Three-dimensional printing technology in reverse shoulder arthroplasty after resection of proximal humeral tumors / 中华骨科杂志

ABSTRACT

Objective:To analyze the efficacy of the reconstruction of the proximal humerus by reverse shoulder arthroplasty with three-dimensional (3D) printing technology after tumor rescetion.Methods:A retrospective analysis was conducted on the data of eight patients undergoing semi-constrained reverse shoulder arthroplasty with 3D printing technology after the resection of bone tumors in proximal humeri at the Affiliated Wuxi People's Hospital of Nanjing Medical University from December 2017 to January 2021. There were four males and four females with an average age of 55.1 (range, 31-73) years, all of whom had unilateral onset, 2 on the left and 6 on the right. There was one case of leiomyosarcoma (Enneking IIB), two cases of chondrosarcomas (one Enneking IA and one Enneking IB), four cases of Campanacci grade 3 giant cell tumor of bone, and one case of bone metastasis of lung adenocarcinoma. Individualized prosthesis and implantation protocol were completed preoperatively in all patients. The glenoid baseplate was manufactured using 3D printing technology. During the surgery, Malawer type I tumor resection and semi-constrained reverse shoulder arthroplasty were performed, with 6 cases simultaneously using allograft-prosthetic composite reconstruction. The follow-up was scheduled, and the patient received X-ray examination of the shoulder. The range of motion of the shoulder was measured, the Constant-Murley score and musculoskeletal tumor society (MSTS) score were recorded.Results:All 8 patients successfully completed the surgery, with a surgical time of 173.8±46.7 min (range, 130-260 min), intraoperative blood loss of 487.5±334.6 ml (range 200-1,200 ml), and proximal humeral resection of 9.9±4.6 cm (range, 4.5-19.0 cm). All patients were followed up for a period of 45.6±12.5 months (range, 24-60 months). At the last follow-up, the abduction ranges of motion of the affected shoulders increased from 27.5°±14.4° pre-operatively to 106.3°±21.8° post-operatively, with a statistically significant difference ( t=11.37, P<0.001). The forward flexion ranges increased from 28.1°±12.8° pre-operatively to 115.6°±24.0° post-operatively, with a statistically significant difference ( t=11.49, P<0.001). The Constant-Murley score was improved from 40.5±14.3 pre-operatively to 79.3±11.2 post-operatively, with a statistically significant difference ( t=9.58, P<0.001). The MSTS score was 25.6±2.2 (range, 23-28), including 6 excellent cases and 2 good cases. At 2 weeks after surgery, one patient experienced joint dislocation that was successfully reduced manually. Up to the final follow-up, all patients had survived without local tumor recurrence, metastasis, prosthesis infection and loosening. Conclusion:3D printing technology assisted shoulder arthroplasty is helpful for effective reconstruction and shoulder joint function recovery after resection of proximal humeral tumors, with satisfactory outcomes in the early and middle stages.