Comparative Evaluation of Flexural Toughness of Steel Fiber-Reinforced Concrete Beams.

Specifications are available to quantify flexural performance of steel-fiber reinforced concrete beams with several parameters. Each specification provides different results. This study comparatively evaluates existing flexural beam test standards that are used to evaluate the flexural toughness of SFRC beam specimens. Two standards, EN-14651 and ASTM C1609, were followed to test SFRC beams under the three-point bending test (3PBT) and the four-point bending test (4PBT), respectively. Both normal tensile strength steel fiber (1200 MPa) and high tensile strength steel fiber (1500 MPa) in high-strength concrete were considered in this study. The reference parameters recommended in the two standards, which include equivalent flexural strength, residual strength, energy absorption capacity, and flexural toughness, were compared based on the tensile strength (normal or high) of the steel fiber in high-strength concrete. The 3PBT and 4PBT results indicate that both standard test methods yield similar results to quantify the flexural performance of SFRC specimens. However, unintended failure modes were observed for both standard test methods. The adopted correlation model shows that the flexural performance of SFRC is similar for 3PBTs and 4PBTs, but the residual strength obtained from the 3PBTs tends to be greater than that obtained from 4PBTs with an increase in the tensile strength of steel fiber.

Internal Relative Humidity, Autogenous Shrinkage, and Strength of Cement Mortar Modified with Superabsorbent Polymers.

Laboratory evaluations were performed to investigate the effect of internal curing (IC) by superabsorbent polymers (SAP) on the internal relative humidity (IRH), autogenous shrinkage, coefficient of thermal expansion (CTE), and strength characteristics of low water-cement ratio (w/c) mortars. Four types of SAP with different cross-linking densities and particle sizes were used. Test results showed that the SAP inclusion effectively mitigated the IRH drops due to self-desiccation and corresponding autogenous shrinkage, and the IC effectiveness tended to increase with an increased SAP dosage. The greater the cross-linking density and particle size of SAP, the less the IRH drop and autogenous shrinkage. The trend of autogenous shrinkage developments was in good agreement with that of IRH changes, with nearly linear relationships between them. Both immediate deformation (ID)-based and full response-based CTEs were rarely affected by SAP inclusions. There were no substantial losses in compressive and flexural strengths of SAP-modified mortar compared to reference plain mortar. The findings revealed that SAPs can be effectively used to reduce the shrinkage cracking potential of low w/c cement-based materials at early ages, without compromising mechanical and thermal characteristics.