Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 8 de 8
Filtrar
Mais filtros











Base de dados
Intervalo de ano de publicação
1.
J Chem Phys ; 152(4): 044708, 2020 Jan 31.
Artigo em Inglês | MEDLINE | ID: mdl-32007072

RESUMO

Employing molecular photoswitches, we can combine solar energy conversion, storage, and release in an extremely simple single molecule system. In order to release the stored energy as electricity, the photoswitch has to interact with a semiconducting electrode surface. In this work, we explore a solar-energy-storing model system, consisting of a molecular photoswitch anchored to an atomically defined oxide surface in a liquid electrolyte and under potential control. Previously, this model system has been proven to be operational under ultrahigh vacuum (UHV) conditions. We used the tailor-made norbornadiene derivative 2-cyano-3-(4-carboxyphenyl)norbornadiene (CNBD) and characterized its photochemical and electrochemical properties in an organic electrolyte. Next, we assembled a monolayer of CNBD on a well-ordered Co3O4(111) surface by physical vapor deposition in UHV. This model interface was then transferred into the liquid electrolyte and investigated by photoelectrochemical infrared reflection absorption spectroscopy experiments. We demonstrate that the anchored monolayer of CNBD can be converted photochemically to its energy-rich counterpart 2-cyano-3-(4-carboxyphenyl)quadricyclane (CQC) under potential control. However, the reconversion potential of anchored CQC overlaps with the oxidation and decomposition potential of CNBD, which limits the electrochemically triggered reconversion.

2.
Phys Chem Chem Phys ; 21(42): 23364-23374, 2019 Nov 14.
Artigo em Inglês | MEDLINE | ID: mdl-31637373

RESUMO

In this work, we investigated the interaction of phenylphosphonic acid (PPA, C6H5PO3H2) with atomically-defined Co3O4(111) thin films, grown on Ir(100), under ultrahigh vacuum (UHV) conditions and in the electrochemical environment. In the first step, we employed infrared reflection absorption spectroscopy (IRAS) and followed the formation of a saturated monolayer (380 K) in UHV. We observed that the binding motif changes from a chelating tridentate in the sub-monolayer regime to a chelating bidentate at full monolayer coverages. In the electrochemical environment, we analyzed the interaction of PPA with the same Co3O4(111) surface by electrochemical infrared reflection absorption spectroscopy (EC-IRRAS) (0.3 VRHE-1.3 VRHE). When adsorbed at pH 10 from an ammonia buffered aqueous solution, PPA binds to the surface in form of a fully deprotonated chelating bidentate. With increasing electrode potential, we observed two fully reversible processes. At low buffer concentration, protons are released upon oxidation of surface Co2+ ions and lead to protonation of the anchored phosphonates. At high buffer concentration, most of the protons released are accepted by NH3. Simultaneously, the surface phosphonate changes its adsorption motif from bidentate to tridentate while adopting a more upright geometry.

3.
Nat Commun ; 10(1): 2384, 2019 06 03.
Artigo em Inglês | MEDLINE | ID: mdl-31160590

RESUMO

Molecular photoswitches provide an extremely simple solution for solar energy conversion and storage. To convert stored energy to electricity, however, the photoswitch has to be coupled to a semiconducting electrode. In this work, we report on the assembly of an operational solar-energy-storing organic-oxide hybrid interface, which consists of a tailor-made molecular photoswitch and an atomically-defined semiconducting oxide film. The synthesized norbornadiene derivative 2-cyano-3-(4-carboxyphenyl)norbornadiene (CNBD) was anchored to a well-ordered Co3O4(111) surface by physical vapor deposition in ultrahigh vacuum. Using a photochemical infrared reflection absorption spectroscopy experiment, we demonstrate that the anchored CNBD monolayer remains operational, i.e., can be photo-converted to its energy-rich counterpart 2-cyano-3-(4-carboxyphenyl)quadricyclane (CQC). We show that the activation barrier for energy release remains unaffected by the anchoring reaction and the anchored photoswitch can be charged and discharged with high reversibility. Our atomically-defined solar-energy-storing model interface enables detailed studies of energy conversion processes at organic/oxide hybrid interfaces.

4.
Rev Sci Instrum ; 90(2): 024105, 2019 Feb.
Artigo em Inglês | MEDLINE | ID: mdl-30831747

RESUMO

Photochemical in situ studies in a well-controlled surface science environment can help to understand photochemical reactions in organic thin films in more detail. To perform such studies without external focusing or light guiding systems, we designed a high-intensity UV-photon source, which is compatible with an ultra-high vacuum (UHV) environment. The UV source is based on a high power light-emitting diode (LED), soldered onto a copper heat reservoir to avoid overheating. The LED can be placed in close vicinity in front of a single crystal, providing flux densities of 2 × 1018 photons s-1 cm-2 at a wavelength of 365 nm. Thus, the device provides light intensities one order of magnitude higher as compared to conventional continuous wave arc lamps, at only a small variation of the flux of less than ±20% over a sample surface of 10 × 8 mm2. The UV source is mounted in a UHV infrared reflection absorption spectroscopy system and triggered by using the IR spectrometer. This allows fully automatized in situ IR studies of photochemical reactions at interfaces and thin films. We prove the functionality of the device by studying the photochemical conversion of norbornadiene (NBD) to quadricyclane (QC) mediated by the photosensitizer 4,4'-bis(dimethylamino)benzophenone (Michler's ketone, MK). NBD and MK were grown by physical vapor deposition in the form of thin films on Pt(111) at 120 K. Even at prolonged UV irradiation (>100 s), the temperature of the sample increased by less than 10 K. We report first successful conversion of NBD to QC under UHV conditions and follow the conversion behavior as a function of the photon dose and NBD/MK ratio. Initial quantum yields of up to 23% and selectivity for a QC of 70% are obtained at NBD/MK of 7.4:1, indicating good electronic coupling between NBD and MK even in a frozen multilayer. For both very small and very large NBD loadings, the conversion efficiency decreases, which is attributed to the effect of the metallic substrate and phase separation in thick multilayers, respectively.

5.
Rev Sci Instrum ; 89(11): 114101, 2018 Nov.
Artigo em Inglês | MEDLINE | ID: mdl-30501282

RESUMO

Model studies at complex, yet well-defined electrodes can provide a better understanding of electrocatalytic reactions. New experimental devices are required to prepare such model electrocatalysts with atomic-level control. In this work, we discuss the design of a new setup, which enables the preparation of well-defined electrocatalysts in ultra-high vacuum (UHV) using the full portfolio of surface science techniques. The setup allows for direct transfer of samples from UHV and the immersion into the electrolyte without contact to air. As a special feature, the single crystal sample is transferred without any sample holder, which makes the system easily compatible with most electrochemical in situ methods, specifically with electrochemical infrared reflection absorption spectroscopy, but also with other characterization methods such as single-crystal cyclic voltammetry, differential electrochemical mass spectrometry, or electrochemical scanning tunneling microscopy. We demonstrate the preparation in UHV, the transfer in inert atmosphere, and the immersion into the electrolyte for a complex model catalyst that requires surface science methods for preparation. Specifically, we study Pt nanoparticles supported on well-ordered Co3O4(111) films which are grown on an Ir(100) single crystal. In comparison with reference experiments on Pt(111), the model catalyst shows a remarkably different adsorption and reaction behavior during CO electrooxidation in alkaline environments.

6.
Nat Mater ; 17(7): 592-598, 2018 07.
Artigo em Inglês | MEDLINE | ID: mdl-29867166

RESUMO

Electrocatalysis is at the heart of our future transition to a renewable energy system. Most energy storage and conversion technologies for renewables rely on electrocatalytic processes and, with increasing availability of cheap electrical energy from renewables, chemical production will witness electrification in the near future1-3. However, our fundamental understanding of electrocatalysis lags behind the field of classical heterogeneous catalysis that has been the dominating chemical technology for a long time. Here, we describe a new strategy to advance fundamental studies on electrocatalytic materials. We propose to 'electrify' complex oxide-based model catalysts made by surface science methods to explore electrocatalytic reactions in liquid electrolytes. We demonstrate the feasibility of this concept by transferring an atomically defined platinum/cobalt oxide model catalyst into the electrochemical environment while preserving its atomic surface structure. Using this approach, we explore particle size effects and identify hitherto unknown metal-support interactions that stabilize oxidized platinum at the nanoparticle interface. The metal-support interactions open a new synergistic reaction pathway that involves both metallic and oxidized platinum. Our results illustrate the potential of the concept, which makes available a systematic approach to build atomically defined model electrodes for fundamental electrocatalytic studies.

7.
J Phys Chem Lett ; 8(13): 2819-2825, 2017 Jul 06.
Artigo em Inglês | MEDLINE | ID: mdl-28565910

RESUMO

The two valence isomers norbornadiene (NBD) and quadricyclane (QC) enable solar energy storage in a single molecule system. We present a new photoelectrochemical infrared reflection absorption spectroscopy (PEC-IRRAS) experiment, which allows monitoring of the complete energy storage and release cycle by in situ vibrational spectroscopy. Both processes were investigated, the photochemical conversion from NBD to QC using the photosensitizer 4,4'-bis(dimethylamino)benzophenone (Michler's ketone, MK) and the electrochemically triggered cycloreversion from QC to NBD. Photochemical conversion was obtained with characteristic conversion times on the order of 500 ms. All experiments were performed under full potential control in a thin-layer configuration with a Pt(111) working electrode. The vibrational spectra of NBD, QC, and MK were analyzed in the fingerprint region, permitting quantitative analysis of the spectroscopic data. We determined selectivities for both the photochemical conversion and the electrochemical cycloreversion and identified the critical steps that limit the reversibility of the storage cycle.

8.
ChemSusChem ; 9(12): 1424-32, 2016 06 22.
Artigo em Inglês | MEDLINE | ID: mdl-27094340

RESUMO

We have investigated the electrochemically triggered cycloreversion of quadricyclane (QC) to norbornadiene (NBD), a system that holds the potential to combine both energy storage and conversion in a single molecule. Unambiguous voltammetric traces are obtained for pure NBD and pure QC, the latter a strained polycyclic isomer of the former. The difference in redox potentials is smaller than the energy difference between the neutral molecules. This is owing to a significant energy difference between the corresponding radical cations, as demonstrated by density functional theory (DFT) calculations. The vibrational modes of each pure compound are characterized experimentally in the fingerprint region and identified by DFT methods. Thermal and electrochemical transformations of NBD and QC are monitored in situ by IR spectroelectrochemical methods. The kinetics of the cycloreversion of QC to NBD, which is catalyzed by oxidizing equivalents, can be controlled by an applied electrode potential, which implies the ability to adjust in real time the release of thermal power stored in QC.


Assuntos
Hidrocarbonetos Aromáticos com Pontes/química , Norbornanos/química , Temperatura , Eletroquímica , Cinética , Modelos Moleculares , Conformação Molecular , Teoria Quântica
SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA