RESUMO
A serious risk that harms the safe use of water and affects aquatic ecosystems is water pollution. This occurs when the water's natural equilibrium is disrupted by an excessive amount of substances, both naturally occurring and as a byproduct of human activities, that have varied degrees of toxicity. Radiation from Cs isotopes, which are common components of radioactive waste and are known for their long half-lives (30 years), which are longer than the natural decay processes, is a major source of contamination. Adsorption is a commonly used technique for reducing this kind of contamination, and zeolite chabazite has been chosen as the best adsorbent for cesium in this particular situation. The purpose of this research is to investigate a composite material based on magnesium phosphate cement (MPC). Magnesium oxide (MgO), potassium dihydrogen phosphate (KH2PO4), and properly selected retarders are used to create the MPC. The optimal conditions for this composite material are investigated through the utilization of X-ray diffraction, scanning electron microscopy, BET surface area analysis, and atomic absorption spectroscopy. The principal aim is to enable innovations in the elimination of radioactive waste-contaminated water using effective cesium removal. The most promising results were obtained by using KH2PO4 as an acid, and MgO as a base, and aiming for an M/P ratio of two or four. Furthermore, we chose zeolite chabazite as a crucial component. The best adsorption abilities for Cs were found at Qads = 106.997 mg/g for S2 and Qads = 122.108 mg/g for S1. As a result, zeolite is an eco-friendly material that is a potential usage option, with many benefits, such as low prices, stability, and ease of regeneration and use.
RESUMO
A high-entropy Fe30Co20Ni20Mn20Al10 (at%) alloy with a face-centered cubic (FCC) crystalline phase was produced through mechanical alloying. This study examined the development of its phases, microstructure, morphology, and magnetic characteristics. Scanning electron microscopy (SEM) was applied to assess the sample morphology in relation to milling times. The changes that the material underwent during milling were investigated using X-ray diffraction. The milling time affected the phase transformation. A single FCC solid solution (crystallite size = 12 nm) was found after 50 h of milling. Additionally, the magnetic characteristics were examined and shown to be associated with microstructural changes. The powder mixture exhibited behavior consistent with soft magnetics, with an Hc value of 8 Am-1 and an Ms value of 165 emu/g. The excellent soft magnetic characteristic may be related to the stability of the FCC phase, which was generated following a 30 h milling process. In addition, the low value of Ms may have originated from the presence of Al atoms in the solid solution and the development of large densities of interfaces and crystal defects.