Characterization and chemical fractionation of potentially toxic elements in soils of a pre-mining mineralized area; an evaluation of mobility and environmental risk.

The environmental geochemical characterization of mineralized areas prior to mining does not receive adequate attention. This study shows trace element distribution in soils of two unexploited porphyry copper deposits located in Darreh-Zereshk and Ali-Abad in central Iran. The study was carried out using a compositional data analysis (CoDa) approach and combination of multivariate statistics and clustering techniques, which made it possible to identify the geochemical associations representing the different areas of the mineral deposits. The results of the chemical analyses, performed by ICP-MS, revealed high concentrations of those elements typically associated with porphyry deposits (As, Co, Cu, Mo, Ni, Pb, and Zn). The typical zonal pattern with an anomaly of Cu in central parts of the system and the prevalence of epithermal elements (Ag, Cd, Pb, and Zn) toward the peripheral propylitic alteration zone were recognized. The XRD analysis of selected soil samples allowed us to determine the distribution of elements within the different carrier minerals. Afterward, geochemical speciation patterns were investigated by a four-step sequential extraction procedure based on BCR protocol. The residual fraction consisting of primary resistant minerals was found to be the main host for As (73-93.4%), Cr (65.1-79.6%), Cu (54.3-81.4%), Ni (58.9-80.6%), V (75.9-88%), and Zn (56.5-60.5%) in the studied soils. Even though these elements are not readily leachable, their behavior and distribution could be largely affected by the mining operation and consequent changes in the physicochemical properties of the soil. The soluble-exchangeable phase was only less than 15% of the total extractions for all elements, except for Cd. With respect to the mobility factor (MF), Cd was the most mobile element followed by Sb and Pb. The measured risk assessment code (RAC) presented the following risk order: Cd > Sb > Ni > Co > Pb > Cr > As > Zn > Cu > V. This study reveals that the acquisition of pre-mining geo-environmental data of trace elements is very important to establish pre-mining backgrounds and baselines for evaluating post-mining or post-reclamation geochemical signatures.