A silicon source of frequency-bin entangled photons: publisher's note.

This publisher's note contains corrections to Opt. Lett.47, 6201 (2022)10.1364/OL.471241.

Design and Characterization of 5 µm Pitch InGaAs Photodiodes Using In Situ Doping and Shallow Mesa Architecture for SWIR Sensing.

This paper presents the complete design, fabrication, and characterization of a shallow-mesa photodiode for short-wave infra-red (SWIR) sensing. We characterized and demonstrated photodiodes collecting 1.55 µm photons with a pixel pitch as small as 3 µm. For a 5 µm pixel pitch photodiode, we measured the external quantum efficiency reaching as high as 54%. With substrate removal and an ideal anti-reflective coating, we estimated the internal quantum efficiency as achieving 77% at 1.55 µm. The best measured dark current density reached 5 nA/cm2 at -0.1 V and at 23 °C. The main contributors responsible for this dark current were investigated through the study of its evolution with temperature. We also highlight the importance of passivation with a perimetric contribution analysis and the correlation between MIS capacitance characterization and dark current performance.

SiN half-etch horizontal slot waveguides for integrated photonics: numerical modeling, fabrication, and characterization of passive components.

This work presents a "half-etch" horizontal slot waveguide design based on SiN, where only the upper SiN layer is etched to form a strip that confines the mode laterally. The numerical modeling, fabrication, and characterization of passive waveguiding components are described. This novel slot waveguide structure was designed with on-chip light amplification in mind, for example with an Er-doped oxide spacer layer. Proof-of-concept racetrack resonators were fabricated and characterized, showing quality factors up to 50,000 at critical coupling and residual losses of 4 dB/cm at wavelengths away from the N-H bond absorption peak in SiN, demonstrating the high potential of these horizontal slot waveguides for use in active integrated photonics.

Silicon source of frequency-bin entangled photons.

We demonstrate an integrated source of frequency-entangled photon pairs on a silicon photonics chip. The emitter has a coincidence-to-accidental ratio exceeding 103. We prove entanglement by showing two-photon frequency interference with a visibility of 94.6% ± 1.1%. This result opens the possibility of on-chip integration of frequency-bin sources with modulators and the other active and passive devices available in the silicon photonics platform.

Si microring resonator optical switch based on optical phase shifter with ultrathin-InP/Si hybrid metal-oxide-semiconductor capacitor.

We propose a microring resonator (MRR) optical switch based on III-V/Si hybrid metal-oxide-semiconductor (MOS) optical phase shifter with an ultrathin InP membrane. By reducing the thickness of the InP membrane, we can reduce the insertion loss of the phase shifter, resulting in a high-quality-factor (Q-factor) MRR switch. By optimizing the device structure using numerical analysis, we successfully demonstrated a proof-of-concept MRR optical switch. The optical switch exhibits 0.3 pW power consumption for switching, applicable to power-efficient, thermal-crosstalk-free, Si programmable photonic integrated circuits (PICs) based on wavelength division multiplexing (WDM).

Broadband Fourier-transform silicon nitride spectrometer with wide-area multiaperture input.

Integrated microspectrometers implemented in silicon photonic chips have gathered a great interest for diverse applications such as biological analysis, environmental monitoring, and remote sensing. These applications often demand high spectral resolution, broad operational bandwidth, and large optical throughput. Spatial heterodyne Fourier-transform (SHFT) spectrometers have been proposed to overcome the limited optical throughput of dispersive and speckle-based on-chip spectrometers. However, state-of-the-art SHFT spectrometers in near-infrared achieve large optical throughput only within a narrow operational bandwidth. Here we demonstrate for the first time, to the best of our knowledge, a broadband silicon nitride SHFT spectrometer with the largest light collecting multiaperture input (320×410µm2) ever implemented in an SHFT on-chip spectrometer. The device was fabricated using 248 nm deep-ultraviolet lithography, exhibiting over 13 dB of optical throughput improvement compared to a single-aperture device. The measured resolution varies between 29 and 49 pm within the 1260-1600 nm wavelength range.

Dual-band fiber-chip grating coupler in a 300 mm silicon-on-insulator platform and 193 nm deep-UV lithography.

Surface grating couplers are fundamental building blocks for coupling the light between optical fibers and integrated photonic devices. However, the operational bandwidth of conventional grating couplers is intrinsically limited by their wavelength-dependent radiation angle. The few dual-band grating couplers that have been experimentally demonstrated exhibit low coupling efficiencies and rely on complex fabrication processes. Here we demonstrate for the first time, to the best of our knowledge, the realization of an efficient dual-band grating coupler fabricated using 193 nm deep-ultraviolet lithography for 10 Gbit symmetric passive optical networks. The footprint of the device is 17×10µm2. We measured coupling efficiencies of -4.9 and -5.2dB with a 3-dB bandwidth of 27 and 56 nm at the wavelengths of 1270 and 1577 nm, corresponding to the upstream and downstream channels, respectively.

Frequency-tuning dual-comb spectroscopy using silicon Mach-Zehnder modulators.

Dual-comb spectroscopy using a silicon Mach-Zehnder modulator is reported for the first time. First, the properties of frequency combs generated by silicon modulators are assessed in terms of tunability, coherence, and number of lines. Then, taking advantage of the frequency agility of electro-optical frequency combs, a new technique for fine resolution absorption spectroscopy is proposed, named frequency-tuning dual-comb spectroscopy, which combines dual-comb spectroscopy and frequency spacing tunability to measure optical spectra with detection at a unique RF frequency. As a proof of concept, a 24 GHz optical bandwidth is scanned with a 1 GHz resolution.

Erbium-doped hybrid waveguide amplifiers with net optical gain on a fully industrial 300 mm silicon nitride photonic platform.

Recently, erbium-doped integrated waveguide devices have been extensively studied as a CMOS-compatible and stable solution for optical amplification and lasing on the silicon photonic platform. However, erbium-doped waveguide technology still remains relatively immature when it comes to the production of competitive building blocks for the silicon photonics industry. Therefore, further progress is critical in this field to answer the industry's demand for infrared active materials that are not only CMOS-compatible and efficient, but also inexpensive and scalable in terms of large volume production. In this work, we present a novel and simple fabrication method to form cost-effective erbium-doped waveguide amplifiers on silicon. With a single and straightforward active layer deposition, we convert passive silicon nitride strip waveguide channels on a fully industrial 300 mm photonic platform into active waveguide amplifiers. We show net optical gain over sub-cm long waveguide channels that also include grating couplers and mode transition tapers, ultimately demonstrating tremendous progress in developing cost-effective active building blocks on the silicon photonic platform.

Polarization independent and temperature tolerant AWG based on a silicon nitride platform.

A polarization tolerant optical receiver is a key building block for the development of wavelength division multiplexing based high-speed optical data links. However, the design of a polarization independent demultiplexer is not trivial. In this Letter, we report on the realization of a polarization tolerant arrayed waveguide grating (AWG) on a 300-mm silicon nitride (SiN) photonic platform. By introducing a series of individual polarization rotators in the middle of the waveguide array, the polarization dependence of the AWG has been substantially reduced. Insertion losses below 2.2 dB and a crosstalk level better than -29dB has been obtained for transverse electric and transverse magnetic polarizations on a four-channel coarse AWG. The AWG temperature sensitivity has also been evaluated. Thanks to the low thermo-optical coefficient of SiN, a thermal shift below 12 pm/°C has been demonstrated.