Role of threading dislocations on the growth of HgCdTe epilayers investigated using monochromatic X-ray Bragg diffraction imaging.

High-quality Hg1-xCdxTe (MCT) single crystals are essential for two-dimensional infrared detector arrays. Crystal quality plays an important role on the performance of these devices. Here, the dislocations present at the interface of CdZnTe (CZT) substrates and liquid-phase epitaxy grown MCT epilayers are investigated using X-ray Bragg diffraction imaging (XBDI). The diffraction contributions coming from the threading dislocations (TDs) of the CZT substrate and the MCT epilayers are separated using weak-beam conditions in projection topographs. The results clearly suggest that the lattice parameter of the growing MCT epilayer is, at the growth inception, very close to that of the CZT substrate and gradually departs from the substrate's lattice parameter as the growth advances. Moreover, the relative growth velocity of the MCT epilayer around the TDs is found to be faster by a factor of two to four compared with the matrix. In addition, a fast alternative method to the conventional characterization methods for probing crystals with low dislocation density such as atomic force microscopy and optical interferometry is introduced. A 1.5 mm × 1.5 mm area map of the epilayer defects with sub-micrometre spatial resolution is generated, using section XBDI, by blocking the diffraction contribution of the substrate and scanning the sample spatially.

Large-Scale Defect Clusters with Hexagonal Honeycomb-like Arrangement in Ammonothermal GaN Crystals.

In this paper, we investigate, using X-ray Bragg diffraction imaging and defect selective etching, a new type of extended defect that occurs in ammonothermally grown gallium nitride (GaN) single crystals. This hexagonal "honeycomb" shaped defect is composed of bundles of parallel threading edge dislocations located in the corners of the hexagon. The observed size of the honeycomb ranges from 0.05 mm to 2 mm and is clearly correlated with the number of dislocations located in each of the hexagon's corners: typically ~5 to 200, respectively. These dislocations are either grouped in areas that exhibit "diameters" of 100-250 µm, or they show up as straight long chain alignments of the same size that behave like limited subgrain boundaries. The lattice distortions associated with these hexagonally arranged dislocation bundles are extensively measured on one of these honeycombs using rocking curve imaging, and the ensemble of the results is discussed with the aim of providing clues about the origin of these "honeycombs".

Quantitative comparison between two phase contrast techniques: diffraction enhanced imaging and phase propagation imaging.

Two x-ray phase contrast imaging techniques are compared in a quantitative way for future mammographic applications: diffraction enhanced imaging (DEI) and phase propagation imaging (PPI). DEI involves, downstream of the sample, an analyser crystal acting as an angular filter for x-rays refracted by the sample. PPI simply uses the propagation (Fresnel diffraction) of the monochromatic and partially coherent x-ray beam over large distances. The information given by the two techniques is assessed by theoretical simulations and compared at the level of the experimental results for different kinds of samples (phantoms and real tissues). The imaging parameters such as the energy, the angular position of the analyser crystal in the DEI case or the sample to detector distance in the PPI case were varied in order to optimize the image quality in terms of contrast, visibility and figure of merit.

XTOP: high-resolution X-ray diffraction and imaging.

The latest virtual special issue of Journal of Applied Crystallography includes some highlights of the 12th Conference on High-Resolution X-ray Diffraction and Imaging (XTOP), which took place in Villard-de-Lans and Grenoble in September 2014.

Quantification of the degree of mineralization of bone in three dimensions using synchrotron radiation microtomography.

The availability of three-dimensional measuring techniques coupled to specific image processing methods opens new opportunities for the analysis of bone structure. In particular, synchrotron radiation microtomography may provide three-dimensional images with spatial resolution as high as one micrometer. Moreover, the use of a monoenergetic synchrotron beam, which avoids beam-hardening effects, allows quantitative measurements of the degree of mineralization in bone samples. Indeed, the reconstructed gray levels of tomographic images correspond directly to a map of the linear attenuation coefficient within the sample. Since the absorption depends on the amount of mineral content, we proposed a calibration method to evaluate the three-dimensional distribution of the degree of mineralization within the sample. First a theoretical linear relationship modeling the linear attenuation coefficient as a function of the hydroxyapatite concentrations was derived. Then, an experimental validation on phantoms confirmed both the accuracy of the image processing tools and the experimental setup used. Finally, the analysis of the degree of mineralization in four iliac crest bone biopsy samples was reported. Our method was compared to the reference microradiography technique, currently used for this quantification in two dimensions. The concentration values of the degree of mineralization were found with both techniques in the range 0.5-1.6 g of mineral per cubic centimeter of bone, both in cortical and in trabecular region. The mean difference between the two techniques was around 4.7%, and was slightly higher in trabecular region than in cortical bone.

The Visible Cement Data Set.

With advances in x-ray microtomography, it is now possible to obtain three-dimensional representations of a material's microstructure with a voxel size of less than one micrometer. The Visible Cement Data Set represents a collection of 3-D data sets obtained using the European Synchrotron Radiation Facility in Grenoble, France in September 2000. Most of the images obtained are for hydrating portland cement pastes, with a few data sets representing hydrating Plaster of Paris and a common building brick. All of these data sets are being made available on the Visible Cement Data Set website at http://visiblecement.nist.gov. The website includes the raw 3-D datafiles, a description of the material imaged for each data set, example two-dimensional images and visualizations for each data set, and a collection of C language computer programs that will be of use in processing and analyzing the 3-D microstructural images. This paper provides the details of the experiments performed at the ESRF, the analysis procedures utilized in obtaining the data set files, and a few representative example images for each of the three materials investigated.

Three-dimensional rocking curve imaging to measure the effective distortion in the neighbourhood of a defect within a crystal: an ice example.

Rocking curve imaging (RCI) is a quantitative version of monochromatic beam diffraction topography that involves using a two-dimensional detector, each pixel of which records its own 'local' rocking curve. From these local rocking curves one can reconstruct maps of particularly relevant quantities (e.g. integrated intensity, angular position of the centre of gravity, FWHM). Up to now RCI images have been exploited in the reflection case, giving a quantitative picture of the features present in a several-micrometre-thick subsurface layer. Recently, a three-dimensional Bragg diffraction imaging technique, which combines RCI with 'pinhole' and 'section' diffraction topography in the transmission case, was implemented. It allows three-dimensional images of defects to be obtained and measurement of three-dimensional distortions within a 50 × 50 × 50 µm elementary volume inside the crystal with angular misorientations down to 10-5-10-6 rad. In the present paper, this three-dimensional-RCI (3D-RCI) technique is used to study one of the grains of a three-grained ice polycrystal. The inception of the deformation process is followed by reconstructing virtual slices in the crystal bulk. 3D-RCI capabilities allow the effective distortion in the bulk of the crystal to be investigated, and the predictions of diffraction theories to be checked, well beyond what has been possible up to now.

Phase-contrast X-ray imaging combining free space propagation and Bragg diffraction.

The combination of X-ray 'propagation-based' and 'analyzer-based' phase-contrast imaging with a perfect crystal-analyzer is investigated. The image pattern produced using this 'hybrid' imaging technique presents peculiar features that can be interpreted as a mixture of the two independent phase-contrast signals. A quantitative analysis has been performed in terms of signal-to-noise ratio for the three techniques considered in this paper. Results show that in the 'hybrid imaging' technique this parameter has a weaker dependence on the angular alignment of the crystal analyser with respect to the 'analyser-based' imaging. This pioneering experiment indicates that this hybrid imaging technique might permit simultaneous advantage of the specific features of the two imaging methods to be taken.