Altering almond protein function through partial enzymatic hydrolysis for creating gel structures in acidic environment.

ABSTRACT

Protein inadequacy is the major problem for most plant-based dairy yoghurt substitutes. This study investigated three limited degree of hydrolysis (DH 1%, 5%, and 9%) of almond protein and the combined effect of DH and hydrolysed almond protein (HP) to non-hydrolysed almond protein (NP) ratios (HP/NP 4060, 2080, 1090 and 595) on the physicochemical properties of resulting fermentation induced almond-based gel (yoghurt). The gel microstructure, particle size, firmness, pH, water holding capacity (WHC), lubrication, flow, and gelation characteristics were measured and associated with the DH, composition, and SDS-PAGE results. The results show significant differences in gel samples with the same HP/NP (4060) ratio of protein but different protein DH. A higher DH (9%) resulted in samples with lower hardness (6.03 g), viscosity (0.11 Pa s at 50 s-1), cohesiveness (0.63) and higher friction (0.203 at 10 mm/s) compared to sample with 1% DH with higher hardness - 7.34 g, viscosity at 50 s-1 - 0.16 Pa s, cohesiveness - 0.86 and friction at 10 mm/s - 0.194. Comparing samples with the same DH (5%) but different HP/NP ratios showed smaller coarse microgel particles (21.36 µm) and lower hardness (7.17 g), viscosity (0.14 Pa s at 50 s-1) and friction value (0.189 at 10 mm/s) in samples with high HP/NP (4060) compared to sample with low HP/NP (595) that contained significantly large coarse microgel particles (34.61 µm) with the gel being very hard (9.38 g), highly viscous (0.32 Pa s at 50 s-1), and less lubricating (0.220 at 10 mm/s).