RESUMO
We introduce a new application of solid state NMR measurements towards characterizing the donor-acceptor interfaces within bulk heterojunction (BHJ) films. Rotational echo double resonance (REDOR) is used to measure dipolar couplings between ^{13}C nuclei on the acceptor phenyl-C_{61}-butyric acid methyl ester (PCBM) fullerene cage, which is ≈18% isotopically enriched with ^{13}C, and beta hydrogens on the donor poly(3-hexyl thiophene) (P3HT) main chain, which are >95% isotopically enriched with ^{2}H. The ^{13}C-^{2}H dipolar couplings are used for constraining possible models of molecular packing in the amorphous mixed phase of a P3HT/PCBM BHJ. The films studied are highly mixed (>80%) and have a maximum length scale of composition nonuniformity of ≈6 nm in the mixed phase, as demonstrated by ^{1}H spin diffusion NMR and supported by TEM. The REDOR results show that despite the lack of phase separation at length scales greater than ≈6 nm, neat P3HT and PCBM clusters exist on ≈3 nm size scales, and, for the average PCBM molecule, the number of nearest neighbors P3HTs is two.
RESUMO
Doping to enhance the electrical conductivity of organic semiconductors is not without its challenges: The efficacy of this process depends on many factors and it is not always clear how to remedy poor doping. In the case of doping with salts, one of the possible causes of poor doping is a limited yield of integer charge transfer resulting in the presence of both cations and anions in the film. The charge of such ions can severely limit the electrical conductivity, but their presence is not easily determined. Here we introduce a set of simple conductivity measurements to determine whether poor doping in the case where the dopant is a salt is due to limited integer charge transfer. By tracking how the conductivity changes over time when applying a bias voltage for an extended amount of time we can pinpoint whether unwanted ions are present in the film. Firstly, we introduce the principle of this approach by performing numerical simulations that include the movement of ions. We show that the conductivity can increase or decrease depending on the type of ions present in the film. Next, we show that the movement of these dopant ions causes a build-up of space-charge, which makes the current-voltage characteristic non-linear. Next, we illustrate how this approach may be used in practice by doping a fullerene derivative with a series of organic salts. We thus provide a tool to make the optimization of doping more rational.
RESUMO
Mechanically controllable break junctions allow for an impressive level of control over the distance between two electrodes, but lack stability at room temperature. On the other hand, two-dimensional (2D) networks of nanoparticles bridged by molecules form a stable device structure for investigating molecular conductance properties. Here, we combine both techniques to create a robust platform for molecular charge transport with control over the inter-electrode distance on the picometer scale. The resistance change due to bending of our structures is dependent on the molecular species present between the nanoparticles.
RESUMO
The heterofullerene ion C(59)N(+) is formed efficiently in the gas phase during fast atom bombardment mass spectroscopy of a cluster-opened N-MEM (N-methoxyethoxy methyl) ketolactam. This transformation is shown to occur also in solution in the presence of strong acid, affording biazafullerenyl (C(59)N)(2) in good yield. It is proposed that the azafullerene dimer is formed upon in situ reduction of the highly reactive azafulleronium ion. The isolation and characterization of biazafullerenyl opens a viable route for the preparation of other heterofullerenes in solution.
RESUMO
The temperature dependence of the exciton dynamics in a conjugated polymer is studied using time-resolved spectroscopy. Photoluminescence decays were measured in heterostructured samples containing a sharp polymer-fullerene interface, which acts as an exciton quenching wall. Using a 1D diffusion model, the exciton diffusion length and diffusion coefficient were extracted in the temperature range of 4-293 K. The exciton dynamics reveal two temperature regimes: in the range of 4-150 K, the exciton diffusion length (coefficient) of approximately 3 nm (approximately 1.5 x 10 (-4) cm2/s) is nearly temperature independent. Increasing the temperature up to 293 K leads to a gradual growth up to 4.5 nm (approximately 3.2 x 10 (-4) cm2/ s). This demonstrates that exciton diffusion in conjugated polymers is governed by two processes: an initial downhill migration toward lower energy states in the inhomogenously broadened density of states, followed by temperature activated hopping. The latter process is switched off below 150 K.
RESUMO
The as-produced isomer mixture of the organic photovoltaic device acceptor material bis-[60]PCBM has been purified into its constituents by peak-recycling HPLC, and those individual isomers were characterised by UV-Vis absorption spectroscopy and cyclic voltammetry. A total of 18 isomers were purified from the mixture to a standard exceeding 99.5% with respect to other isomers. The HOMOs, LUMOs, and HOMO-LUMO gaps of the purified isomers vary from -5.673 to -5.444 eV, -3.901 to -3.729 eV, and 1.664 to 1.883 eV, respectively. We also find a correlation between HPLC retention time and the relative positions of the addends; in that generally the closer the addends are to each other the longer the retention time of the isomer, and vice versa.
RESUMO
The formation of hetero-dimers of bifunctional oligo(p-phenylenevinylene) and C60 ureido-pyrimidinone derivatives has been observed by 1H-NMR and fluorescence techniques.
RESUMO
The photocurrent in conjugated polymer-fullerene blends is dominated by the dissociation efficiency of bound electron-hole pairs at the donor-acceptor interface. A model based on Onsager's theory of geminate charge recombination explains the observed field and temperature dependence of the photocurrent in PPV:PCBM blends. At room temperature only 60% of the generated bound electron-hole pairs are dissociated and contribute to the short-circuit current, which is a major loss mechanism in photovoltaic devices based on this material system.
RESUMO
There is ample evidence that organic field-effect transistors have reached a stage where they can be industrialized, analogous to standard metal oxide semiconductor (MOS) transistors. Monocrystalline silicon technology is largely based on complementary MOS (CMOS) structures that use both n-type and p-type transistor channels. This complementary technology has enabled the construction of digital circuits, which operate with a high robustness, low power dissipation and a good noise margin. For the design of efficient organic integrated circuits, there is an urgent need for complementary technology, where both n-type and p-type transistor operation is realized in a single layer, while maintaining the attractiveness of easy solution processing. We demonstrate, by using solution-processed field-effect transistors, that hole transport and electron transport are both generic properties of organic semiconductors. This ambipolar transport is observed in polymers based on interpenetrating networks as well as in narrow bandgap organic semiconductors. We combine the organic ambipolar transistors into functional CMOS-like inverters.