RESUMO
Practical applications of heat transport control with artificial metamaterials will heavily depend on the realization of thermal diodes/rectifiers, in which thermal conductivity depends on the heat flux direction. Whereas various macroscale implementations have been made experimentally, nanoscales realizations remain challenging and efficient rectification still requires a better fundamental understanding of heat carriers' transport and nonlinear mechanisms. Here, we propose an experimental realization of a thermal rectifier based on two leads with asymmetric mass gradients separated by a ballistic spacer, as proposed in a recent numerical investigation, and measure its thermal properties electrically with the microbridge technique. We use a Si[Formula: see text]N[Formula: see text] nanobeam on which an asymmetric mass gradient has been engineered and demonstrate that in its current form, this structure does not allow for thermal rectification. We explain this by a combination of too weak asymmetry and non-linearities. Our experimental observations provide important information towards fabricating rigorous thermal rectifiers in the ballistic phonon transport regime, which are expected to open new possibilities for applications in thermal management and quantum thermal devices.
RESUMO
We present a novel shadow evaporation technique for the realization of junctions and capacitors. The design by e-beam lithography of strongly asymmetric undercuts on a bilayer resist enables in situ fabrication of junctions and capacitors without the use of the well-known suspended bridge (Dolan 1977 Appl. Phys. Lett. 31 337-9). The absence of bridges increases the mechanical robustness of the resist mask as well as the accessible range of the junction size, from 10(-2) µm(2) to more than 10(4) µm(2). We have fabricated Al/AlO(x)/Al Josephson junctions, phase qubit and capacitors using a 100 kV e-beam writer. Although this high voltage enables a precise control of the undercut, implementation using a conventional 20 kV e-beam is also discussed. The phase qubit coherence times, extracted from spectroscopy resonance width, Rabi and Ramsey oscillation decays and energy relaxation measurements, are longer than the ones obtained in our previous samples realized by standard techniques. These results demonstrate the high quality of the junction obtained by this bridge-free technique.
RESUMO
Emerging quantum technologies require mastering thermal management, especially at the nanoscale. It is now accepted that thermal metamaterial-based phonon manipulation is possible, especially at sub-kelvin temperatures. In these extreme limits of low temperatures and dimensions, heat conduction enters a quantum regime where phonon exchange obeys the Landauer formalism. Phonon transport is then governed by the transmission coefficients between the ballistic conductor and the thermal reservoirs. Here we report on ultra-sensitive thermal experiments made on ballistic 1D phonon conductors using a micro-platform suspended sensor. Our thermal conductance measurements attain a power sensitivity of 15 attoWatts [Formula: see text] around 100 mK. Ballistic thermal transport is dominated by non-ideal transmission coefficients and not by the quantized thermal conductance of the nanowire itself. This limitation of heat transport in the quantum regime may have a significant impact on modern thermal management and thermal circuit design.