Local pathology and systemic serum bupivacaine after subcutaneous delivery of slow-releasing bupivacaine microspheres.

BACKGROUND: Prolonged local anesthesia, particularly desirable to minimize acute and chronic postoperative pain, has been provided by microspheres that slowly release bupivacaine (MS-Bup). In this study, we report on the systemic drug concentrations and the local dermatopathology that occur after subcutaneous injection of MS-Bup. METHODS: Rats (approximately 300 g) were injected under the dorsolumbar skin with MS-Bup containing 40 mg of bupivacaine (base) or with 0.4 mL of 0.5% bupivacaine-HCl (BupHCl; 1.78 mg bupivacaine). Blood was drawn, under sevoflurane anesthesia, at 10 minutes to 144 hours, and the serum analyzed for total bupivacaine by liquid chromatography-tandem mass spectrometry. In different animals, skin punch biopsies (4 mm) were taken at 1, 3, 7, 14, and 30 days after the same drug injections, sectioned at 5 µm, and stained with hematoxylin-eosin. Samples from skin injected with BupHCl, with MS-Bup suspended in carboxymethyl cellulose (MS-Bup.CMC), or in methyl cellulose (MS-Bup.MC) were compared with their respective drug-free controls (placebos). RESULTS: Serum bupivacaine reached a maximal average value (n = 8) of 194.9 ng/mL at 8 hours after injection of MS-Bup (95% upper prediction limit = 230.2 ng/mL), compared with the maximal average (n = 6) serum level of 374.9 ng/mL (95% prediction limit = 470.6 ng/mL) at 30 minutes after injection of BupHCl. Serum bupivacaine decreased to undetectable levels (<3.23 ng/mL) at 8 hours after BupHCl and was detectable at approximately 20% of the maximal value at 144 hours after MS-Bup injection. BupHCl injection resulted in moderate lymphocytic infiltration of skeletal muscle at 1 and 3 days. MS-Bup.CMC and placebo-CMC caused extensive infiltration of macrophages, lymphocytes, and some neutrophils at 1 to 7 days, whereas MS-Bup.MC and placebo-MC caused only mild inflammation. CONCLUSIONS: Subcutaneous administration of microspheres releasing bupivacaine results in lower blood levels lasting for much longer times than those from bupivacaine solution.

Forced degradation studies of medroxyprogesterone acetate injectable suspensions (150 mg/ml) with implementation of HPLC, mass spectrometry, and QSAR techniques.

Medroxyprogesterone acetate (MPA) injectable products are a key commodity for reproductive health and are available in the global market from a variety of manufacturing sources. Depending on the climatic zone conditions of the destination country for product use, MPA injectables are at risk of exposure to adverse transport and storage conditions. Analytical methods are available that quantify impurity levels in MPA and MPA injectable products, but minimal information is publicly available on the source of impurity and degradation product generation or the safety risk of these compounds. Forced degradation studies were conducted on MPA and MPA injectables to gain a better understanding of potential sources of impurities and degradation products. Furthermore, QSAR analysis was conducted to assess the toxicity risk of known impurities. More impurities were generated under acidic, basic, light, and oxidative forced degradation conditions relative to thermal degradation, however thermal exposure is the most likely adverse condition to be experienced by these products. Even if impurities are present in MPA injectables, QSAR analysis found that known impurities for MPA are apparently no more of a safety risk than MPA.

Parallel solid-phase synthesis and high-throughput 1H NMR evaluation of a 96-member 1,2,4-trisubstituted-pyrimidin-6-one-5-carboxylic acid library.

A solid-phase organic synthesis method has been developed for the preparation of trisubstituted pyrimidin-6-one carboxylic acids 12, which allows elaboration to a 3-dimensional combinatorial library. Three substituents are introduced by initial Knoevenagel condensation of an aldehyde and malonate ester resin 7 to give resin bound 1. Cyclization of 1 with an N-substituted amidine 10, oxidation, and cleavage afforded pyrimidinone 12. The initial solid-phase reaction sequence was followed by gel-phase (19)FNMR and direct-cleavage (1)H NMR of intermediate resins to determine the optimal conditions. The scope of the method for library production was determined by investigation of a 3 x 4 pilot library of twelve compounds. Cyclocondensation of N-methylamidines and 7 followed by CAN oxidation gave mixtures of the resin bound pyrimidin-6-one 11 and the regioisomeric pyrimidin-4-one 15, which after cleavage from the resin afforded a nearly 1:1 mixture of pyrimidin-6-one and pyrimidin-4-one carboxylic acids 12 and 16, respectively. The regiochemical assignment was confirmed by ROESY1D and gHMBC NMR experiments. A library was prepared using 8 aldehydes, 3 nitriles, and 4 amines to give a full combinatorial set of 96 pyrimidinones 12. Confirmation of structural identity and purity was carried out by LCMS using coupled ELS detection and by high-throughput flow (1)H NMR.