The influence of various welding wires on microstructure, and mechanical characteristics of AA7075 Al-alloy welded by TIG process.

ABSTRACT

Owing to their exceptional mechanical properties, the various welding wires used to combine aluminum can meet the needs of many engineering applications that call for components with both good mechanical and lightweight capabilities. This study aims to produce high-quality welds made of AA7075 aluminum alloy using the GTAW technique and various welding wires, such as ER5356, ER4043, and ER4047. The microstructure, macrohardness, and other mechanical characteristics, such as tensile strength and impact toughness, were analyzed experimentally. To check the fracture surface of the AA7075 welded joints, the specimens were examined using optical and scanning electron microscopy (SEM). A close examination of the samples that were welded with ER5356 welding wire revealed a fine grain in the weld zone (WZ). In addition, the WZ of the ER4043 and ER4047 welded samples had a coarse grain structure. Because the hardness values of the welded samples were lower in the WZ than in the base metal (BM) and heat-affected zone (HAZ), the joints filled with ER5356 welding wire provided the highest hardness values compared to other filler metals. Additionally, the ER4047 filler metal yielded the lowest hardness in the weld zone. The welding wire of ER5356 produced the greatest results for ultimate tensile stress, yield stress, welding efficiency, and strain-hardening capacity (Hc), whereas the filler metal of ER4043 produced the highest percentage of elongation. In addition, the ER4047 fracture surface morphology revealed coarser and deeper dimples than the ER5356 fine dimples in the welded joints. Finally, the highest impact toughness was obtained at joints filled with the ER4047 filler metal, whereas the lowest impact toughness was obtained at the BM.