Recumbent vs. upright bicycles: 3D trajectory of body centre of mass, limb mechanical work, and operative range of propulsive muscles.

Recumbent bicycles (RB) are high performance, human-powered vehicles. In comparison to normal/upright bicycles (NB) the RB may allow individuals to reach higher speeds due to aerodynamic advantages. The purpose of this investigation was to compare the non-aerodynamic factors that may potentially influence the performance of the two bicycles. 3D body centre of mass (BCoM) trajectory, its symmetries, and the components of the total mechanical work necessary to sustain cycling were assessed through 3D kinematics and computer simulations. Data collected at 50, 70, 90 110 rpm during stationary cycling were used to drive musculoskeletal modelling simulation and estimate muscle-tendon length. Results demonstrated that BCoM trajectory, confined in a 15-mm side cube, changed its orientation, maintaining a similar pattern across all cadences in both bicycles. RB displayed a reduced additional mechanical external power (16.1 ± 9.7 W on RB vs. 20.3 ± 8.8 W on NB), a greater symmetry on the progression axis, and no differences in the internal mechanical power compared to NB. Simulated muscle activity revealed small significant differences for only selected muscles. On the RB, quadriceps and gluteus demonstrated greater shortening, while biceps femoris, iliacus, and psoas exhibited greater stretch; however, aerodynamics still remains the principal benefit.

Biomechanics of human locomotion in the wind.

In laboratory settings, human locomotion encounters minimal opposition from air resistance. However, moving in nature often requires overcoming airflow. Here, the drag force exerted on the body by different headwind or tailwind speeds (between 0 and 15 m·s-1) was measured during walking at 1.5 m·s-1 and running at 4 m·s-1. To our knowledge, the biomechanical effect of drag in human locomotion has only been evaluated by simulations. Data were collected on eight male subjects using an instrumented treadmill placed in a wind tunnel. From the ground reaction forces, the drag and external work done to overcome wind resistance and to sustain the motion of the center of mass of the body were measured. Drag increased with wind speed: a 15 m·s-1 headwind exerted a drag of ∼60 N in walking and ∼50 N in running. The same tailwind exerted -55 N of drag in both gaits. At this wind speed, the work done to overcome the airflow represented ∼80% of the external work in walking and ∼50% in running. Furthermore, in the presence of fast wind speeds, subjects altered their drag area (CdA) by adapting their posture to limit the increase in air friction. Moving in the wind modified the ratio between positive and negative external work performed. The modifications observed when moving with a head- or tailwind have been compared with moving uphill or downhill. The present findings may have implications for optimizing aerodynamic performance in competitive running, whether in sprints or marathons.NEW & NOTEWORTHY This is the first study to assess the biomechanical adaptations to a wide range of wind speeds inside a wind tunnel. Humans increase their mechanical work and alter their drag area (CdA) by adapting their posture when walking and running against increasing head and tailwinds. The observed drag force applied to the subject is different between walking and running at similar headwind speeds.

Mechanical energy patterns in nordic walking: comparisons with conventional walking.

The use of poles during Nordic Walking (NW) actively engages the upper body to propel the body forward during walking. Evidence suggests that NW leads to a longer stride and higher speed, and sometimes to increased ground reaction forces with respect to conventional walking (W). The aim of this study was to investigate if NW is associated with different changes in body centre of mass (COM) motion and limbs energy patterns, mechanical work and efficiency compared to W. Eight experienced Nordic Walkers performed 5-min W and NW trials on a treadmill at 4kmh-1. Steady state oxygen consumption and movements of body segments and poles were measured during each trial. We found greater fluctuation of kinetic (KE) and potential (PE) energy associated with COM displacement for NW compared to W. An earlier increase of KE for NW than for W, probably due to the propulsive action of poles, modified the synchronization between PE and KE oscillations so that a 10.9% higher pendular recovery between these energies was found in NW. The 10.2% higher total mechanical work found for NW was mainly due to the greater work required to move upper limbs and poles. NW was 20% less efficient and was metabolically more demanding than W, this difference could be ascribed to isometric contraction and low efficiency of upper musculature. Concluding, NW can be considered a highly dynamic gait, with distinctive mechanical features compared to conventional gait, due to pole propulsion and arm/pole swing.

Breaststroke swimmers moderate internal work increases toward the highest stroke frequencies.

A model to predict the mechanical internal work of breaststroke swimming was designed. It allowed us to explore the frequency-internal work relationship in aquatic locomotion. Its accuracy was checked against internal work values calculated from kinematic sequences of eight participants swimming at three different self-chosen paces. Model predictions closely matched experimental data (0.58 ± 0.07 vs 0.59 ± 0.05 J kg(-1)m(-1); t(23)=-0.30, P=0.77), which was reflected in a slope of the major axis regression between measured and predicted total internal work whose 95% confidence intervals included the value of 1 (ß=0.84, [0.61, 1.07], N=24). The model shed light on swimmers ability to moderate the increase in internal work at high stroke frequencies. This strategy of energy minimization has never been observed before in humans, but is present in quadrupedal and octopedal animal locomotion. This was achieved through a reduced angular excursion of the heaviest segments (7.2 ± 2.9° and 3.6 ± 1.5° for the thighs and trunk, respectively, P<0.05) in favor of the lightest ones (8.8 ± 2.3° and 7.4 ± 1.0° for the shanks and forearms, respectively, P<0.05). A deeper understanding of the energy flow between the body segments and the environment is required to ascertain the possible dependency between internal and external work. This will prove essential to better understand swimming mechanical cost determinants and power generation in aquatic movements.

Overuse in volleyball training/practice: A review on shoulder and spine-related injuries.

Overuse injuries are predominant in sports involving the repetition of similar movements patterns, such as in volleyball or beach volleyball, and they may represent as much a problem as do acute injuries. This review discusses the prevalence of two of the most common overuse-related injuries in volleyball: shoulder and back/spine injuries. Risk factors and the aetiology of these injuries are illustrated in order to make possible to initiate preventive programme or post-injuries solutions. Data collected from literature showed a moderately higher injury rate for overuse shoulder injuries compared to the back/spine (19.0 ± 11.2% and 16.8 ± 9.7%, respectively). These data could be underestimated, and future epidemiological studies should consider overuse injuries separately from the others, with new methodological approaches. In addition to age, biomechanical and anatomical features of a volleyball technique utilised in game and the amount of hours played are considered as the main risk factors for overuse upper limb injuries, both for professional and recreational athletes. Together with post-injuries solutions, great importance has to be placed on preventive programmes, such as preventive rehabilitation, stretching, adequate warm up, strength-power exercises, etc. Furthermore, it is particularly suggested that coaches and players work together in order to develop new game/training techniques that minimise stresses and range of motion of the principal anatomical structures involved, while maintaining athletes performance.