RESUMO
Sapphire optical fiber has the ability to withstand ultrahigh temperatures and high radiation, but it is multimoded which prevents its use in many sensing applications. Problematically, Bragg gratings in such fiber exhibit multiple reflection peaks with a fluctuating power distribution. In this work, we write single-mode waveguides with Bragg gratings in sapphire using a novel multi-layer depressed cladding design in the 1550 nm telecommunications waveband. The Bragg gratings have a narrow bandwidth (<0.5 nm) and have survived annealing at 1000°C. The structures are inscribed with femtosecond laser direct writing, using adaptive beam shaping with a non-immersion objective. A single-mode sapphire fiber Bragg grating is created by writing a waveguide with a Bragg grating within a 425 µm diameter sapphire optical fiber, providing significant potential for accurate remote sensing in ultra-extreme environments.
RESUMO
We present dynamic time-resolved measurements of a multi-pixel analog liquid crystal phase modulator driven at a 1 kHz frame rate. A heterodyne interferometer is used to interrogate two pixels independently and simultaneously, to deconvolve phase modulation with a wide bandwidth. The root mean squared optical phase error within a 30 Hz to 25 kHz bandwidth is <0.5° and the crosstalk rejection is 50 dB. Measurements are shown for a custom-built device with a flexoelectro-optic chiral nematic liquid crystal. However, the technique is applicable to many different types of optical phase modulators and spatial light modulators.
RESUMO
We present here the first time-resolved tilt-angle and retardance measurements for large-tilt (>45°) flexoelectro-optic liquid crystal modulators. These devices have potential for next generation fast switching (>1 kHz), 0-2π analog phase spatial light modulators (SLMs), with applications in optical beamsteering, microscopy and micromachining. The chiral nematic device used consisted of a mixture of CBC7CB and the chiral dopant R5011 in a nominally 5 µm-thick cell, aligned in the uniform lying helix mode. As the device is dynamically switched over angles of ± 54°, retardance changes of up to 0.17λ are observed. Furthermore, the time-resolved measurements reveal an asymmetry in the tilt in the optic-axis depending on the polarity of the applied electric field. The change in the optic-axis exhibits a pattern dependence, whereby it is determined by both the pulse history and the applied field. This pattern dependence results in tilt-angle errors of up to 8.8°, which could manifest as phase errors as large as 35.2° in potential SLMs. These time domain measurements may allow correction of these deterministic errors, to realize practical devices.
RESUMO
A new polarimeter is presented which gives time-resolved measurements of both the optic-axis angle and the linear phase retardation for modulated birefringent optical devices. It is suitable for characterizing dynamic waveplate devices based on liquid crystal and other materials. It is fully automated and requires no angular alignment of the device under test. The system has an absolute angle error of < ± 0.3° and a retardance error of < ± 0.44°, with considerably better relative accuracy. The method has been tested with a chiral nematic liquid crystal device exhibiting flexoelectro-optic switching at 3 kHz in the uniform lying helix mode. These results represent the first time-resolved tilt-angle and phase retardation measurements for a liquid crystal device operating at fast switching frequencies.
RESUMO
We present fiber Bragg gratings (FBGs) fabricated using adaptive optics aberration compensation for the first time to the best of our knowledge. The FBGs are fabricated with a femtosecond laser by the point-by-point method using an air-based objective lens, removing the requirement for immersion oil or ferrules. We demonstrate a general phase correction strategy that can be used for accurate fabrication at any point in the fiber cross-section. We also demonstrate a beam-shaping approach that nullifies the aberration when focused inside a central fiber core. Both strategies give results which are in excellent agreement with coupled-mode theory. An extremely low wavelength polarization sensitivity of 4 pm is reported.
RESUMO
We present a flexoelectro-optic liquid crystal (LC) analog phase modulator with >2π phase range at a 1 kHz switching frequency. The chiral nematic LC mixture consists of the bimesogen CBC7CB with chiral dopant R5011, aligned in the uniform lying helix mode. The mixture exhibits >±π/4 rotation of the optic axis for a drive voltage of ±21.5 V (E=±4.5 V µm-1). The rotation of the optic axis is converted into a phase modulation with the aid of a reflective device configuration incorporating a â¼5 µm LC cell, a polarizer, two quarter-wave plates, and a mirror. The residual amplitude modulation is found to be <23%. This flexoelectro-optic phase modulator combination has the potential to enable analog spatial light modulators with very fast frame rates suitable for a range of applications.
RESUMO
Although well-established textbook arguments suggest that static electric susceptibility χ(0) must be positive in "all bodies," it has been pointed out that materials that are not in thermodynamic equilibrium are not necessarily subject to this restriction. Media with inverted populations of atomic and molecular energy levels have been predicted theoretically to exhibit a χ(0) < 0 state, however the systems envisioned require reduced temperature, reduced pressure, and an external pump laser to maintain the population inversion. Further, the existence of χ(0) < 0 has never been confirmed experimentally. Here, a completely different approach is taken to the question of χ(0) < 0 and a design concept to achieve "true" χ(0) < 0 is proposed based on active metamaterials with internal power sources. Two active metamaterial structures are fabricated that, despite still having their power sources implemented externally for reasons of practical convenience, provide evidence in support of the general concept. Effective values are readily achieved at room temperature and pressure and are tunable throughout the range of stability -1 < χ(0) < 0, resulting in experimentally-determined magnitudes that are over one thousand times greater than those predicted previously. Since χ(0) < 0 is the missing electric analog of diamagnetism, this work opens the door to new technological capabilities such as stable electrostatic levitation.
RESUMO
In this paper, we demonstrate a flexoelectro-optic liquid crystal phase-only device that uses a chiral nematic reflector to achieve full 2π phase modulation. This configuration is found to be very tolerant to imperfections in the chiral nematic reflector provided that the flexoelectro-optic LC layer fulfils the half-wave condition. Encouragingly, the modulation in the phase, which operates at kHz frame rates, is also accompanied by low amplitude modulation. The configuration demonstrated herein is particularly promising for the development of next-generation liquid crystal on silicon spatial light modulators.