Evaluation of enamel surface integrity after orthodontic bracket debonding: comparison of three different system.

OBJECTIVE: This study aimed to evaluate enamel surface integrity and time consumed during residual cement removal after bracket debonding using different adhesive removal burs with and without a dental loupe. MATERIAL AND METHODS: Sixty human-extracted premolars were collected, cleaned, mounted, and prepared for orthodontic bracket bonding. Teeth were randomly divided into three main groups (n = 20) based on the adhesive removal method: tungsten carbide system (TC), sof-lex discs system (SD), and diamond system (DB) groups. Then, each group was subdivided into two subgroups (naked eye and magnifying loupe subgroups). The brackets were bonded and then debonded after 24 h, and the Adhesive Remnant Index (ARI) was assessed. The adhesive remnants were removed by different systems, and the final polishing was performed by Silicone OneGloss. The enamel surface roughness was evaluated before bracketing (T0), after residual cement removal (T1), and finally after polishing (T2) using surface Mitutoyo SJ-210 profilometry and Scanning Electron Microscopy (SEM) to determine the Enamel Damage Index (EDI) score. The time consumed for adhesive removal was recorded in seconds. RESULTS: The Kruskal Wallis test showed a statistically significant difference in roughness values at T1 compared to T2 between subgroups (p < 0.001). When comparing EDI at T1 and T2, the Kruskal-Wallis H-test showed statistically significant differences in all subgroups. The pairwise comparisons revealed that EDI scores showed a statistically significant difference at T1 and T2 between DB vs. TC and SD (p = 0.015) but not between TC vs. SD (p = 1.000), indicating the highest roughness value observed in the DB group. The time for cement removal was significantly shorter in the magnifying loupe group than in the naked eye group and was shortest with the TC group, whereas the time was the longest with the DB group (p < 0.05). CONCLUSION: All three systems were clinically satisfactory for residual orthodontic adhesive removal. However, TC system produced the lowest enamel roughness, while the DB system created the greatest. The polishing step created smoother surfaces regardless of the systems used for resin removal.

The relationship between the dimensions of frontal air sinus and skeletal malocclusions: A systematic review and meta-analysis.

Objective: The goal of this systematic review and meta-analysis was to assess whether the dimensions of the frontal air sinus correlate with skeletal malocclusion. Study selection: PubMed, Scopus, Embase, and Google Scholar were searched for relevant studies published up to May 23, 2023. The review included observational and retrospective studies that compared the dimensions of the frontal air sinus between different skeletal malocclusions. The PECOS method was used in this study ("Population, Exposure, Comparator, Outcome, and Study design"). The search was done using the following English keywords: "frontal sinus" OR "lateral cephalometric" OR "malocclusion" AND "surface area". Results: Seven studies were included, which involved 1101 participants, of whom 403 were class I, 375 were class II, and 323 were class III. These studies had a moderate risk of bias. The surface area of the frontal sinus in class III was significantly larger than in class I (standardized difference in means (SDM) = -0.971; 95 % CI = -1.147- -0.796; P < 0.001) and in class II (SDM = -1.535; 95 % CI = -1.732- -1.337; P < 0.001). Conclusion: Class III malocclusion is associated with a larger surface area of the frontal sinus compared to classes I and II.