JEM Spotlight: Fungi, mycotoxins and microbial volatile organic compounds in mouldy interiors from water-damaged buildings.

Concerns have been raised about exposure to mycotoxin producing fungi and the microbial volatile organic compounds (MVOCs) they produce in indoor environments. Therefore, the presence of fungi and mycotoxins was investigated in 99 samples (air, dust, wallpaper, mycelium or silicone) collected in the mouldy interiors of seven water-damaged buildings. In addition, volatile organic compounds (VOCs) were sampled. The mycotoxins were analysed by liquid chromatography-tandem mass spectrometry (LC-MS/MS) (20 target mycotoxins) and quadrupole time-of-flight mass spectrometry (LC-Q-TOF-MS). Morphological and molecular identifications of fungi were performed. Of the 99 samples analysed, the presence of one or more mycotoxins was shown in 62 samples by means of LC-MS/MS analysis. The mycotoxins found were mainly roquefortine C, chaetoglobosin A and sterigmatocystin but also roridin E, ochratoxin A, aflatoxin B(1) and aflatoxin B(2) were detected. Q-TOF-MS analysis elucidated the possible occurrence of another 42 different fungal metabolites. In general, the fungi identified matched well with the mycotoxins detected. The most common fungal species found were Penicillium chrysogenum, Aspergillus versicolor (group), Chaetomium spp. and Cladosporium spp. In addition, one hundred and seventeen (M)VOCs were identified, especially linear alkanes (C(9)-C(17)), aldehydes, aromatic compounds and monoterpenes.

Development of an immunoassay-based lateral flow dipstick for the rapid detection of aflatoxin B1 in pig feed.

The aim of this work was to develop an immunoassay-based lateral flow dipstick for the rapid detection of aflatoxin B(1) in pig feed. The test consisted of three main components: conjugate pad, membrane, and absorbent pad. The membrane was coated with two capture reagents, that is, aflatoxin B(1)-bovine serum albumin conjugate and rabbit anti-mouse antibodies. The detector reagent consisted of colloidal gold particles coated with affinity-purified monoclonal anti-aflatoxin B(1) antibodies, which saturated the conjugate pad. A comparison of several extraction methods for the pig feed matrix is presented. A mixture of methanol/water (80:20, v/v) gave the best recoveries. After sample extraction and dilution, the dipstick was put in the sample solution at the conjugate pad side and developed for 10 min. Analyte present in the sample competed with the aflatoxin B(1) immobilized on the membrane for binding to the limited amount of antibodies in the detector reagent. Thus, the line color intensity of an aflatoxin B(1)-positive dipstick is visually distinguishable from that of an aflatoxin B(1)-negative sample. The visual detection limit for aflatoxin B(1) is 5 microg/kg. The major advantages of this one-step striptest are that results can be obtained within 10 min and that all reagents are immobilized on the lateral flow dipstick.

Use of headspace SPME-GC-MS for the analysis of the volatiles produced by indoor molds grown on different substrates.

An automated headspace solid phase microextraction method followed by GC-MS analysis was used to evaluate and compare the in vitro production of microbial volatile organic compounds (MVOCs) on malt extract agar, plasterboard and wallpaper. Five fungal strains were isolated from the walls of water-damaged houses and identified. In addition, four other common molds were studied. In general, MVOC production was the highest on malt extract agar. On this synthetic medium, molds typically produced 2-methylpropanol, 2-methylbutanol and 3-methylbutanol. On wallpaper, mainly 2-ethylhexanol, methyl 2-ethylhexanoate and compounds of the C8-complex such as 1-octene-3-ol, 3-octanone, 3-octanol and 1,3-octadiene were detected. The detection of 2-ethylhexanol and methyl 2-ethylhexanoate indicates an enhanced degradation of the substrate by most fungi. For growth on plasterboard, no typical metabolites were detected. Despite these metabolite differences on malt extract agar, wallpaper and plasterboard, some molds also produced specific compounds independently of the used substrate, such as trichodiene from Fusarium sporotrichioides and aristolochene from Penicillium roqueforti. Therefore, these metabolites can be used as markers for the identification and maybe also mycotoxin production of these molds. All five investigated Penicillium spp. in this study were able to produce two specific diterpenes, which were not produced by the other species studied. These two compounds, which remain unidentified until now, therefore seem specific for Penicillium spp. and are potentially interesting for the monitoring of this fungal genus. Further experiments will be performed with other Penicillium spp. to study the possibility that these two compounds are specific for this group of molds.

Simultaneous non-instrumental detection of aflatoxin B1 and ochratoxin A using a clean-up tandem immunoassay column.

A set-up and simple method based on the clean-up tandem immunoassay approach was developed for the visual detection of two analytes. The method was based on a 1 mL column with one clean-up layer and two detection immunolayers. As detection immunolayers CNBr-activated Sepharose 4B with coupled secondary rabbit anti-mouse antibodies was used. Different specific antibodies were coupled to each detection immunolayer. The analysis was realised in a competitive ELISA format with visual detection of the developed colour for each detection immunolayer and took 20 min for six sample extracts. The described method was applied to the simultaneous detection of aflatoxin B1 and ochratoxin A in spices with cut-off levels at 5 and 10 microg kg(-1), respectively. Results were confirmed by LC-MS/MS with immunoaffinity column clean-up.