Design of Ionic Liquids for Fluorinated Gas Absorption: COSMO-RS Selection and Solubility Experiments.

In recent years, the fight against climate change and the mitigation of the impact of fluorinated gases (F-gases) on the atmosphere is a global concern. Development of technologies that help to efficiently separate and recycle hydrofluorocarbons (HFCs) at the end of the refrigeration and air conditioning equipment life is a priority. The technological development is important to stimulate the F-gas capture, specifically difluoromethane (R-32) and 1,1,1,2-tetrafluoroethane (R-134a), due to their high global warming potential. In this work, the COSMO-RS method is used to analyze the solute-solvent interactions and to determine Henry's constants of R-32 and R-134a in more than 600 ionic liquids. The three most performant ionic liquids were selected on the basis of COSMO-RS calculations, and F-gas absorption equilibrium isotherms were measured using gravimetric and volumetric methods. Experimental results are in good agreement with COSMO-RS predictions, with the ionic liquid tributyl(ethyl)phosphonium diethyl phosphate, [P2444][C2C2PO4], being the salt presenting the highest absorption capacities in molar and mass units compared to salts previously tested. The other two ionic liquids selected, trihexyltetradecylphosphonium glycinate, [P66614][C2NO2], and trihexyl(tetradecyl)phosphonium 2-cyano-pyrrole, [P66614][CNPyr], may be competitive as far as their absorption capacities are concerned. Future works will be guided on evaluating the performance of these ionic liquids at an industrial scale by means of process simulations, in order to elucidate the role in process efficiency of other relevant absorbent properties such as viscosity, molar weight, or specific heat.

Tuning the solvation of indigo in aqueous deep eutectics.

The solubility of synthetic indigo dye was measured at room temperature in three deep eutectic solvents (DESs)-1:3 choline chloride:1,4-butanediol, 1:3 tetrabutylammonium bromide:1,4-butanediol, and 1:2 choline chloride:p-cresol-to test the hypothesis that the structure of DESs can be systematically altered, to induce specific DES-solute interactions, and, thus, tune solubility. DESs were designed starting from the well-known cholinium chloride salt mixed with the partially amphiphilic 1,4-butanediol hydrogen bond donor (HBD), and then, the effect of increasing salt hydrophobicity (tetrabutylammonium bromide) and HBD hydrophobicity (p-cresol) was explored. Measurements were made between 2.5 and 25 wt. % H2O, as a reasonable range representing atmospherically absorbed water, and molecular dynamics simulations were used for structural analysis. The choline chloride:1,4-butanediol DES had the lowest indigo solubility, with only the hydrophobic character of the alcohol alkyl spacers. Solubility was highest for indigo in the tetrabutylammonium bromide:1,4-butanediol DES with 2.5 wt. % H2O due to interactions of indigo with the hydrophobic cation, but further addition of water caused this to reduce in line with the added water mole fraction, as water solvated the cation and reduced the extent of the hydrophobic region. The ChCl:p-cresol DES did not have the highest solubility at 2.5 wt. % H2O, but did at 25 wt. % H2O. Radial distribution functions, coordination numbers, and spatial distribution functions demonstrate that this is due to strong indigo-HBD interactions, which allow this system to resist the higher mole fraction of water molecules and retain its solubility. The DES is, therefore, a host to local-composition effects in solvation, where its hydrophobic moieties concentrate around the hydrophobic solute, illustrating the versatility of DES as solvents.

Ion pair free energy surface as a probe of ionic liquid structure.

Numerous combinations of cations and anions are possible for the production of ionic liquids with fine-tuned properties once the correlation with the molecular structure is known. In this sense, computer simulations are useful tools to explain and even predict the properties of ionic liquids. However, quantum mechanical methods are usually restricted to either small clusters or short time scales so that parameterized force fields are required to study the bulk liquids. In this work, a method is proposed to enable a comparison between the quantum mechanical system and both polarizable and nonpolarizable force fields by means of the calculation of free energy surfaces for the translational motion of the anion around the cation in gas phase. This method was tested for imidazolium-based cations with 3 different anions, [BF4]-, [N(CN)2]-, and [NTf2]-. Better agreement was found with the density functional theory calculations when polarizability is introduced in the force field. In addition, the ion pair free energy surfaces reproduced the main structural patterns observed in the first coordination shell in molecular dynamics simulations of the bulk liquid, proving to be useful probes for the liquid phase structure that can be computed with higher level methods and the comparison with forcefields can indicate further improvements in their parameterization.