Wet Etching of Quartz Using a Solution Based on Organic Solvents and Anhydrous Hydrofluoric Acid.

ABSTRACT

The quartz-crystal resonator is the core device for frequency control in modern communication systems and network technology. At present, in modern resonator blanks manufacturing, BOE solution is usually used as the etching solution, but its etching rate is relatively volatile, and the surface morphology of the blanks is prone to defects after etching, which brings certain difficulties to the deep-etching process of the wafer. To solve the above challenges, this paper systematically compares a BOE solution and anhydrous etching solution in terms of etching rate, surface morphology, and electrical properties of the blanks after etching. Seven groups of blanks were etched using different etching solutions with different etching conditions to verify their effect on the surface morphology and electrical properties of quartz blanks. The experimental results suggest that the application of anhydrous etching solution has achieved better surface morphology and electrical properties and can be more suitable for application in batch manufacturing. In general, when using anhydrous etching solution, it is possible to reduce surface roughness by up to 70% and equivalent resistance by 32%, and the etch rate is almost 10 times lower than BOE solution under the same temperature, which is more conducive to the rate control of wafers in the etching process.