Morse taper performance: A finite element analysis study
Clinics
; 74: e852, 2019. tab, graf
Artigo
em Inglês
| LILACS
| ID: biblio-989639
Biblioteca responsável:
BR1.1
ABSTRACT
OBJECTIVES:
To evaluate and compare the magnitude and distribution of stresses generated on implants, abutments and first molar metal-ceramic crowns using finite element analysis.METHODS:
Preliminary three-dimensional models were created using the computer-aided design software SolidWorks. Stress and strain values were observed for two distinct virtual models model 1 - Morse taper and solid abutment; model 2 - Morse taper and abutment with screw. A load (250 N) was applied to a single point of the occlusal surface at 15° to the implant long axis. Von Mises stresses were recorded for both groups at four main points 1) abutment-retaining screws; 2) abutment neck; 3) cervical bone area; 4) implant neck. RESULTS ANDCONCLUSION:
Model 1 showed a higher stress value (1477.5 MPa) at the abutment-retaining screw area than the stresses found in model 2 (1091.1 MPa for the same area). The cervical bone strain values did not exceed 105 µm for either model.
Texto completo:
Disponível
Coleções:
Bases de dados internacionais
Base de dados:
LILACS
Assunto principal:
Implantes Dentários
/
Planejamento de Prótese Dentária
/
Análise de Elementos Finitos
/
Análise do Estresse Dentário
/
Projeto do Implante Dentário-Pivô
Limite:
Humanos
Idioma:
Inglês
Revista:
Clinics
Assunto da revista:
Medicina
Ano de publicação:
2019
Tipo de documento:
Artigo
País de afiliação:
Brasil
Instituição/País de afiliação:
Universidade Federal de Uberlandia (UFU)/BR
/
Universidade de Araraquara (UNIARA)/BR
/
Universidade de Passo Fundo/BR