Clinical and Radiographic Outcomes of a Monoblock Fluted Titanium-Tapered Stem for Paprosky IIIa, IIIb, and IV Femoral Bone Defects.

BACKGROUND: Modern fluted titanium-tapered stems (FTTS) have been increasingly utilized to achieve primary stability in conversion and revision total hip arthroplasty with major femoral bone loss. This study sought to determine the radiographic and clinical outcomes of a monoblock FTTS in patients who had major femoral bone loss. METHODS: A multicenter retrospective observational study of all total hip arthroplasty patients who received a monoblock FTTS who had up to 5-year radiographic follow-up was conducted. Only patients with femoral Paprosky classifications of IIIa, IIIb, and IV were included. Eighty-one monoblock FTTS were examined. Median clinical follow-up was 29 months (range, 18 to 58). Stem subsidence and loosening were assessed on most recent radiographs. All-cause revisions and stem survivals were assessed. RESULTS: Median subsidence was 1.4 millimeters (mm) (range, 0 to 15.0). Sixteen (23.9%) and 3 (4.5%) stems had subsidence greater than 5 and 10 mm, respectively. All stems not acutely revised appeared stable, without evidence of loosening, at latest follow-up. Ten hips (12.3%) required reoperations. Of these, only 5 (6.2%) stems were removed; 4 due to periprosthetic joint infection and 1 for surgical exposure during acetabular revision. Kaplan-Meier analyses yielded an all-cause stem survivorship of 95.1% at 2-years and 87.1% at 4-years. Stem survivorships excluding septic causes was 98.8% at both 2 and 4 years. CONCLUSION: Monoblock FTTS in complex femoral reconstruction cases showed encouraging clinical and radiographic results in patients who had severe femoral bone loss at median 29 months follow-up.

Mid term outcomes of a novel metaphyseal porous titanium cone in revision total knee arthroplasty.

Introduction: Bone loss is present in all revision total knee arthroplasties. Metaphyseal cones allow surgeons to negotiate loss of femoral and tibial bone stock while obtaining stable bony fixation. This study examines the mid-term functional and radiographic outcomes in patients undergoing revision total knee arthroplasty (rTKA) utilizing a novel metaphyseal cone system. Methods: This multicenter retrospective study examined all patients who received a porous, titanium tibial or femoral cone at four academic urban tertiary care institutions and presented for a minimum two-year follow-up. Patient demographics, indications for revision surgery, knee range-of-motion (ROM), re-revision rates, radiographic measurements, bone defect per AORI classification, and implant osseointegration were evaluated according to the Knee Society total knee arthroplasty (TKA) radiographic evaluation system. Results: One-hundred and four patients received 128 cone implants (84 tibial, 44 femoral cones; 24 patients with simultaneous ipsilateral tibial and femoral cones; 104 rTKA) with mean follow-up of 32.75 ± 6.54 months. The pre-operative main revision indications were aseptic loosening 36 (34.61 %), periprosthetic infection (PJI) 23 (22.11 %) and instability 18 (17.3 %). Thirteen rTKA underwent re-revision surgery: 3 for acute PJI, 4 for chronic PJI, 5 for instability, and 1 for mechanical failure of a hinged system. At most recent radiographic follow-up available, all unrevised cones had evidence of osteointegration and no visible implant migration.All-cause re-operation free survivorship was 87.5 % (91/104), and all-cause cone implant survivorship was 96.09 % (123/128 cones) at 2-year follow-up. Conclusion: This study demonstrates excellent mid-term outcomes of a novel porous, titanium metaphyseal cone in patients with large bone defects undergoing complex revision TKA. Level of evidence: IV, case series.

Outcomes of novel 3D-printed fully porous titanium cup and a cemented highly cross-linked polyethylene liner in complex and revision total hip arthroplasty.

INTRODUCTION: A novel fully porous acetabular titanium shell has been designed to reduce stiffness mismatch between bone and implant and promote osseointegration in complex (cTHA) and revision total hip arthroplasty (rTHA). A highly cross-linked polyethylene (XLPE) liner is cemented within the cup to reduce wear rates and increase survivorship. This study reported the outcomes of an XLPE liner cemented into a novel 3D-printed fully porous cup in cTHA and rTHA. METHODS: Presented was a multicenter retrospective review of 40 patients (6 cTHA and 34 rTHA) who underwent THA with a fully porous titanium acetabular cup and cemented XLPE liner. Data were collected on demographics, surgical information, outcomes, including osseointegration and migration and implant survivorship. RESULTS: On average, patients were 71.42 ± 9.97 years old and obese (BMI: 30.36 ± 6.88 kg/m2) and were followed up for a mean time of 2.21 ± 0.77 years. Six patients underwent cTHA and 34 patients underwent rTHA. The mean hospital length of stay was 5.34 ± 3.34 days. Three (7.5%) 90-day readmissions were noted. Harris Hip Scores improved, on average, from 53.87 ± 12.58 preoperatively to 83.53 ± 12.15 postoperatively (P<0.001). One case of acetabular shell aspetic loosening with migration was noted. Thirty-nine of the 40 acetabular components were fully osseointegrated without migration. Two patients underwent re-revision surgery for PJI and one patient received acetabular shell+liner re-revision due to aseptic loosening. Kaplan-Meier analysis showed an all-cause revision-free survival rate of 95.0% at 6 months and 1 year, and 92.0% at 4-years. Aseptic acetabular cup, liner dislocation/loosening, and fracture-free survival was 100% at 6 months and 1-year, and 97.1% at 2 years. CONCLUSION: The combined use of a novel 3D-printed fully porous titanium acetabular shell and cemented XLPE acetabular liner yielded excellent rates of osseointegration, and all-cause and acetabular aseptic loosening survivorship at a minimum 1-year follow-up. Further long-term studies are needed to assess the longevity of this construct.

Minimum 2-Year Outcomes of a Novel 3D-printed Fully Porous Titanium Acetabular Shell in Revision Total Hip Arthroplasty.

Background: Fully porous acetabular shells are an appealing choice for patients with extensive acetabular defects undergoing revision total hip arthroplasty (rTHA). This study reports on the early outcomes of a novel 3-D printed fully porous titanium acetabular shell in revision acetabular reconstruction. Methods: A multicenter retrospective study of patients who received a fully porous titanium acetabular shell for rTHA with a minimum of 2 years of follow-up was conducted. The primary outcome was rate of acetabular revision. Results: The final study cohort comprised 68 patients with a mean age of 67.6 years (standard deviation 10.4) and body mass index of 29.5 kg/m2 (standard deviation 5.9). Ninety-four percent had a preoperative Paprosky defect grade of 2A or higher. The average follow-up duration was 3.0 years (range 2.0-5.1). Revision-free survivorship at 2 years was 81% for all causes, 88% for acetabular revisions, and 90% for acetabular revision for aseptic acetabular shell failure. Eight shells were explanted within 2 years (12%): 3 for failure of osseointegration/aseptic loosening (4%) after 15, 17, and 20 months; 3 for infection (4%) after 1, 3, and 6 months; and 2 for instability (3%). At the latest postoperative follow-up, all unrevised shells showed radiographic signs of osseointegration, and none had migrated. Conclusions: This novel 3-D printed fully porous titanium shell in rTHA demonstrated good survivorship and osseointegration when used in complex acetabular reconstruction at a minimum of 2 years. Level of evidence: IV, case series.

Short-term outcomes with the REDAPT monolithic, tapered, fluted, grit-blasted, forged titanium revision femoral stem.

AIMS: Although good clinical outcomes have been reported for monolithic tapered, fluted, titanium stems (TFTS), early results showed high rates of subsidence. Advances in stem design may mitigate these concerns. This study reports on the use of a current monolithic TFTS for a variety of indications. METHODS: A multi-institutional retrospective study of all consecutive total hip arthroplasty (THA) and revision total hip arthroplasty (rTHA) patients who received the monolithic TFTS was conducted. Surgery was performed by eight fellowship-trained arthroplasty surgeons at four institutions. A total of 157 hips in 153 patients at a mean follow-up of 11.6 months (SD7.8) were included. Mean patient age at the time of surgery was 67.4 years (SD 13.3) and mean body mass index (BMI) was 28.9 kg/m2 (SD 6.5). Outcomes included intraoperative complications, one-year all-cause re-revisions, and subsidence at postoperative time intervals (two weeks, six weeks, six months, nine months, and one year). RESULTS: There were eight intraoperative complications (4.9%), six of which were intraoperative fractures; none occurred during stem insertion. Six hips (3.7%) underwent re-revision within one year; only one procedure involved removal of the prosthesis due to infection. Mean total subsidence at latest follow-up was 1.64 mm (SD 2.47). Overall, 17 of 144 stems (11.8%) on which measurements could be performed had >5 mm of subsidence, and 3/144 (2.1%) had >10 mm of subsidence within one year. A univariate regression analysis found that additional subsidence after three months was minimal. A multivariate regression analysis found that subsidence was not significantly associated with periprosthetic fracture as an indication for surgery, the presence of an extended trochanteric osteotomy (ETO), Paprosky classification of femoral bone loss, stem length, or type of procedure performed (i.e. full revision vs conversion/primary). CONCLUSION: Advances in implant design, improved trials, a range of stem lengths and diameters, and high offset options mitigate concerns of early subsidence and dislocation with monolithic TFTS, making them a valuable option for femoral revision. Cite this article: Bone Joint J 2020;102-B(2):191-197.

Unicompartmental knee arthroplasty in patients sixty years of age or younger.

BACKGROUND: Unicompartmental knee arthroplasty has been used to treat elderly, low-demand patients, but the literature is sparse regarding the use of this procedure for younger, active patients. The purpose of the present retrospective study was to evaluate the results of unicompartmental knee arthroplasty in younger, more active patients. METHODS: Forty-one patients underwent forty-six consecutive unicompartmental knee arthroplasties with use of the Miller-Galante system between 1988 and 1996. All of the patients were sixty years of age or younger and all were physically active. The Hospital for Special Surgery knee score and the University of California at Los Angeles activity assessment were used to rate the function and to determine the activity level of each patient, respectively. Serial radiographs were used to evaluate the status of prosthetic fixation, femorotibial alignment, and the progression of arthrosis in the unreplaced compartment. Long-term survivorship was calculated with use of Kaplan-Meier analysis. RESULTS: The mean duration of follow-up was eleven years. Of the forty-five knees that were available for follow-up, three had been revised. The Hospital for Special Surgery score was excellent for thirty-nine (93%) of the remaining forty-two knees and good for three. The University of California at Los Angeles activity assessment score was 6.6 +/- 1.4 for the knees in which the original prosthesis had been retained and 7.3 +/- 1.5 for those in which it had been revised. Two asymptomatic patients had revision of a modular tibial component because of substantial radiographic evidence of polyethylene wear; one of these patients had exchange of the polyethylene insert and the tibial tray, and the other had exchange of the polyethylene insert only. A third patient underwent revision total knee arthroplasty because of continuing knee pain and a progressive tibial radiolucent line that was >2 mm in width. The average postoperative femorotibial alignment was 5 degrees of valgus. Nine knees had progression of arthritis in the unresurfaced compartment; none of these knees were revised, and none of the patients had deterioration in the Hospital for Special Surgery score. Kaplan-Meier analysis demonstrated an eleven-year survivorship of 92%. CONCLUSIONS: At an average duration of follow-up of eleven years, unicompartmental knee arthroplasty was associated with pain relief and excellent function in a cohort of patients who had been sixty years of age or younger and active at the time of surgery.

Improving accuracy of total knee component cementation: description of a simple technique.

BACKGROUND: Total knee arthroplasty represents a common orthopedic surgical procedure. Achieving proper alignment of its components with the predrilled patellar and tibial peg holes prior to polymerization of the bone cement can be challenging. TECHNIQUE: After establishing the femoral, patellar and tibial bone cuts, the cancellous bone around the tibial keel, as well as the peg holes for the patella and femoral components are marked with methylene blue using a cotton swab stick. If bone cement is then placed onto the cut and marked bone edges, the methylene blue leaches through the bone cement and clearly outlines the tibial keel and predrilled femoral and patellar peg holes. This allows excellent visualization of the bone preparations for each component, ensuring safe and prompt positioning of TKA components while minimizing intraoperative difficulties with component alignment while the cement hardens. CONCLUSION: The presented technical note helps to improve the accuracy and ease of insertion when the components of total knee arthroplasty are impacted to their final position.

Lateral unicompartmental knee arthroplasty: survivorship and technical considerations at an average follow-up of 12.4 years.

Successful medial unicompartmental knee arthroplasty is becoming standard; however, the "screw-home" mechanism, internal femoral rotation on a fixed tibia as the knee is fully extended, should be taken into account with lateral compartment arthroplasty. Twenty-nine consecutive lateral unicompartmental arthroplasties were performed with our unique tibial component positioning in 10 degrees to 15 degrees of internal rotation to compensate for the "screw-home" mechanism. The Hospital for Special Surgery knee score and serial radiographs were used in the evaluation of each patient. The mean duration of follow-up was 12.4 years with no revisions. The HSS score was excellent or good in all knees. The average postoperative femoral-tibial alignment was 5 degrees of valgus, and the average posterior tibial slope was 6 degrees . Lateral unicompartmental arthroplasty can provide excellent long-term results with modified positioning of the tibial component.