Tendon With Z-Lengthening Technique and Construct Assessment: A Biomechanical Study for Use in Tendon Reconstructions.

ABSTRACT

PURPOSE: Tendon reconstruction is frequently required under conditions of tendon deficiency. The authors sought a technique that could obviate the need for tendon harvest yet meet the minimum load of 45 N required for an early active motion protocol. This study was designed to determine the ideal suture construct utilizing the tendon with Z-lengthening (TWZL) technique. METHODS: Sixty fresh-frozen cadaveric flexor digitorum profundus tendons of the index, middle, and ring fingers were randomized into 5 different TWZL construct designs using 3-0 braided polyethylene suture. Constructs were tested on an electromechanical actuator until failure was observed on the load-elongation recording. Data points on maximum yield and load at 8% strain were recorded for each construct. RESULTS: The maximum yield data revealed the construct with a 4-core suture type configuration (construct #4) had the highest overall mean load to failure at 150 N compared with all other constructs. The construct with the highest mean load at 8% strain was that with a 4-core type repair (construct #4) at 59 N. The constructs with Krackow locking sutures (constructs #2, #3, and #4 were found to withstand a significantly higher mean load at 8% strain than those without Krackow sutures (#0 and #1). Comparison among constructs with Krackow locking sutures #2 (56 N), #3 (48 N), and #4 (59 N) did not show a significant difference in mean load at 8% strain. Construct #3, however, had an SD and 95% confidence interval that fell below the 45 N early active motion threshold, whereas both #2 and #4 had 95% confidence intervals that fell no lower than 50 N. CONCLUSIONS: This study provides evidence that the TWZL technique utilizing either construct #2 or #4 could provide sufficient strength and reproducibility for tendon reconstruction. CLINICAL RELEVANCE The study describes the application of the TWZL technique for utilization in tendon reconstruction and quantifies differences in the yield strengths of the 5 proposed constructs.