maturity. The podded-seed bean genotypes were of the SEF-line pedigrees, which were shown to be heat and drought-tolerant. Meanwhile, bean accessions with SMC, SMN and SMR code prefixes did not pod into seed despite possessing drought-tolerant traits. The effects of interactions between phosphorus and water treatments on the root characteristics of drought-tolerant common bean were as follows: root length, root surface area, average root diameter and root volume growth extensions doubled dimensionally under optimum conditions (P2W2) compared to stressed conditions (P1W1). The results from the present study identified four SEF-bean genotypes, namely, SEF15, SEF 47, SEF 60 and SEF 62, as superior yield performers, even under low soil phosphorus and in extreme high temperature conditions. Therefore, breeding for the selection of drought- and low-P-tolerant common bean for tropical agro-ecological environments must also consider concomitant heat stress tolerance.
ABSTRACT
BACKGROUND: Soil application of biochar and straw alone or their combinations with nitrogen (N) fertilizer are becoming increasingly common, but little is known about their agronomic and environmental performance in semiarid environments. This study was conducted to investigate the effect(s) of these amendments on soil properties, nitrous oxide (N2O) and methane (CH4) emissions and grain and biomass yield of spring wheat (Triticum aestivum L.), and to produce background dataset that may be used to inform nutrient management guidelines for semiarid environments. METHODS: The experiment involved the application of biochar, straw or urea (46% nitrogen [N]) alone or their combinations. The treatments were: CN0-control (zero-amendment), CN50 -50 kg ha-1 N, CN100-100 kg ha-1 N, BN0 -15 t ha-1 biochar, BN50-15 t ha-1 biochar + 50 kg ha-1 N, BN100-15 t ha-1 biochar + 100 kg ha-1 N, SN0 -4.5 t ha-1 straw, SN50 -4.5 t ha-1 straw + 50 kg ha-1 N and SN100-4.5 t ha-1 straw + 100 kg ha-1 N. Fluxes of N2O, CH4 and grain yield were monitored over three consecutive cropping seasons between 2014 and 2016 using the static chamber-gas chromatography method. RESULTS: On average, BN100reported the highest grain yield (2054 kg ha-1), which was between 25.04% and 38.34% higher than all other treatments. In addition, biomass yield was much higher under biochar treated plots relative to the other treatments. These findings are supported by the increased in soil organic C by 17.14% and 21.65% in biochar amended soils (at 0-10 cm) compared to straw treated soils and soils without carbon respectively. The BN100treatment also improved bulk density and hydraulic properties (P < 0.05), which supported the above results. The greatest N2O emissions and CH4 sink were recorded under the highest rate of N fertilization (100 kg N ha-1). Cumulative N2O emissions were 39.02% and 48.23% lower in BN100 compared with CN0 and CN100, respectively. There was also a ≈ 37.53% reduction in CH4 uptake under BN100compared with CN0-control and CN50. The mean cumulative N2O emission from biochar treated soils had a significant decrease of 10.93% and 38.61% compared to straw treated soils and soils without carbon treatment, respectively. However, differences between mean cumulative N2O emission between straw treated soils and soils without carbon were not significant. These results indicate the dependency of crop yield, N2O and CH4 emissions on soil quality and imply that crop productivity could be increased without compromising on environmental quality when biochar is applied in combination with N-fertilizer. The practice of applying biochar with N fertilizer at 100 kg ha-1 N resulted in increases in crop productivity and reduced N2O and CH4soil emissions under dryland cropping systems.
ABSTRACT
Knowledge about fungi diversity following different planting patterns could improve our understanding of soil processes and thus help us to develop sustainable management strategies. The objective of this study was to determine the impact of different furrow-ridge mulching techniques on fungal diversity in rhizosphere soil under continuous cropping system. The investigated treatments were: flat plot without mulch (CK); flat plot with mulch (T1); on-ridge planting with full mulch (T2); on-furrow planting with full mulch (T3); on-ridge planting with half mulch (T4); and on-furrow planting with half mulch (T5). NGS (Illumina) methods and ITS1 sequences were used in monitoring fungi diversity of the potato rhizosphere soil. The fungi diversity in the rhizosphere soil was ranked in the order T5 > T2 > T4 > T1 > CK at the early growth stage and T2 > T3 > T1 > T4 > CK at the late growth stage of potato. The fungal communities found in the rhizosphere soil were Ascomycota, Zygomycota, Basidiomycota, Chytridiomycota, and other unidentified fungal communities. Among the fungal community in the rhizosphere soil, Ascomycota was found to be dominant fungi population, with the highest percentage (89%) in the T5 soil whereas the T2 soils had the lowest percentage (67%). The Fusarium abundance in fully-mulched treated soils was higher than in half-mulched treated soil. The dominant genus in the T4 soil was Mortierella, whereas lower populations (1-2%) of Scutellinia, Cryphonectria, Acremonium, and Alternaria were found in that treatment. Among the eumycetes, the dominant fungal class in all treated soils was the Sordariomycetes, which ranged from 57 to 85% in T2 and T5 soils, respectively. The Fusarium percentages in half-mulched treated soils (T4 and T5) were 55 and 28% lower than that of complete mulched treated soils (T2 and T3), respectively. The cluster analysis results showed that, CK, T4, and T5 treated soils and T1, T2, and T3 treated soils had similarities in microbial compositions, respectively. Potato tuber yield was greater under the on-ridge planting with full mulch (T2) treated soil, followed by on-ridge planting with half-mulch (T4) treated soil. The rhizosphere soil under the on-ridge planting with full-mulch (T2) soil had the highest fungal diversity, suggesting that this management was the best environment for fungi, whereas the on-ridge planting with half-mulch (T4) soil had the minimum abundance of Fusarium.
ABSTRACT
This study was conducted to explore the changes in soil microbial populations, enzyme activity, and tuber yield under the rotation sequences of Potato-Common vetch (P-C), Potato-Black medic (P-B) and Potato-Longdong alfalfa (P-L) in a semi-arid area of China. The study also determined the effects of continuous potato cropping (without legumes) on the above mentioned soil properties and yield. The number of bacteria increased significantly (p < 0.05) under P-B rotation by 78%, 85% and 83% in the 2, 4 and 7-year continuous cropping soils, respectively compared to P-C rotation. The highest fungi/bacteria ratio was found in P-C (0.218), followed by P-L (0.184) and then P-B (0.137) rotation over the different cropping years. In the continuous potato cropping soils, the greatest fungi/bacteria ratio was recorded in the 4-year (0.4067) and 7-year (0.4238) cropping soils and these were significantly higher than 1-year (0.3041), 2-year (0.2545) and 3-year (0.3030) cropping soils. Generally, actinomycetes numbers followed the trend P-L>P-C>P-B. The P-L rotation increased aerobic azotobacters in 2-year (by 26% and 18%) and 4-year (40% and 21%) continuous cropping soils compared to P-C and P-B rotation, respectively. Generally, the highest urease and alkaline phosphate activity, respectively, were observed in P-C (55.77 mg g-1) and (27.71 mg g-1), followed by P-B (50.72 mg mg-1) and (25.64 mg g-1) and then P-L (41.61 mg g-1) and (23.26 mg g-1) rotation. Soil urease, alkaline phosphatase and hydrogen peroxidase activities decreased with increasing years of continuous potato cropping. On average, the P-B rotation significantly increased (p <0.05) tuber yield by 19% and 18%, compared to P-C and P-L rotation respectively. P-L rotation also increased potato tuber yield compared to P-C, but the effect was lesser relative to P-B rotation. These results suggest that adopting potato-legume rotation system has the potential to improve soil biology environment, alleviate continuous cropping obstacle and increase potato tuber yield in semi-arid region.
Subject(s)
Crop Production/methods , Medicago sativa/growth & development , Plant Tubers/growth & development , Soil Microbiology , Solanum tuberosum/growth & development , Vicia sativa/growth & development , Actinobacteria/growth & development , Alkaline Phosphatase/metabolism , Azotobacter/growth & development , Fabaceae/growth & development , Soil/chemistry , Urease/metabolismABSTRACT
BACKGROUND: True arterial blood samples are essential in making clinical decisions for respiratory patients. Previous studies using only the Portex Pro-Vent arterial sampler have shown a significant difference between arterial and venous filling times. The goal of this study was to determine whether there is a statistically significant difference between sampler filling times measured at a normal mean arterial pressure among multiple arterial samplers with plungers and to determine whether there is a statistically significant difference in filling times between venous and normal mean arterial pressures for a sampler without a plunger. METHODS: We assembled an extracorporeal laboratory model to circulate a synthetic compound composed of 0.9% sodium chloride solution and Life/form artificial blood, and we used hemostats to create pressures within the circuit. We randomly selected samplers and measured the filling times of 4 arterial samplers with plungers at a normal mean arterial pressure (93 ± 1 mm Hg). We also measured the filling time of one arterial sampler without a plunger at a normal mean arterial pressure and at a simulated venous pressure (9 ± 2 mm Hg). We used the Kruskal-Wallis one-way analysis of variance to compare arterial filling times in samplers, and we used a t test for independent samples to compare venous and arterial filling times in the sampler without a plunger. RESULTS: There was a statistically significant difference between sampler filling times among the 4 arterial samplers with a plunger (P < .001). There was a statistically significant difference between arterial and venous pressure filling times for the sampler without a plunger (P < .001). CONCLUSIONS: Although there was a statistically significant difference between arterial filling times among various samplers with plungers, the difference was < 1 s and was not deemed clinically important. Regardless of the sampler brand being used, respiratory therapists and other clinicians performing arterial punctures can use sampler filling time to identify a successful arterial puncture while drawing blood.