Effect of NaOCl and ClO2 on seawater desalination using reverse osmosis with cartridge filtration as the pretreatment during the algal bloom.

Increased seawater temperature leads to harmful algal blooms (HABs), which releases toxic materials and extracellular polymeric substances (EPS) that are harmful to both humans and the environment. Reverse osmosis (RO) with cartridge filter (CF) as the pretreatment process is often used for desalination process. However, the EPS causes severe fouling on the CF, and RO membrane. Disinfectants, such as NaOCl and ClO2, are commonly used to remove biofouling, because they can oxidize and kill microorganisms. Therefore, our study aims to utilize NaOCl and ClO2 during the CF-RO process to minimize the algal growth within the system and minimize the fouling induced by EPS. Results from this study show that CF can remove more than 50% of protein and 14% of polysaccharides but is not effective in removing toxins. However, with disinfectants, toxic materials were completely oxidized. Improved removal of EPS with CF improved overall performance. The flux reduction in RO process without disinfection was over 60%, however, the flux decline was about 44% and 10% with NaOCl and ClO2, respectively. Both disinfectants were found to be effective, however use of ClO2 is recommended because it is less damaging the membrane, yet more effective in enhancing the performance.

Non-destructive monitoring and prediction of fouling by organic matters and residual anionic coagulant during membrane process.

Physical fouling characteristics on silicon carbide (SiC) membranes induced by various organic matter compounds vary depending on the presence of calcium ions (Ca2+). Both destructive techniques (morphological surface analysis) and non-destructive techniques (fouling properties monitoring) were used to determine the fouling mechanisms and behavior during the membrane filtration systems. Destructive analysis and a modified Hermia model were employed to assess the fouling mechanisms. Fouling behavior was also analyzed through non-destructive monitoring techniques including optical coherence tomography (OCT) and three-dimensional laser scanning confocal microscopy (3D-LSM). At concentrations of 10, 30, and 100 mg/L without Ca2+, the flux decreased by 57-95% for humic acid (HA) and anionic polyacrylamide (APAM). APAM exhibited a notable removal rate of up to 56% without Ca2+. At concentration of 10, 30, and 100 mg/L in the absence of Ca2+, the flux decreased by 6-8% for sodium alginate (SA). However, the addition of Ca2+ led to a reduction in the flux for SA by up to 91% and resulted in a removal rate of 40%. Furthermore, addition of Ca2+ led to an alteration of the fouling characteristics of HA and SA. In the case of HA, higher concentrations resulted in elevated thickness and roughness with correlation coefficients of 0.991 and 0.992, respectively. For SA, increased SA concentration led to a thicker (correlation coefficient of 0.999) but smoother surfaces (correlation coefficients of 0.502). Monitoring of these physical characteristics of the fouling layer through non-destructive analysis is crucial for effective fouling management, optimization of the system performance and extending the lifespan of the membrane. By continuously assessing the fouling layer thickness and surface roughness, we expect to be able to provide insights on the fouling behavior, identify trends, that can help scientists and engineers to make informed decisions regarding fouling control strategies in future.

Predicting the removal efficiency of pharmaceutical and personal care products using heated metal oxides as adsorbents based on their physicochemical characteristics.

Pharmaceutical and personal care products (PPCPs) are emerging pollutants that are commonly found in the environment and exist predominantly in nondegradable forms. Several attempts have been made to remove PPCPs via conventional wastewater treatment processes; however, these processes have limitations, such as high costs and insufficient removal efficiencies. Adsorption is a promising alternative for removing PPCPs because it is inexpensive, highly reusable, and easy to operate. Therefore, this study aims to determine the contributing characteristics that can be used to predict the adsorption behaviour of PPCPs based on their physicochemical properties, with heated metal oxide adsorbents (HMOAs). HAOP (heated aluminium oxide particles) and HIOP (heated iron oxide particles) with particle sizes below 38 µm were used. Results from the Brunauer-Emmett-Teller (BET) analysis show that HIOP has higher surface area and smaller pore size (113.7 ± 26.3 m2/g and 5.4 ± 1.8 nm) than HAOP (14.5 ± 0.6 m2/g and 18.6 ± 3.1 nm), which suggest that HIOP would show superior adsorption rates compared to HAOP. The adsorption mechanism is identified based on three major physicochemical properties of PPCPs: molecular weight (M.W.), octanol-water partition coefficient (log Kow), and acid dissociation constant (pKa). The results suggest that the most dominant factor that contributes to the adsorption of PPCPs on to HMOAs is the M.W., where the larger the molecular size, the better the adsorption efficiency. The tests conducted with varying log Kow values revealed that the hydrophilicity of the adsorbent influences the adsorption performance. It was found that HIOP exhibits better removal efficiencies with hydrophilic PPCPs (up to 83%) than with hydrophobic PPCPs (48%), while HAOP exhibits better removal efficiencies with hydrophobic PPCPs (86%) than with hydrophilic PPCPs, with less than 10% removal. Unlike the M.W. and pKa values, the log Kow does not exhibit any visible trend. Therefore, the adsorption behaviour can be predicted with the M.W. and pKa values of the PPCPs, when HAOP and HIOP are used as adsorbents.

Low-pressure volume retarded osmosis for removal of per- and polyfluoroalkyl substances.

Forward osmosis is an energy efficient process that is capable of recovering high-quality water from secondary wastewater treatment. However, regeneration of the draw solution (DS) is a problem that needs to be addressed. Herein, we developed and optimized a one-step process that does not require additional treatment for the DS. This process, called pressure assisted-volume retarded osmosis (PA-VRO), utilizes naturally occurring pressure with the aid of a small inlet pressure (< 1 bar). Poly(styrenesulfonate) was employed as the DS, for its high solubility in water and large molecular size (∼70,000 Da). Accordingly, real wastewater was employed as the feed solution for 48 h to remove perfluorooctanoate (PFOA) and perfluorooctane sulfonate (PFOS) through PA-VRO. The rejection rates for PFOA/PFOS and poly(sodium-4-styrenesulfonate) (PSS) were observed to exceed 98%, after 24 h and 99%, after 48 h. Moreover, there were no traceable amounts of PFOA/PFOS in the DS, and hence the detected concentrations of PFOA and PFOS can be attributed to the residuals from the equipment. Therefore, this well-optimized PA-VRO process can be utilized for potable water production from treated wastewater.

Treatment and management of myofascial pain syndrome.

Myofascial Pain Syndrome (MPS) is a regional pain disorder that affects every age-group and is characterized by the presence of trigger points (TrPs) within muscles or fascia. MPS is typically diagnosed via physical exam, and the general agreement for diagnostic criteria includes the presence of TrPs, pain upon palpation, a referred pain pattern, and a local twitch response. The prevalence of MPS among patients presenting to medical clinics due to pain ranges anywhere from 30 to 93%. This may be due to the lack of clear criteria and guidelines in diagnosing MPS. Despite the prevalence of MPS, its pathophysiology remains incompletely understood. There are many different ways to manage and treat MPS. Some include exercise, TrP injections, medications, and other alternative therapies. More research is needed to form uniformly-accepted diagnostic criteria and treatments.

Minimally invasive treatment of lateral epicondylitis.

Lateral epicondylitis (LE), also known as tennis elbow, is the most common cause of elbow pain in adults, with approximately 1-3% of the general population being afflicted. Although the condition is usually self-limiting, pain can be a major hindrance, limiting daily activity and the work capacity of patients. As a result, many treatment options have become available with the aim to shorten the duration of the disease and increase the quality of life. Steroid injections, NSAIDs, topical creams, platelet-rich plasma, physical therapy, and kinesiotaping are considered conservative treatments, while surgical options are last-resort treatments reserved for refractory LE. In this review, we will provide a brief summary of LE and focus on addressing conservative and minimally invasive interventional options for the treatment of LE.

The Amazon rain forest plant Uncaria tomentosa (cat's claw) and its specific proanthocyanidin constituents are potent inhibitors and reducers of both brain plaques and tangles.

Brain aging and Alzheimer's disease both demonstrate the accumulation of beta-amyloid protein containing "plaques" and tau protein containing "tangles" that contribute to accelerated memory loss and cognitive decline. In the present investigation we identified a specific plant extract and its constituents as a potential alternative natural solution for preventing and reducing both brain "plaques and tangles". PTI-00703 cat's claw (Uncaria tomentosa from a specific Peruvian source), a specific and natural plant extract from the Amazon rain forest, was identified as a potent inhibitor and reducer of both beta-amyloid fibrils (the main component of "plaques") and tau protein paired helical filaments/fibrils (the main component of "tangles"). PTI-00703 cat's claw demonstrated both the ability to prevent formation/aggregation and disaggregate preformed Aß fibrils (1-42 and 1-40) and tau protein tangles/filaments. The disaggregation/dissolution of Aß fibrils occurred nearly instantly when PTI-00703 cat's claw and Aß fibrils were mixed together as shown by a variety of methods including Thioflavin T fluorometry, Congo red staining, Thioflavin S fluorescence and electron microscopy. Sophisticated structural elucidation studies identified the major fractions and specific constituents within PTI-00703 cat's claw responsible for both the observed "plaque" and "tangle" inhibitory and reducing activity. Specific proanthocyanidins (i.e. epicatechin dimers and variants thereof) are newly identified polyphenolic components within Uncaria tomentosa that possess both "plaque and tangle" reducing and inhibitory activity. One major identified specific polyphenol within PTI-00703 cat's claw was epicatechin-4ß-8-epicatechin (i.e. an epicatechin dimer known as proanthocyanidin B2) that markedly reduced brain plaque load and improved short-term memory in younger and older APP "plaque-producing" (TASD-41) transgenic mice (bearing London and Swedish mutations). Proanthocyanidin B2 was also a potent inhibitor of brain inflammation as shown by reduction in astrocytosis and gliosis in TASD-41 transgenic mice. Blood-brain-barrier studies in Sprague-Dawley rats and CD-1 mice indicated that the major components of PTI-00703 cat's claw crossed the blood-brain-barrier and entered the brain parenchyma within 2 minutes of being in the blood. The discovery of a natural plant extract from the Amazon rain forest plant (i.e. Uncaria tomentosa or cat's claw) as both a potent "plaque and tangle" inhibitor and disaggregator is postulated to represent a potential breakthrough for the natural treatment of both normal brain aging and Alzheimer's disease.