High concentrated etoposide solutions, additional physical stability data in dextrose 5.

OBJECTIVES: According to the manufacturers, the concentration of etoposide solutions should not exceed 0.4 mg/mL due to a risk of precipitation. Stability studies at higher concentrations were conducted and notably demonstrated 28 day stability up to 1.75 mg/mL for etoposide solutions in 5% dextrose (D5W). Nevertheless, colleagues report precipitation even at 0.4 mg/mL in their daily practice. The objective of this work was to reassess the physical stability of highly concentrated etoposide solutions in D5W (1.2 mg/mL), over a large number of preparations and under different manufacturing processes. METHODS: To study the impact of manufacturing process, etoposide was taken with a spike or a needle and injected in three types of D5W containers (Easyflex, Viaflo and Ecoflac). Forty preparations were made for each container. For half of the preparations, a homogenisation was performed by a syringe rinse. Physical stability was realised by two examiners, with a visual examination searching for the appearance of a precipitate, daily during the first week, then twice a week until day 56. RESULTS: Hundred and eighteen solutions were clear and colourless. Precipitates were observed for two solutions: one in an Easyflex bag on day 4 and one in an Ecoflac container on day 35. CONCLUSIONS: The physical stability at 1.2 mg/mL in D5W remains validated. Precipitations are rare and concern less than 2% of preparations. The appearance of a precipitate does not seem to be correlated to the kind of container or manufacturing process. A rinse was performed for these two solutions to assess a mechanical pressure effect more important on the solution, which could lead to a higher risk of precipitations. However, this is not observed in our daily practice, especially at lower concentrated solutions. We only recommend using an administration set with an in-line micro-filter as a precaution in case of precipitations.

Stability Studies of 16 Antibiotics for Continuous Infusion in Intensive Care Units and for Performing Outpatient Parenteral Antimicrobial Therapy.

The use of continuous infusion to improve the therapeutic efficacy of time-dependent antibiotics has been demonstrated. There is still a lack of data to safely perform these continuous infusions. The objectives in this study were to evaluate the stability by using stability-indicating methods (High-Performance Liquid Chromatography) of 16 antibiotics in concentrated solutions, especially for administration in intensive care units and solutions in elastomeric diffusers at 37 °C for outpatient parenteral antimicrobial therapy. The solutions were considered stable if the percentage of the drug was ≥90%, and the colour and clearness remained unchanged. In syringes, the stability data vary from 4 to 8 h (h) for meropenem in Dextrose 5% (D5W) and Normal Saline (NS), respectively, 6 h for cefotaxime, 12 h for cefoxitin, and 24 h for aztreonam, cefazolin, cefepime, cefiderocol, ceftazidime/avibactam, ceftolozane/tazobactam in NS and D5W, and in water for injection for cloxacillin. A stability period of 48 h has been validated for vancomycin (D5W), aztreonam, and piperacillin/tazobactam. Cefoxitin, cefazolin, cefepime, cefotaxime, cloxacillin, and piperacillin are unstable for diffuser administration. In diffusers, stability times vary from 6 h for cefiderocol, 8 h for ceftazidime, 12 h for ceftazidime/avibactam and ceftolozane/tazobactam (NS), 24 h for temocillin (NS) and piperacillin/tazobactam (D5W), up to 48 h for aztreonam and vancomycin. Solutions stored at 37 °C are less stable and allow the administration of seven antibiotics using diffusers.