Characteristics of hydroxyapatite film formed on human enamel with the powder jet deposition technique.

This study aimed to create hydroxyapatite (HAp) film by powder jet deposition with manipulating the blasting nozzle above human enamel and to examine the microstructural and mechanical properties of the HAp film and the bonding strength at the interface between the HAp film and the enamel substrate. HAp particles calcinated at 1200°C with an average size of 4.7 µm were used. The HAp particles were mixed with carrier gas (N2) to form an aerosol flow and was accelerated and blasted from the nozzle onto the enamel substrate at room temperature and atmospheric pressure. To evaluate the microstructure, scanning electron microscope (SEM) images of the surface and cross section of the HAp films and a three-dimensional profile of the HAp films were observed. To evaluate the mechanical properties, the micro-Vickers hardness and the bonding strength of the HAp films to the enamel substrate were measured. The deposition area of the HAp film was over 3 × 4 mm. The average and maximum thickness were about 30 and 40 µm, respectively. No significant difference was observed between the hardness of the HAp film and the enamel (p > 0.05). The bonding strength of the HAp film was the same as the bonding strength between composite resin and enamel. Compared with previous reports, wider and thicker HAp film was created on the enamel substrate successfully. The HAp film, which has same hardness with enamel and same bonding strength to the enamel with composite resin, would be a candidate as dental restorative materials.