Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 8 de 8
Filtrar
Mais filtros










Base de dados
Intervalo de ano de publicação
1.
J Am Chem Soc ; 141(42): 16997-17005, 2019 Oct 23.
Artigo em Inglês | MEDLINE | ID: mdl-31592655

RESUMO

Upconverting nanoparticles provide valuable benefits as optical probes for bioimaging and Förster resonant energy transfer (FRET) due to their high signal-to-noise ratio, photostability, and biocompatibility; yet, making nanoparticles small yields a significant decay in brightness due to increased surface quenching. Approaches to improve the brightness of UCNPs exist but often require increased nanoparticle size. Here we present a unique core-shell-shell nanoparticle architecture for small (sub-20 nm), bright upconversion with several key features: (1) maximal sensitizer concentration in the core for high near-infrared absorption, (2) efficient energy transfer between core and interior shell for strong emission, and (3) emitter localization near the nanoparticle surface for efficient FRET. This architecture consists of ß-NaYbF4 (core) @NaY0.8-xErxGd0.2F4 (interior shell) @NaY0.8Gd0.2F4 (exterior shell), where sensitizer and emitter ions are partitioned into core and interior shell, respectively. Emitter concentration is varied (x = 1, 2, 5, 10, 20, 50, and 80%) to investigate influence on single particle brightness, upconversion quantum yield, decay lifetimes, and FRET coupling. We compare these seven samples with the field-standard core-shell architecture of ß-NaY0.58Gd0.2Yb0.2Er0.02F4 (core) @NaY0.8Gd0.2F4 (shell), with sensitizer and emitter ions codoped in the core. At a single particle level, the core-shell-shell design was up to 2-fold brighter than the standard core-shell design. Further, by coupling a fluorescent dye to the surface of the two different architectures, we demonstrated up to 8-fold improved emission enhancement with the core-shell-shell compared to the core-shell design. We show how, given proper consideration for emitter concentration, we can design a unique nanoparticle architecture to yield comparable or improved brightness and FRET coupling within a small volume.

2.
ACS Cent Sci ; 5(7): 1211-1222, 2019 Jul 24.
Artigo em Inglês | MEDLINE | ID: mdl-31403071

RESUMO

Upconverting nanoparticles (UCNPs) are promising tools for background-free imaging and sensing. However, their usefulness for in vivo applications depends on their biocompatibility, which we define by their optical performance in biological environments and their toxicity in living organisms. For UCNPs with a ratiometric color response to mechanical stress, consistent emission intensity and color are desired for the particles under nonmechanical stimuli. Here, we test the biocompatibility and mechanosensitivity of α-NaYF4:Yb,Er@NaLuF4 nanoparticles. First, we ligand-strip these particles to render them dispersible in aqueous media. Then, we characterize their mechanosensitivity (∼30% in the red-to-green spectral ratio per GPa), which is nearly 3-fold greater than those coated in oleic acid. We next design a suite of ex vivo and in vivo tests to investigate their structural and optical properties under several biorelevant conditions: over time in various buffers types, as a function of pH, and in vivo along the digestive tract of Caenorhabditis elegans worms. Finally, to ensure that the particles do not perturb biological function in C. elegans, we assess the chronic toxicity of nanoparticle ingestion using a reproductive brood assay. In these ways, we determine that mechanosensitive UCNPs are biocompatible, i.e., optically robust and nontoxic, for use as in vivo sensors to study animal digestion.

3.
Nano Lett ; 19(6): 3878-3885, 2019 06 12.
Artigo em Inglês | MEDLINE | ID: mdl-31056918

RESUMO

The optical efficiency of lanthanide-based upconversion is intricately related to the crystalline host lattice. Different crystal fields interacting with the electron clouds of the lanthanides can significantly affect transition probabilities between the energy levels. Here, we investigate six distinct alkaline-earth rare-earth fluoride host materials (M1- xLn xF2+x, MLnF) for infrared-to-visible upconversion, focusing on nanoparticles of CaYF, CaLuF, SrYF, SrLuF, BaYF, and BaLuF doped with Yb3+ and Er3+. We first synthesize ∼5 nm upconverting cores of each material via a thermal decomposition method. Then we introduce a dropwise hot-injection method to grow optically inert MYF shell layers around the active cores. Five distinct shell thicknesses are considered for each host material, resulting in 36 unique, monodisperse upconverting nanomaterials each with size below ∼15 nm. The upconversion quantum yield (UCQY) is measured for all core/shell nanoparticles as a function of shell thickness and compared with hexagonal (ß-phase) NaGdF4, a traditional upconverting host lattice. While the UCQY of core nanoparticles is below the detection limit (<10-5%), it increases by 4 to 5 orders of magnitude as the shell thickness approaches 4-6 nm. The UCQY values of our cubic MLnF nanoparticles meet or exceed the ß-NaGdF4 reference sample. Across all core/shell samples, SrLuF nanoparticles are the most efficient, with UCQY values of 0.53% at 80 W/cm2 for cubic nanoparticles with ∼11 nm edge length. This efficiency is 5 times higher than our ß-NaGdF4 reference material with comparable core size and shell thickness. Our work demonstrates efficient and bright upconversion in ultrasmall alkaline-earth-based nanoparticles, with applications spanning biological imaging and optical sensing.

4.
Nat Nanotechnol ; 14(5): 420-425, 2019 05.
Artigo em Inglês | MEDLINE | ID: mdl-30833691

RESUMO

Electron microscopy has been instrumental in our understanding of complex biological systems. Although electron microscopy reveals cellular morphology with nanoscale resolution, it does not provide information on the location of different types of proteins. An electron-microscopy-based bioimaging technology capable of localizing individual proteins and resolving protein-protein interactions with respect to cellular ultrastructure would provide important insights into the molecular biology of a cell. Here, we synthesize small lanthanide-doped nanoparticles and measure the absolute photon emission rate of individual nanoparticles resulting from a given electron excitation flux (cathodoluminescence). Our results suggest that the optimization of nanoparticle composition, synthesis protocols and electron imaging conditions can lead to sub-20-nm nanolabels that would enable high signal-to-noise localization of individual biomolecules within a cellular context. In ensemble measurements, these labels exhibit narrow spectra of nine distinct colours, so the imaging of biomolecules in a multicolour electron microscopy modality may be possible.


Assuntos
Corantes Fluorescentes/química , Microscopia Eletrônica de Transmissão , Nanopartículas/química
5.
Nano Lett ; 18(7): 4454-4459, 2018 07 11.
Artigo em Inglês | MEDLINE | ID: mdl-29927609

RESUMO

Lanthanide-doped nanoparticles are an emerging class of optical sensors, exhibiting sharp emission peaks, high signal-to-noise ratio, photostability, and a ratiometric color response to stress. The same centrosymmetric crystal field environment that allows for high mechanosensitivity in the cubic-phase (α), however, contributes to low upconversion quantum yield (UCQY). In this work, we engineer brighter mechanosensitive upconverters using a core-shell geometry. Sub-25 nm α-NaYF4:Yb,Er cores are shelled with an optically inert surface passivation layer of ∼4.5 nm thickness. Using different shell materials, including NaGdF4, NaYF4, and NaLuF4, we study how compressive to tensile strain influences the nanoparticles' imaging and sensing properties. All core-shell nanoparticles exhibit enhanced UCQY, up to 0.14% at 150 W/cm2, which rivals the efficiency of unshelled hexagonal-phase (ß) nanoparticles. Additionally, strain at the core-shell interface can tune mechanosensitivity. In particular, the compressive Gd shell results in the largest color response from yellow-green to orange or, quantitatively, a change in the red to green ratio of 12.2 ± 1.2% per GPa. For all samples, the ratiometric readouts are consistent over three pressure cycles from ambient to 5 GPa. Therefore, heteroepitaxial shelling significantly improves signal brightness without compromising the core's mechano-sensing capabilities and further, promotes core-shell cubic-phase nanoparticles as upcoming in vivo and in situ optical sensors.

6.
Nano Lett ; 18(4): 2689-2695, 2018 04 11.
Artigo em Inglês | MEDLINE | ID: mdl-29589449

RESUMO

We demonstrate a facile method to improve upconversion quantum yields in Yb,Er-based nanoparticles via emission dye-sensitization. Using the commercially available dye ATTO 542, chosen for its high radiative rate and significant spectral overlap with the green emission of Er3+, we decorate the surfaces of sub-25 nm hexagonal-phase Na(Y/Gd/Lu)0.8F4:Yb0.18Er0.02 upconverting nanoparticles with varying dye concentrations. Upconversion photoluminescence and absorption spectroscopy provide experimental confirmation of energy transfer to and emission from the dye molecules. Upconversion quantum yield is observed to increase with dye sensitization, with the highest enhancement measured for the smallest particles investigated (10.9 nm in diameter); specifically, these dye-decorated particles are more than 2× brighter than are unmodified, organic-soluble nanoparticles and more than 10× brighter than are water-soluble nanoparticles. We also observe 3× lifetime reductions with dye adsorption, confirming the quantum yield enhancement to result from the high radiative rate of the dye. The approach detailed in this work is widely implementable, renders the nanoparticles water-soluble, and most significantly improves sub-15 nm nanoparticles, making our method especially attractive for biological imaging applications.

7.
Nano Lett ; 18(2): 669-674, 2018 02 14.
Artigo em Inglês | MEDLINE | ID: mdl-29341615

RESUMO

Metallic nanostructures exhibit a strong plasmon resonance at a wavelength whose value is sensitive to the charge density in the nanostructure, its size, shape, interparticle coupling, and the dielectric properties of its surrounding medium. Here we use UV-visible transmission and reflectance spectroscopy to track the shifts of the plasmon resonance in an array of gold nanoparticles buried under metal-oxide layers of varying thickness produced using atomic layer deposition (ALD) and then coated with bulk layers of one of three metals: aluminum, silver, or gold. A significant shift in the plasmon resonance was observed and a precise value of ωp, the plasmon frequency of the gold comprising the nanoparticles, was determined by modeling the composite of gold nanoparticles and metal-oxide layer as an optically homogeneous film of core-shell particles bounded by two substrates: one of quartz and the other being one of the aforementioned metals, then using a Maxwell-Garnett effective medium expression to extract ωp for the gold nanoparticles before and after coating with the bulk metals. Under illumination, the change in the charge density of the gold nanoparticles per particle determined from the change in the values of ωp is found to be some 50-fold greater than what traditional electrostatic contact electrification models compute based on the work function difference of the two conductive materials. Moreover, when using bulk gold as the capping layer, which should have resulted in a negligible charge exchange between the gold nanoparticles and the bulk gold, a significant charge transfer from the bulk gold layer to the nanoparticles was observed as with the other metals. We explain these observations in terms of the "plasmoelectric effect", recently described by Atwater and co-workers, in which the gold nanoparticles modify their charge density to allow their resonant wavelength to match that of the incident light, thereby achieving, a lower value of the chemical potential due to the entropy increase resulting from the conversion of the plasmon's energy to heat. We conclude that even the act of registering the spectrum of nanoparticles is at times sufficient to alter their charge densities and hence their UV-visible spectra.

8.
J Am Chem Soc ; 138(51): 16800-16808, 2016 12 28.
Artigo em Inglês | MEDLINE | ID: mdl-27982572

RESUMO

Thin films with tunable and homogeneous composition are required for many applications. We report the synthesis and characterization of a new class of compositionally homogeneous thin films that are amorphous solid solutions of Al2O3 and transition metal oxides (TMOx) including VOx, CrOx, MnOx, Fe2O3, CoOx, NiO, CuOx, and ZnO. The synthesis is enabled by the rapid decomposition of molecular transition-metal nitrates TM(NO3)x at low temperature along with precondensed oligomeric Al(OH)x(NO3)3-x cluster species, both of which can be processed from aq solution. The films are dense, ultrasmooth (Rrms < 1 nm, near 0.1 nm in many cases), and atomically mixed amorphous metal-oxide alloys over a large composition range. We assess the chemical principles that favor the formation of amorphous homogeneous films over rougher phase-segregated nanocrystalline films. The synthesis is easily extended to other compositions of transition and main-group metal oxides. To demonstrate versatility, we synthesized amorphous V0.1Cr0.1Mn0.1Fe0.1Zn0.1Al0.5Ox and V0.2Cr0.2Fe0.2Al0.4Ox with Rrms ≈ 0.1 nm and uniform composition. The combination of ideal physical properties (dense, smooth, uniform) and broad composition tunability provides a platform for film synthesis that can be used to study fundamental phenomena when the effects of transition metal cation identity, solid-state concentration of d-electrons or d-states, and/or crystallinity need to be controlled. The new platform has broad potential use in controlling interfacial phenomena such as electron transfer in solar-cell contacts or surface reactivity in heterogeneous catalysis.

SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA