Multi-energy calibration of a PILATUS3 CdTe detector for hard x-ray measurements of magnetically confined fusion plasmas.

A multi-energy hard x-ray pin-hole camera based on the PILATUS3 X 100K-M CdTe detector has been developed at the Princeton Plasma Physics Laboratory for installation on the Tungsten Environment in Steady State Tokamak. This camera will be employed to study thermal plasma features such as electron temperature as well as non-thermal effects such as fast electron tails produced by a lower hybrid radiofrequency current drive and the birth of runaway electrons. The innovative aspect of the system lies in the possibility of setting the threshold energy independently for each of the ∼100k pixels of the detector. This feature allows for the measurement of the x-ray emission in multiple energy ranges with adequate space and time resolution (∼1 cm, 2 ms) and coarse energy resolution. In this work, the energy dependence of each pixel was calibrated within the range 15 keV-100 keV using a tungsten x-ray tube and emission from a variety of fluorescence targets (from yttrium to uranium). The data corresponding to pairs of Kα emission lines are fit to the characteristic responsivity ("S-curve"), which describes the detector sensitivity across the 64 possible energy threshold values for each pixel; this novel capability is explored by fine-tuning the voltage of a six-bit digital-analog converter after the charge-sensitive amplifier for each of the ∼100k pixels. This work presents the results of the calibration including a statistical analysis. It was found that the achievable energy resolution is mainly limited by the width of the S-curve to 3 keV-10 keV for threshold energies up to 50 keV, and to ≥20 keV for energies above 60 keV.

Calibration of a versatile multi-energy soft x-ray diagnostic for WEST long pulse plasmas.

A compact multi-energy soft x-ray diagnostic is being installed on the W Environment in Steady-state Tokamak (WEST), which was designed and built to test ITER-like tungsten plasma facing components in a long pulse (∼1000 s) scenario. The diagnostic consists of a pinhole camera fielded with the PILATUS3 photon-counting Si-based detector (≲100 kpixel). The detector has sensitivity in the range 1.6-30 keV and enables energy discrimination, providing a higher energy resolution than conventional systems with metal foils and diodes with adequate space and time resolution (≲1 cm and 2 ms). The lower-absorption cut-off energy is set independently on each one of the ∼100 kpixels, providing a unique opportunity to measure simultaneously the plasma emissivity in multiple energy ranges and deduce a variety of plasma parameters (e.g., Te, nZ, and ΔZeff). The energy dependence of each pixel is calibrated here over the range 3-22 keV. The detector is exposed to a variety of monochromatic sources-fluorescence emission from metallic targets-and for each pixel, the lower energy threshold is scanned to calibrate the energy dependence. The data are fit to a responsivity curve ("S-curve") that determines the mapping between the possible detector settings and the energy response for each pixel. Here, the calibration is performed for three energy ranges: low (2.3-6 keV), medium (4.5-13.5 keV), and high (5.4-21 keV). We determine the achievable energy resolutions for the low, medium, and high energy ranges as 330 eV, 640 eV, and 950 eV, respectively. The main limitation for the energy resolution is found to be the finite width of the S-curve.

Statistical features in the lakes-straits model and the influence of hernias.

We evaluate numerically the mobility of DNA chains under field-inversion gel electrophoresis (FIGE) conditions in the framework of the lakes-straits model introduced by Zimm (Phys. Rev. Lett. 1988, 61, 2965-2968; J. Phys. Chem. 1991, 94, 2197-2206). We extend the model by allowing both simple and also multiple-branched hernias; this is achieved by arranging the data structure used in the algorithm so that each fragment in a lake can be treated separately. We show that the existence of hernias allows the probe to migrate faster and that with hernias the mobility minimum in FIGE shifts to smaller field periods. These effects occur only if the electric field is strong enough. We also discuss the influence of the model's parameters on the mobility.

Subcellular calcium content in cardiomyopathic hamster hearts in vivo: an electron probe study.

In the Syrian cardiomyopathic hamster heart, abnormal cellular calcium regulation, resulting in cellular calcium overload, is believed to play a role in the pathogenesis of cardiac hypertrophy and failure. Alternatively, the primary abnormality may be coronary vasospasm, resulting in reperfusion-induced necrosis. According to the latter hypothesis, only those cells that suffer an ischemic insult would contain elevated calcium levels. To determine whether a generalized elevation in myocytic calcium exists in myopathic hamster hearts, we measured cellular and subcellular calcium concentrations by electron probe microanalysis in cryosections of 50-day and 96-day myopathic and control hearts, rapidly frozen in vivo. Total calcium content of ventricular homogenates from each group was also measured by atomic absorption spectrophotometry. No significant differences in subcellular calcium were found by electron probe microanalysis among 50-day and 96-day myopathics and their age-matched controls. In 50-day myopathic and control hearts, mitochondrial calcium was 0.7 +/- 0.2 and 0.9 +/- 0.2, respectively, and A-band calcium was 3.0 +/- 0.4 and 2.6 +/- 0.4 mmol calcium/kg dry wt(+/- SEM). Results from 96-day animals were similar. Localized regions of elevated calcium were found only at sites of necrotic foci: in Na+-loaded cells (mitochondria: 4.7 +/- 1.3 (SEM) mmol/kg dry wt), in dying cells (mitochondria: 72 +/- 22 (SEM) mmol/kg dry wt) or as extracellular deposits (7-10 mol/kg dry wt). Total calcium content of hearts from myopathic hamsters, as determined by atomic absorption spectrophotometry, was also 13 times (50-day) and 50 times (96-day) higher than controls. These results demonstrate that there is a marked heterogeneity in cellular calcium content in myopathic hamster hearts, but the data do not support the hypothesis of a generalized cellular calcium overload.

Effect of lovastatin on cholesterol content of cardiac and red blood cell membranes in normal and cardiomyopathic hamsters.

Lovastatin, an inhibitor of 3-hydroxy-3-methylglutaryl coenzyme A, is used therapeutically to lower plasma cholesterol levels. However, the effect of this therapy on cell membrane cholesterol in vivo is not known. The goal of this study was to investigate whether lovastatin treatment of hamsters decreases cholesterol in cardiac cell membranes and in red blood cell (RBC) membranes. Because abnormal cellular Ca++ regulation has been associated with altered membrane cholesterol in hearts of cardiomyopathic (CM) hamsters, we also measured the cholesterol content of cardiac and RBC membranes from lovastatin-treated and untreated Bio 14.6 CM hamsters to determine whether any differences existed with respect to normals. Sarcolemma-enriched cardiac membranes and RBC membranes were obtained from 42 to 45-day normal and CM hamsters after 13 days of lovastatin treatment (0.1% of food/day) and from untreated normal and CM hamsters. Plasma cholesterol, membrane cholesterol/phospholipid (C/PL) ratio and cholesterol per milligram of membrane protein (C/prot) were determined. In hearts from untreated CM hamsters, C/prot was significantly lower (P < .05) than in untreated normals. Lovastatin decreased plasma cholesterol by 76% and 81% in normal and CM hamsters, respectively (P < .001), but after lovastatin treatment, there was no significant change in C/PL or C/prot in cardiac membranes from either strain; there was also no significant decrease in C/prot or in C/PL of RBC membranes from normals or C/PL of CM hamster RBC membranes. However, lovastatin feeding resulted in a significant (P < .01) 24% decrease in C/prot of CM RBC membranes.(ABSTRACT TRUNCATED AT 250 WORDS)