RESUMO
Two-dimensional polystyrene sphere opals are important materials for nanotechnology applications and fundamental nanoscience research. They are a facile and inexpensive nanofabrication tool, but the quality factor of these opals has drastic differences between reports. Additives like ethanol, ions, and organic molecules in the aqueous particle spreading solution are known to affect the quality factor and growth efficiency of the produced opals. However, a systematic study on the effect and optimization of some of the most effective additives has not been reported until now. Here, we investigate the influence of additives on the growth efficiency and quality factor of such monolayers formed at the air-water interface without the use of a Langmuir-Blodgett trough. The additives induced large variations in the monolayer quality factor and growth efficiency, and we found that the ideal additive content of the spreading agents is 30 wt % < cethanol < 70 wt %, 0 < cH2SO4 < 30.5 mM, and 0 < csty < 255.0 mM. This study provides a guideline for the rational composition and additive content of the spreading solution to obtain high-quality two-dimensional opals for further applications in nanofabrication and photonics and will enable researchers and application engineers to produce standardized nanofabrication materials.
RESUMO
Transparent electrodes are vital for optoelectronic devices, but their development has been constrained by the limitations of existing materials such as indium tin oxide (ITO) and newer alternatives. All face issues of robustness, flexibility, conductivity, and stability in harsh environments. Addressing this challenge, we developed a flexible, low-cost titanium nitride (TiN) nanomesh transparent electrode showcasing exceptional acid-alkali resistance. The TiN nanomesh electrode, created by depositing a TiN coating on a naturally cracked gel film substrate via a sputtering method, maintains a stable electrical performance through thousands of bending cycles. It exhibits outstanding chemical stability, resisting strong acid and alkali corrosion, which is a key hurdle for current electrodes when in contact with acidic/alkaline materials and solvents during device fabrication. This, coupled with superior light transmission and conductivity (88% at 550 nm with a sheet resistance of â¼200 Ω/sq), challenges the reliance on conventional materials. Our TiN nanomesh electrode, successfully applied in electric heaters and electrically controlled thermochromic devices, offers broad potential beyond harsh environment applications. It enables alternative possibilities for the design and fabrication of future optoelectronics for advancements in this pivotal field.
RESUMO
Precipitation-hardening high-entropy alloys (PH-HEAs) with good strength-ductility balances are a promising candidate for advanced structural applications. However, current HEAs emphasize near-equiatomic initial compositions, which limit the increase of intermetallic precipitates that are closely related to the alloy strength. Here we present a strategy to design ultrastrong HEAs with high-content nanoprecipitates by phase separation, which can generate a near-equiatomic matrix in situ while forming strengthening phases, producing a PH-HEA regardless of the initial atomic ratio. Accordingly, we develop a non-equiatomic alloy that utilizes spinodal decomposition to create a low-misfit coherent nanostructure combining a near-equiatomic disordered face-centered-cubic (FCC) matrix with high-content ductile Ni3Al-type ordered nanoprecipitates. We find that this spinodal order-disorder nanostructure contributes to a strength increase of ~1.5 GPa (>560%) relative to the HEA without precipitation, achieving one of the highest tensile strength (1.9 GPa) among all bulk HEAs reported previously while retaining good ductility (>9%).